Hitron TECHNOLOGIES CGNM2252 Wireless Cable Gateway User Manual
Hitron TECHNOLOGIES Wireless Cable Gateway
User Manual
| Download: |  |
| Mirror Download [FCC.gov] | |
| Document ID | 3053127 |
| Application ID | wMrH9KJK1PB8H/ndtZCGMQ== |
| Document Description | User Manual |
| Short Term Confidential | No |
| Permanent Confidential | No |
| Supercede | No |
| Document Type | User Manual |
| Display Format | Adobe Acrobat PDF - pdf |
| Filesize | 157.66kB (1970750 bits) |
| Date Submitted | 2016-07-06 00:00:00 |
| Date Available | 2016-07-07 00:00:00 |
| Creation Date | 2017-12-09 16:27:42 |
| Producing Software | GPL Ghostscript 9.18 |
| Document Lastmod | 2017-12-09 16:27:42 |
| Document Title | User Manual |
| Document Creator | Adobe Illustrator CS6 (Windows) |
QUICK START GUIDE Check the box contents STEP HITRON CGNM-3552-ROG Read me first! 1 CGNM-3552-ROG 1 POWER ADAPTOR Connect to the network Set up your wireless network QUICK START GUIDE Connect to the cable outlet Connect to the power outlet Use the coaxial (not included) to connect the device’s CABLE connector to the cable outlet. STEP Connect to an Ethernet-equipped device (optional) Use the Ethernet cable provided to connect one of the LAN ports to an Ethernet-equipped device. STEP STEP Use the power cord provided to connect the POWER port to power outlet. Connect with wireless devices (optional) STEP You can connect your wireless devices with the correct SSID and Passphrase. If you have not changed them, the default values are indicated on the sticker on the rear of the unit. 2.4GHz SSID:XXXXXXXXXXXX PassPhrase:XXXXXXXXXXXX 5GHz SSID:XXXXXXXXXXXX PassPhrase:XXXXXXXXXXXX Connect options User configuration STEP Wireless Devices Computer Power Adaptor Cable Your gateway has a configuration interface allowing complete control over the device’s behavior. In a Web browser, enter 192.168.0.1 in the address bar. In the screen that displays, enter cusadmin as the username and password as the password. Setup Complete Congratulations! You have successfully set up your gateway. If you have any problems, see the sections below for help identifying the problem. IP addresses If your gateway is successfully connected to the network (see LED display) but you cannot access the Internet from a connected computer, your computer’s IP Address may be set up wrongly. In your computer’s control panel either ensure that the computer is configured to receive an IP address automatically (recommended) or ensure that it has a static IP address in the range 192.168.0.10~192.168.0.254. For more information, consult your Operating System’s document. LED display Power Green-Steady The gateway is receiving power. Off Not powered. Green-Steady A device is connected to one of LAN ports but is Off not transmitting or receiving data. The gateway is searching for the downstream No device is connected to one of the LAN ports. frequency. Green-Steady Downstream frequency is locked. (1 channel only) Blue-Steady Downstream frequency is locked. (channel bonding) Off Not scanning A device is connected to one of LAN ports and is transmitting or receiving data. LAN Connec Green-Blinking t power Downsteam Green-Blinking Green-Blinking The 2.4GHz wireless network is enabled, and data is being transmitted or received. Wireless (2.4GHz) Green-Steady The 2.4GHz wireless network is enabled, and no data is being transmitted or received. Off The 2.4GHz wireless network is not enabled. Green-Blinking The gateway is searching for the upstream Green-Blinking The 5GHz wireless network is enabled, and data is frequency. Upsteam Green-Steady Upstream frequency is locked. (1 channel only) Blue-Steady Upstream frequency is locked. (channel bonding) Off Not scanning being transmitted or received. Wireless (5GHz) Green-Steady data is being transmitted or received. Off and is transmitting or receiving data. head-end. Green-Steady Gateway is operational for data transmission. Off Gateway is offline. The 5GHz wireless network is not enabled. Green-Blinking A USB device is connected to one of the USB ports, Green-Blinking Registration is in progress with cable company’s Online The 5GHz wireless network is enabled, and no USB Green-Steady A USB device is connected to one of the USB ports, and is not transmitting or receiving data. Off No USB device is connected to eigher USB port. Safety Warnings WARNING Risk of electrical shock. Do not expose the device to water or moisture. The device is a high-performance communications device designed for home and office environments. Do not use the device outdoors. Keep the device in an environment between 0°C ~ 40°C (32°F ~104°F). To avoid overheating, do NOT place any object on top of the device. Do not restrict the flow of air around the cable modem. The manufacturer assumes no liabilities for damage caused by any improper use of the device. DISCLAIMER The manufacturer assumes no liabilities with respect to the contents of this document. The manufacturer also reserves the right to revise this document or update the content thereof without any obligation to notify any person of such revisions or amendments. Specifications subject to change without notice. CAUTION The cable distribution system should be grounded (earthed) in a accordance with ANS/NFPA 70, the National Electrical Code (NEC), in particular Section 820.93, Grounding of Outer Conductive Shield of a Coaxial Cable. FCC Statement: Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: ● Reorient or relocate the receiving antenna. ● Increase the separation between the equipment and receiver. ● Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. ● Consult the dealer or an experienced radio/TV technician for help. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. This device is going to be operated in 5.15~5.25GHz frequency range, it is restricted in indoor environment only. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. For product available in the USA/Canada market, only channel 1~11 can be operated. Selection of other channels is not possible. IC Statement: This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. For product available in the USA/Canada market, only channel 1~11 can be operated. Selection of other channels is not possible. Pour les produits disponibles aux États-Unis / Canada du marché, seul le canal 1 à 11 peuvent être exploités. Sélection d'autres canaux n'est pas possible. This device and it's antennas(s) must not be co-located or operating in conjunction with any other antenna or transmitter except in accordance with IC multi-transmitter product procedures. Cet appareil et son antenne (s) ne doit pas être co-localisés ou fonctionnement en association avec une autre antenne ou transmetteur. The device for the band 5150-5250 MHz is only for indoor usage to reduce potential for harmful interference to co-channel mobile satellite systems. Les dispositifs fonctionnant dans la bande 5150-5250 MHz sont réservés uniquement pour une utilisation à l’intérieur afin de réduire les risques de brouillage préjudiciable aux systèmes de satellites mobiles utilisant les mêmes canaux. This device and it's antennas(s) must not be co-located or operating in conjunction with any other antenna or transmitter except in accordance with FCC multi-transmitter product procedures. IMPORTANT NOTE: FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 21cm between the radiator & your body. COPYRIGHT © 2015 HITRON TECHNOLOGIES, INC. IC Radiation Exposure Statement: This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 26cm between the radiator & your body. Cet équipement est conforme aux limites d'exposition aux rayonnements IC établies pour un environnement non contrôlé. Cet équipement doit être installé et utilisé avec un minimum de 26cm de distance entre la source de rayonnement et votre corps. P/N:0440010208N0(2A)
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.6 Linearized : Yes Encryption : Standard V4.4 (128-bit) User Access : Print, Extract, Print high-res Create Date : 2016:05:18 15:17:57+08:00 Creator : Adobe Illustrator CS6 (Windows) Modify Date : 2016:06:16 17:42:05+08:00 Title : XMP Toolkit : Adobe XMP Core 4.2.1-c043 52.372728, 2009/01/18-15:08:04 Metadata Date : 2016:06:16 17:42:05+08:00 Creator Tool : Adobe Illustrator CS6 (Windows) Format : application/pdf Document ID : uuid:f83a1baa-42af-4da2-b998-d4a18943086e Instance ID : uuid:286dd461-5934-42e5-a172-047f6effc674 Producer : Adobe PDF library 10.01 Page Count : 2EXIF Metadata provided by EXIF.tools