Handy Home Products Gruntavore Lift 16867 Users Manual 15277 OWNERS

: Handy-Home-Products Handy-Home-Products-Gruntavore-Lift-16867-Users-Manual-563460 handy-home-products-gruntavore-lift-16867-users-manual-563460 handy-home-products pdf

Open the PDF directly: View PDF .
Page Count: 4

Download
Open PDF In Browser	View PDF

GRUNTAVORE LIFT
Item # 16867

INSTRUCTIONS - PARTS DRAWING - PARTS LIST
WARNING: READ INSTRUCTIONS BEFORE OPERATING

1. Center load on table - 1800 lb. maximum.
2. Connect to 100 psi maximum shop air.
3. Keep safety bar in position at all times - except
when lowering.
4. Keep hands and tools from under carriage.
5. Do not mount table when in elevated position.
6. Do not ride vehicle onto lift.
7. Lift must be in the lowered position when moving.
8. Only trained persons should operate Air Lift.
9. The working area should be sufficiently lit.
10. Foot controller should be at least 3 feet away from
Air Lift during raising and lowering operation.
HANDY INDUSTRIES L.L.C.
702 South 3rd Ave. Marshalltown, IA 50158

1-800-247-7594

Fax 641-752-1205 www.handyindustries.com

GRUNTAVORE LIFT
NOTE: READ ENTIRE MANUAL TO COMPLY WITH ALL SAFETY AND SERVICE PRECAUTIONS. DEATH, PERSONAL INJURY AND/OR PROPERTY DAMAGE MAY OCCUR
UNLESS INSTRUCTIONS ARE FOLLOWED CAREFULLY.

INSTRUCTIONS
UNPACKING AND SET-UP
1. Open carton, then remove ramp and shipping boards.
2. Connect foot-operated air valve to 100 psi maximum air supply. The lift may be damaged and/or
personal injury may result if the pressure exceeds the maximum 100 psi rating.
3. Stand clear of lift table, and depress the UP side of foot valve to raise table.
4. To lower table, lift detent bar from safety latch and lower to next position or to floor.
5. To mount ramp, insert ramp mounting pins into holes at end of table opposite vise holes.

UNPACKING AND SET-UP OF EXTENSION COMPONENTS
1. Open cartons containing side and end extension components. Refer to the illustration and parts list
page.
2. Connect Air Lift to 100 psi air then raise lift and engage safety detent bar.
3. Insert the 53-1/4” stabilizer shafts thru each frame end. Place axle extensions with the wheels secured by two
spiral retaining rings onto shaft then retain with quick pins. Place stabilizer feet onto shaft at outside frame and
retain with quick pins.
4. Insert the two 3/4” pipes thru holes near center of lift top. Place side extensions onto these pipes and retain
with quick pins at each end of the pipe.
5. Pull side extensions out against quick pins and center side extensions on the Air Lift.
6. Place end extension onto lift top and side extensions aligning pipe holes , then insert 1” pipe. Install quick pins
at pipe ends. Secure end extensions to both lift top and side extensions to both lift top and side extension
using ten 5/16-18 cap screws and nuts for each end extension. Note eight bolts go down and one is located at
each side near bend.
7. Attach detent handle extensions on each side of detent safety bar. See detail on illustration and parts list
page.
8. To mount ramps, insert mounting pins in to matching slots on the end extension farthest from the wheels of the
Air Lift.

OPERATION
1. Loads must be centered on table at all times. Table is rated for a maximum load of 1800 lbs.
2. Loads must be firmly positioned and secured on table at all times.
3. All moving parts have been lubricated at the factory and should be re-lubricated every (6) months to prevent
galling. Grease zerks are located at each end of frame pivot shaft and at top ends of inside frame assembly.
4. Lightly oil cylinder rod when it becomes dry.
5. Squirt some oil through bleed hole in plate end of cylinder to lubricate piston and its seal every (6) months.
6. Pivot shaft set screws should be checked frequently to be sure they are tight. These are
located at the top end of the inside frame assembly.

GRUNTAVORE LIFT
MOUNTING ILLUSTRATION AND PARTS LIFT

PART
NO..
11253
11271
11358
12128
12305
14737
15255
15258
15261
15263
15265
15267
15269
15275
15452
15618
16865

DESCRIPTION
SPIRAL RETAINING RING
10-32 HEX NUT
QUIK PIN
5/16-18 X ¾ HEX HD CAP SCREW
5/16-18 HEX NUT
CAST WHEEL
DETENT HANDLE EXTENSION RETAINER
DETNET HANDLE EXTENSION TUBE
SWIVEL STABILIZER FOOT
AXLE EXTENSION
STABILZER SHAFT 53 ¼”
¾” PIPE EXTENSION 61 ½” LONG
1” PIPE EXTENSION 61 ½” LONG
END EXTENSION ASSEMBLY
RAMP ASSEMBLY (ONE COMES WITH 16865)
SIDE EXTENSION
LIFT GRUNTAVOR

QTY
4
2
12
20
20
2
2
2
2
2
2
2
2
2
1
2
1

GRUNTAVORE
PARTS DRAWING - PARTS LIST

Part #
10819
14381
11250
11253
11255
14737
12887
12937
11304
11305
16764
15397
16765
15400
15401

Description
detent clip
air hose assembly
screw 3/4 -10 x 1-3/4
retaining ring 1-5/16
lockwasher - 3/4”
wheel
valve stem assembly
foot valve assembly complete
cylinder shaft bushing
cylinder shaft seal
cylinder assembly
cam roller bearing
cylinder shaft assembly
retaining ring 2-3/8”
piston

Part #
15403
15253
16761
16760
16766
15452
15687
15458
15460
15461
15462
15463
15484
15528
15529

Description
piston seal
top assembly
inside frame assembly
outside frame assembly
foot assembly
ramp
drop out cover
detent bar
frame pivot shaft
cylinder pivot shaft
retaining ring 1-1/4”
track roller bearing
cover plate
rubber pad
spacer

LIFT LIMITED WARRANTY
Handy Industries, LLC, warrants to the original purchaser of this Air Lift, all parts to be free from defects in manufacture for a period of ninety
days from date of delivery. Notice of defective part must be received in writing at Handy Industries, LLC., and which upon our examination
shall prove defective in manufacture or workmanship, will be replace or put in good operating condition. This warranty does not apply to damage resulting from accident or to any lift which has been improperly installed or repaired, neglected or operated contrary to instruction. The
cost of such replacement or repair shall be exclusive remedy for any breach of any warranty and Handy Industries, LLC. shall not be liable to
any person for consequential damage, or injury, or commercial loss resulting from any breach of warranty of merchantability, makes no warranty of fitness for a particular purpose and makes no other warranty expressed or implied, including implied warranty arising from the course
or dealing or usage of the trade.
12/07 15277



---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : No
Create Date                     : 2007:12:05 08:58:10-06:00
Modify Date                     : 2007:12:05 08:58:10-06:00
Page Count                      : 4
Creation Date                   : 2007:12:05 14:58:10Z
Mod Date                        : 2007:12:05 14:58:10Z
Producer                        : Acrobat Distiller 5.0.5 (Windows)
Author                          : ethomasson
Metadata Date                   : 2007:12:05 14:58:10Z
Creator                         : ethomasson
Title                           : 15277 GRUNTAVORE OWNERS MANUAL.qxd

EXIF Metadata provided by EXIF.tools