Hansong HSWSR Powered Speaker (WS80i) User Manual page1 5 ws80i 20120302

Download:
Mirror Download [FCC.gov]
Document ID	1659753
Application ID	Jx3bZ6Ex+z5rSjsmaCiA7Q==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	141.45kB (1768099 bits)
Date Submitted	2012-03-20 00:00:00
Date Available	2012-03-21 00:00:00
Creation Date	2012-03-02 16:46:20
Producing Software	Acrobat Distiller 9.0.0 (Windows)
Document Lastmod	2012-03-02 16:46:20
Document Title	page1~5 ws80i 20120302.pdf
Document Creator	Adobe InDesign CS3 (5.0.4)
Document Author:	wakeyouw

by turning the equipment off and on, the user is
encouraged to try to correct the interference by
Rules. Operation is subject to the following two
conditions: (1) this device may not cause
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and
interference received, including interference that
may cause undesired operation.
circuit different from that to which the receiver is
connected.
the party responsible for compliance could void the
user's authority to operate the equipment.
The transmitter of this device has been designed
to operate with the attached antennas, and having
a maximum gain of 1.5dBi. Antennas not identical
as that or having a gain greater than 1.5dBi are
strictly prohibited for use with this device. The
required antenna impedance is 50 ohms. To reduce
potential radio interference to other users, the
antenna type and its gain should be so chosen that
the equivalent isotropically radiated power (e.i.r.p.)
is not more than that permitted for successful
communication
with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates uses and can radiate
radio frequency energy and, if not installed and
used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to radio
Page | 15
technician for help.
This equipment has been tested and found to comply
—Consult the dealer or an experienced radio/TV
—Connect the equipment into an outlet on a
Changes or modifications not expressly approved by
receiver.
one or more of the following measures:
interference, and (2) this device must accept any
harmful
or television reception, which can be determined
This device complies with Part 15 of the FCC
REMINDING used on Product &
User Manual
Page | 16
isotropically radiated power (e.i.r.p.) is not more
than that necessary for successful communication.
separation distance of 20 cm or more should be
maintained between the antenna of this device and
fonctionner avec une antenne d'un type et d'un gain
maximal (ou inférieur) approuvé pour l'émet teur
par Industrie Canada. Dans le but de réduire les
risques de brouillage radioélectrique à l'intention
des autres utilisateurs, il faut choisir le type
d'antenne et son gain de sorte que la puissance
isotrope rayonnée équivalente (p.i.r.e.) ne dépasse
Les antennes installées doivent être situées de
facon à ce que l a popul ation ne puisse y être
exposée à
une distance de moin de 20 cm. Installer les
antennes de facon à ce que le personnel ne puisse
approcher à 20 cm ou moins de la position centrale
de l’ antenne.
Page | 17
radio interference to other users, the antenna type
transmitter by Industry Canada. To reduce potential
type and maximum (or lesser) gain approved for the
transmitter may only operate using an antenna of a
Under Industry Canada regul ations, this radio
personnes pendant son functionnement.
être en tout temps éloigné d’au moins 20 cm des
La FCC des États-Unis stipule que cet appareil doit
Canada, le présent émetteur radio peut
this distance is not recommended.
communication satisfaisante.
pas l'intensité nécessaire à l'établissement d'une
Conformément à l a réglementation d'Industrie
To ensure compliance, operations at closer than
persons during device operation.
and its gain should be so chosen that the equivalent
T o s at i s f y F C C R F e x p o s u r e r e q u i r e m e n t s , a
MPE Reminding
Page | 18


---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.5
Linearized                      : Yes
Author                          : wakeyouw
Create Date                     : 2012:03:02 16:46:20+08:00
Modify Date                     : 2012:03:02 16:46:20+08:00
XMP Toolkit                     : Adobe XMP Core 4.2.1-c041 52.342996, 2008/05/07-20:48:00
Metadata Date                   : 2012:03:02 16:42:53+08:00
Creator Tool                    : Adobe InDesign CS3 (5.0.4)
Format                          : application/pdf
Title                           : page1~5 ws80i 20120302.pdf
Creator                         : wakeyouw
Document ID                     : uuid:f69ed379-6562-4416-b57f-bb2246807baa
Instance ID                     : uuid:bdd627aa-8b5f-4387-9d2f-5435ad133c77
Producer                        : Acrobat Distiller 9.0.0 (Windows)
Page Count                      : 11

EXIF Metadata provided by EXIF.tools