Hetronic MFSUSBMDM USB RF Dongle User Manual

Hetronic International Inc USB RF Dongle

User Manual

User’s Manual MFS USB DONGLE        
1. DESCRIPTION The MFS USB Dongle is a small, USB to RF modem designed to communicate with MFS systems operating in the 915MHz and 2400MHz frequency bands. The standard firmware load enables H-Link connectivity with the PC platform, but it is possible that this firmware be changed for other purposed (Tx / Rx Simulator, etc.). 2. FCC AND IC INFORMATION FCC ID Number: LW9-MFSUSBMDM IC ID Number: 2119B-MFSUSBMDM Note: Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Note: The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Note: The MFS USB Dongle is shipped with the FCC/IC ID label attached. The FCC/IC ID label must not be removed. Remarque : L'opération est soumis à deux conditions suivantes: (1) ce dispositif ne peut pas causer de brouillage, et (2) ce dispositif doit accepter toute interférence, y compris le brouillage qui peut causer intempestif de fonctionnement du dispositif. Remarque : L'utilisateur est averti que les changements ou modifications non expressément approuvées par la partie responsable de la conformité pouvaient annuler l'autorisation l'utilisateur à faire fonctionner l'équipement. Note : Le Dongle USB de MFS est livré avec le label ID FCC/IC attaché. L'étiquette de la FCC/IC ID ne doit pas être supprimé. 
3. TECHNICAL SPECIFICATIONS Temperature Range -20° to +70° Celsius Supply Voltage Range 5V USB Supply Current <30mA Outputs RF: 915MHz and 2400MHz H-Link Data, USB PC Interface Inputs RF: 915MHz and 2400MHz H-Link Data, Transmitter Control Data, USB PC Interface Table 1, Technical Specifications 4. ASSEMBLY DESCRIPTION 4.1. Test / Programming Jumper Configuration N/A – no firmware/software required for operation. 4.2. Operational Jumper Configuration N/A – no Jumper configurations required for operation. 4.3. Wiring N/A – no wiring required for operation. 4.4. Glue and Lacquer Masks N/A – no Glue or Lacquer masks are required for operation. 5. Connection Diagram The device connects to a standard PC/Laptop USB port. Currently, only Windows XP and Windows 7 operating systems are supported.   

Navigation menu