Hansong HSWSR Powered Speaker (WS80i) User Manual page1 5 ws80i 20120302
Hansong(Nanjing) Technology Ltd. Powered Speaker (WS80i) page1 5 ws80i 20120302
Hansong >
User Manual
Page | 15 Page | 16
REMINDING used on Product &
User Manual
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
Changes or modifications not expressly approved by
the party responsible for compliance could void the
user's authority to operate the equipment.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates uses and can radiate
radio frequency energy and, if not installed and
used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to radio
or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and
receiver.
—Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV
technician for help.
The transmitter of this device has been designed
to operate with the attached antennas, and having
a maximum gain of 1.5dBi. Antennas not identical
as that or having a gain greater than 1.5dBi are
strictly prohibited for use with this device. The
required antenna impedance is 50 ohms. To reduce
potential radio interference to other users, the
antenna type and its gain should be so chosen that
the equivalent isotropically radiated power (e.i.r.p.)
is not more than that permitted for successful
communication
Page | 18Page | 17
MPE Reminding
To satisfy FCC RF exposure requirements, a
separation distance of 20 cm or more should be
maintained between the antenna of this device and
persons during device operation.
To ensure compliance, operations at closer than
this distance is not recommended.
Les antennes installées doivent être situées de
facon à ce que la population ne puisse y être
exposée à
une distance de moin de 20 cm. Installer les
antennes de facon à ce que le personnel ne puisse
approcher à 20 cm ou moins de la position centrale
de l’ antenne.
La FCC des États-Unis stipule que cet appareil doit
être en tout temps éloigné d’au moins 20 cm des
personnes pendant son functionnement.
Under Industry Canada regulations, this radio
transmitter may only operate using an antenna of a
type and maximum (or lesser) gain approved for the
transmitter by Industry Canada. To reduce potential
radio interference to other users, the antenna type
and its gain should be so chosen that the equivalent
isotropically radiated power (e.i.r.p.) is not more
than that necessary for successful communication.
Conformément à la réglementation d'Industrie
Canada, le présent émetteur radio peut
fonctionner avec une antenne d'un type et d'un gain
maximal (ou inférieur) approuvé pour l'émetteur
par Industrie Canada. Dans le but de réduire les
risques de brouillage radioélectrique à l'intention
des autres utilisateurs, il faut choisir le type
d'antenne et son gain de sorte que la puissance
isotrope rayonnée équivalente (p.i.r.e.) ne dépasse
pas l'intensité nécessaire à l'établissement d'une
communication satisfaisante.
