Hobbyengine Model 0202 26.96-27.28 mhz wireless r/c-tx User Manual users manual

Download:
Mirror Download [FCC.gov]
Document ID	425903
Application ID	79ra1/Ivr6mmt2Fv7SSULw==
Document Description	users manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	68.37kB (854616 bits)
Date Submitted	2004-05-27 00:00:00
Date Available	2004-05-27 00:00:00
Creation Date	2004-04-18 13:39:45
Producing Software	Adobe PDF Library 2.0
Document Lastmod	2004-05-25 10:17:30
Document Title	users manual

1. BATTERIES INSTALLATION OF TRANSMITTER
CONTENTS
(A). Check the contents list and parts (Diagram 1):
2 Main wings
2 Joints
1 Wing cover
1 Fuselage
1 Horizontal wing
1 Vertical wing
1 Plastic sheet
1 Landing gear
9 1 Cross-headed screw driver
10
11
12
13
14
15
1 7.2 V 2/3 "A" rechargeable
battery pack screws
1 Antenna
12 Screws
1 Transmitter
16 Rubber bands
1 Car charger
BATTERIES REQUIREMENT
a. 8 x "AA" alkaline batteries (not included) for transmitter.(Diagram 2a)
b. 7.2V 2/3 "A" Ni-MH rechargeable battery pack (included).(Diagram 2b)
8 x 1.5V / 8 x"AA" / 8 x LR6
7.2V 2/3"A"900mAh
(b)
(Diagram 2)
(a)
1) Horizontally pull down the battery cover, depending on the polarity of
batteries installs batteries to the transmitter. (Diagram 3)
Air Knight
8 x LR6 / 8 x 1.5V / 8 x "AA"
8 x LR6 / 8 x 1.5V / 8 x "AA"
(Diagram 3)
2) Transmitter battery power indicator has 5 LED light. (Red light is battery
power, yellow light is warning, green light are voltage indicators)
IMPORTANT NOTES
14
Battery indicator
1. Check the contents list and all parts.
2. Study the instruction manual carefully before assembling.
3. Ensure all required batteries are ready.
4. Follow the instructions printed in manual when using the quick
charger
5. This product is intended for 14 years and up. (Adult supervision is
required if user is below 14 years old)
6. Do not fly over or near people, power pylon, buildings, highways, train
rails, vehicles, trees, lake, and airport.
7. Do not fly if wind speed is over 3 M/S(or over 5 mph)
E-mail : info@hobbyengine.com.hk
Website : www.hobbyengine.com.hk
13
10
15
11
Warning light
12
OFF ON
OFF ON
Battery voltage indicators
(Diagram 4)
(Diagram 1)
ITEM NO. 0202
4) Wings and body installation
Put wings on top of the plane body and use r ubber bangs to fix it,
following the picture instruction.(Diagram 8)
2. PLANE ASSEMBLY
1) Wing assembly
After match left/right wings
together, put the wings cover
on top of the left/right wings
and put 4 pieces of ø2.0*5PWB
screws. Installs and put 4
pieces of ø2.0*5PWB screws
into the joints.(Diagram 5)
1. Switch to "OFF" position, and plug into the electric power input of car,
connecting the rechargeable battery to the charger.
2. Switch to fast charge/slow charge, charging signal light or battery power
signal light is "ON" that means started charging.
3. After while(fast charge around 40 mins, slow charge around 80 mins),
charging signal light is "OFF" and battery is warm that means fully charged
for the rechargeable battery.
4. Switch to "OFF" position, take off the charger.
Attention:
1. Please do not charge the same rechargable battery continous two times.
2. Please do not use over 12V electric power or the other kind of battery
connect to the charger.
3. After fully charged battery are left over 24 hours, please charge again when
use.
4. The charger has build-in fuse, when the circuit or rechargable battery set are
overheated, the fuse will off the power for protection and safety used.
5. The situation of the liquid coming out from the battery, overheat of the
surface of the battery, smoke coming out from the battery are happened,
when it is charging. Please take out the battery and the charger immediately.
(Diagram 5)
2) Landing gear installation
Put the landing gear and plastic
sheet together to install into the
bottom of the plane. After that,
put the ø2.0*5PB screw to fix
it.(Diagram 6)
4. BATTERY INSTALLATION
Switch to “OFF” position
before installing the
battery.
Motor on/off switch
(Diagram 10)
1. Insert a fully charged rechargeable battery into the plane body.(Diagram 11a)
2. Follow the direction showed in diagram to tied up the battery inside the
plane.(Diagram 11b)
3. Place the cover on top of the body then screw in one screw into both end of
the cover holes.(Diagram 11c)
(Diagram 8)
(Diagram 6)
3) Vertical / Horizontal wings installation
Merge v ertical / horizontal wings together, and put it on the tail of the
plane, following the position of 4 screw holes. After that, use 4 pieces of
ø2.0*5PB screws to fix it.(Diagram 7)
2. THE METHOD OF USING CHARGER AND
RECHARGEABLE BATTERY
FAST CHARGER-OFF-SLOW CHARGER SWITCH
CHARGER PLUG
FAST-OFF-SLOW
CHARGING
SIGNAL LIGHT
CHARGER'S CONNECTOR
7.2V 2/3“A” 900 mAh
CAR CHARGER
BATTERY POWER
SIGNAL LIGHT
(Diagram 9)
After connecting battery and charger, switch to “FAST” position for fast
charging(40 mins) or switch to “SLOW” position for slow charging (80mins).
The charger will be automatically cut off power. Charging time is around 40
minutes.
(Diagram 7)
(Diagram 11)
5. USE AND CONTROL OF TRANSMITTER
CAUTIONS!
The person who holds the airplane should NOT touch the propeller
with any parts of his body to avoid injury.
1. First pull out the antenna to full position, and then switch to “ON” position
(all light will switch on). Advised to move trims to middle position.
2. Left control stick on the transmitter is for speed control. Turn over the plane
body and then switch “ON” the plane power, then the speed control stick is
pushed vertical up/down; the engine will start running and the propeller will
also start rotating. The amount of speed will change according to the
amount of movement apply to control stick. (Diagram 12)
6. USE OF CONTROL STICK
1. Push the controller stick to right/left, the vertical rudder will respond and
move the same direction as the stick. the plane will turn direction during
fly according movement of the rudder.
2. Push the controller stick to up/down, the horizontal rudder will respond in
moving opposite direction. When the stick is pushed up, the rudder will flip
down, in result of that the plane will fly lower. otherwise pushing the stick
down will result in the plane fly higher.
trims
speed control
OFF ON
(Diagram 14)
OFF ON
speed up
(Diagram 19)
(Diagram 17)
LET'S GO FLYING
speed down
direction control
OFF ON
(Diagram 12)
3. Place the plane end facing the used. Advice to adjust both vertical and
horizontal rudder to middle position. The trims on the rudder can be use to
change the position of rudder. (Diagram 13)
1. Starting
a). Fly by hand.
Use left hand to hold the transmitter and
switch it "ON", right hand hold the
airplane. Left hand push the left stick on
the controller to the top and the propellers
rotate in high speed, throw out the
airplane horizontally and directly head to
the wind, watch the airplane flying
position and decide whether alignment is
required. (Diagram 15)
OFF ON
OFF ON
(Diagram 15)
(Diagram 20)
(Diagram 18)
the adjustor of
horizontal rudder
the adjustor of
vertical rudder
b). Take off from the ground.
Place the airplane on the ground and
switch “ON” the transmitter. Push the left
stick to the top on the transmitter and
propeller will rotate in the highest speed.
The airplane will move forword in full
speed and take off from the ground.
(Diagram 15)
Note:
When all three battery voltage indicators (green lights) are
switched off, that indicates the “AA” battery of the transmitter
need renewing.
(Diagram 16)
(Diagram 13)
10
FCC NOTE:
THE ANTENNA PROVIDED IS A UNIQUE ANTENNA. BY INSTALLATION OF UNAUTHORIZED
ANTENNA TO THIS EQUIPMENT. SUCH UNAUTHORIZED INSTALLATION COULD VOID THE
USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR T V INTERFERENCE CAUSED
BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS
COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : No
Modify Date                     : 2004:05:25 10:17:30+08:00
Producer                        : Adobe PDF Library 2.0
Create Date                     : 2004:04:18 13:39:45
Page Count                      : 2

EXIF Metadata provided by EXIF.tools