Handy Home Products Gruntavore Lift 16867 Users Manual 15277 OWNERS

: Handy-Home-Products Handy-Home-Products-Gruntavore-Lift-16867-Users-Manual-563460 handy-home-products-gruntavore-lift-16867-users-manual-563460 handy-home-products pdf

Open the PDF directly: View PDF .
Page Count: 4

GRU NTAVO RE LIFT

INSTRUCTIONS

-

PARTS

DRAWING

-

PARTS

LIST

1. Center load on table - 1800 lb. maximum.

2. Connect to 100 psi maximum shop air.

3. Keep safety bar in position at all times - except

when lowering.

4. Keep hands and tools from under carriage.

5. Do not mount table when in elevated position.

6. Do not ride vehicle onto lift.

7. Lift must be in the lowered position when moving.

8. Only trained persons should operate Air Lift.

9. The working area should be sufficiently lit.

10. Foot controller should be at least 3 feet away from

Air Lift during raising and lowering operation.

HANDY INDUSTRIES L.L.C.

702 South 3rd Ave. Marshalltown, IA 50158 1-800-247-7594 Fax 641-752-1205 www.handyindustries.com

Item # 16867

WARNING: READ INSTRUCTIONS BEFORE OPERATING

NOTE: READ ENTIRE MANUAL TO COMPLY WITH ALL SAFETY AND SERVICE PRE-

CAUTIONS. DEATH, PERSONAL INJURY AND/OR PROPERTY DAMAGE MAY OCCUR

UNLESS INSTRUCTIONS ARE FOLLOWED CAREFULLY.

INSTRUCTIONS

UNPACKING AND SET-UP

1. Open carton, then remove ramp and shipping boards.

2. Connect foot-operated air valve to 100 psi maximum air supply. The lift may be damaged and/or

personal injury may result if the pressure exceeds the maximum 100 psi rating.

3. Stand clear of lift table, and depress the UP side of foot valve to raise table.

4. To lower table, lift detent bar from safety latch and lower to next position or to floor.

5. To mount ramp, insert ramp mounting pins into holes at end of table opposite vise holes.

UNPACKING AND SET-UP OF EXTENSION COMPONENTS

1. Open cartons containing side and end extension components. Refer to the illustration and parts list

page.

2. Connect Air Lift to 100 psi air then raise lift and engage safety detent bar.

3. Insert the 53-1/4” stabilizer shafts thru each frame end. Place axle extensions with the wheels secured by two

spiral retaining rings onto shaft then retain with quick pins. Place stabilizer feet onto shaft at outside frame and

retain with quick pins.

4. Insert the two 3/4” pipes thru holes near center of lift top. Place side extensions onto these pipes and retain

with quick pins at each end of the pipe.

5. Pull side extensions out against quick pins and center side extensions on the Air Lift.

6. Place end extension onto lift top and side extensions aligning pipe holes , then insert 1” pipe. Install quick pins

at pipe ends. Secure end extensions to both lift top and side extensions to both lift top and side extension

using ten 5/16-18 cap screws and nuts for each end extension. Note eight bolts go down and one is located at

each side near bend.

7. Attach detent handle extensions on each side of detent safety bar. See detail on illustration and parts list

page.

8. To mount ramps, insert mounting pins in to matching slots on the end extension farthest from the wheels of the

Air Lift.

OPERATION

1. Loads must be centered on table at all times. Table is rated for a maximum load of 1800 lbs.

2. Loads must be firmly positioned and secured on table at all times.

3. All moving parts have been lubricated at the factory and should be re-lubricated every (6) months to prevent

galling. Grease zerks are located at each end of frame pivot shaft and at top ends of inside frame assembly.

4. Lightly oil cylinder rod when it becomes dry.

5. Squirt some oil through bleed hole in plate end of cylinder to lubricate piston and its seal every (6) months.

6. Pivot shaft set screws should be checked frequently to be sure they are tight. These are

located at the top end of the inside frame assembly.

GRUNTAVORE LIFT

PART

NO..

DESCRIPTION

QTY

11253

SPIRAL RETAINING RING

4

11271

10-32 HEX NUT

2

11358

QUIK PIN

12

12128

5/16-18 X ¾ HEX HD CAP SCREW

20

12305

5/16-18 HEX NUT

20

14737

CAST WHEEL

2

15255

DETENT HANDLE EXTENSION RETAINER

2

15258

DETNET HANDLE EXTENSION TUBE

2

15261

SWIVEL STABILIZER FOOT

2

15263

AXLE EXTENSION

2

15265

STABILZER SHAFT 53 ¼”

2

15267

¾” PIPE EXTENSION 61 ½” LONG

2

15269

1” PIPE EXTENSION 61 ½” LONG

2

15275

END EXTENSION ASSEMBLY

2

15452

RAMP ASSEMBLY (ONE COMES WITH 16865)

1

15618

SIDE EXTENSION

2

16865

LIFT GRUNTAVOR

1

GRUNTAVORE LIFT

MOUNTING ILLUSTRATION AND PARTS LIFT

GRUNTAVORE

Part # Description

10819 detent clip

14381 air hose assembly

11250 screw 3/4 -10 x 1-3/4

11253 retaining ring 1-5/16

11255 lockwasher - 3/4”

14737 wheel

12887 valve stem assembly

12937 foot valve assembly complete

11304 cylinder shaft bushing

11305 cylinder shaft seal

16764 cylinder assembly

15397 cam roller bearing

16765 cylinder shaft assembly

15400 retaining ring 2-3/8”

15401 piston

Part # Description

15403 piston seal

15253 top assembly

16761 inside frame assembly

16760 outside frame assembly

16766 foot assembly

15452 ramp

15687 drop out cover

15458 detent bar

15460 frame pivot shaft

15461 cylinder pivot shaft

15462 retaining ring 1-1/4”

15463 track roller bearing

15484 cover plate

15528 rubber pad

15529 spacer

LIFT LIMITED WARRANTY

Handy Industries, LLC, warrants to the original purchaser of this Air Lift, all parts to be free from defects in manufacture for a period of ninety

days from date of delivery. Notice of defective part must be received in writing at Handy Industries, LLC., and which upon our examination

shall prove defective in manufacture or workmanship, will be replace or put in good operating condition. This warranty does not apply to dam-

age resulting from accident or to any lift which has been improperly installed or repaired, neglected or operated contrary to instruction. The

cost of such replacement or repair shall be exclusive remedy for any breach of any warranty and Handy Industries, LLC. shall not be liable to

any person for consequential damage, or injury, or commercial loss resulting from any breach of warranty of merchantability, makes no war-

ranty of fitness for a particular purpose and makes no other warranty expressed or implied, including implied warranty arising from the course

or dealing or usage of the trade.

PARTS DRAWING - PARTS LIST

12/07 15277