Hitachi Welding System Sj300 037Hfe Users Manual Series Inverter Instruction
SJ300-037HFE to the manual c88dbdc4-787c-4d2d-b3f1-7341546bb418
2015-01-24
: Hitachi Hitachi-Welding-System-Sj300-037Hfe-Users-Manual-314307 hitachi-welding-system-sj300-037hfe-users-manual-314307 hitachi pdf
Open the PDF directly: View PDF
Page Count: 289 [warning: Documents this large are best viewed by clicking the View PDF Link!]
- Cover
- Safety Messages
- Table of Contents
- Getting Started
- Inverter Mounting and Installation
- Configuring Drive Parameters
- Choosing a Programming Device
- Using Keypad Devices
- “D” Group: Monitoring Functions
- “F” Group: Main Profile Parameters
- “A” Group: Standard Functions
- Basic Parameter Settings
- Analog Input Settings
- Multi-speed and Jog Frequency Settings
- Torque Control Algorithms
- DC Braking Settings
- Frequency- related Functions
- Acceleration Pause Function
- PID Control
- Automatic Voltage Regulation (AVR) Function
- Energy Savings Mode / Optimal Accel/Decel
- Second Acceleration and Deceleration Functions
- Accel/Decel Characteristics
- Additional Analog Input Settings
- “B” Group: Fine-Tuning Functions
- “C” Group: Intelligent Terminal Functions
- “H” Group: Motor Constants Functions
- “P” Group: Expansion Card Functions
- “U” Group: User-selectable Menu Functions
- Programming Error Codes
- Operations and Monitoring
- Introduction
- Optional Controlled Decel and Alarm at Power Loss
- Connecting to PLCs and Other Devices
- Using Intelligent Input Terminals
- Input Wiring Examples
- Wiring Diagram Conventions
- Forward Run/ Stop and Reverse Run/Stop Commands
- Multi-Speed Select
- Jogging Command
- External Signal for DC Injection Braking
- Set Second or Third Motors
- Two-stage Acceleration and Deceleration
- Free-run Stop
- External Trip
- Unattended Start Protection
- Commercial Power Source Switching
- Software Lock
- Analog Input Current/Voltage Select
- Reset Inverter
- Thermistor Thermal Protection
- Three-wire Interface Operation
- PID ON/OFF and PID Clear
- Internal Speed Loop Gain Settings
- Remote Control Up and Down Functions
- Force Operation from Digital Operator
- Overload Restriction
- Torque Limit
- External Brake Control Function
- Expansion Card Input Signals
- Using Intelligent Output Terminals
- Run Signal
- Frequency Arrival Signals
- Overload Advance Notice Signal
- Output Deviation for PID Control
- Alarm Signal
- Over-torque Signal
- Instantaneous Power Failure / Under-voltage Signal
- Torque Limit Signal
- Run Time / Power-On Time Over Signals
- Thermal Warning Signal
- Brake Control Signals
- Expansion Card Output Signals
- Analog Input Operation
- Analog Output Operation
- Setting Motor Constants for Vector Control
- PID Loop Operation
- Configuring the Inverter for Multiple Motors
- Inverter System Accessories
- Troubleshooting and Maintenance
- Glossary and Bibliography
- Serial Communications
- Drive Parameter Settings Tables
- CE-EMC Installation Guidelines
- Index