High Flying Electronics Technology HF-LPT200 Embedded WiFi Module User Manual Addendum

Addendum

FCC INFORMATION (additional)

OEM INTEGRATION INSTRUCTIONS:

This device is intended only for OEM integrators under the following conditions:

The module must be installed in the host equipment such that 20 cm is maintained between the antenna

and users, and the transmitter module may not be co-located with any other transmitter or antenna. The

module shall be only used with the internal on-board antenna that has been originally tested and certified

with this module. External antennas are not supported.

As long as these 3 conditions above are met, further transmitter test will not be required. However, the

OEM integrator is still responsible for testing their end-product for any additional compliance requirements

required with this module installed (for example, digital device emissions, PC peripheral requirements,

etc.). The end-product may need Verification testing, Declaration of Conformity testing, a Permissive Class

II Change or new Certification. Please involve a FCC certification specialist in order to determine what will

be exactly applicable for the end-product.

Validity of using the module certification:

In the event that these conditions cannot be met (for example certain laptop configurations or co-location

with another transmitter), then the FCC authorization for this module in combination with the host

equipment is no longer considered valid and the FCC ID of the module cannot be used on the final

product. In these circumstances, the OEM integrator will be responsible for re-evaluating the end product

(including the transmitter) and obtaining a separate FCC authorization. In such cases, please involve a

FCC certification specialist in order to determine if a Permissive Class II Change or new Certification is

required.

Upgrade Firmware:

The software provided for firmware upgrade will not be capable to affect any RF parameters as certified

for the FCC for this module, in order to prevent compliance issues.

End product labeling:

This transmitter module is authorized only for use in device where the antenna may be installed such that

20 cm may be maintained between the antenna and users. The final end product must be labeled in a

visible area with the following:

“Contains FCC ID: AZY-HF-LPT200”.

Information that must be placed in the end user manual:

The OEM integrator has to be aware not to provide information to the end user regarding how to install or

remove this RF module in the user's manual of the end product which integrates this module. The end

user manual shall include all required regulatory information/warning as show in this manual.