Holtzbrk Publishers RLR15 Wireless handheld classroom response device for students User Manual
Holtzbrinck Publishers Wireless handheld classroom response device for students Users Manual
Users Manual
i>clicker+ Remote FCC
FCC ID: T24-RLR15
Changes not expressly approved by Holtzbrinck Publishers could void the user’s
authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
UÊ,iÀiÌÊÀÊÀiV>ÌiÊÌiÊÀiViÛ}Ê>Ìi>°
UÊVÀi>ÃiÊÌiÊÃi«>À>ÌÊLiÌÜiiÊÌiÊiµÕ«iÌÊ>`ÊÀiViÛiÀ°
UÊÊiVÌÊÌiÊiµÕ«iÌÊÌÊ>ÊÕÌ«ÕÌÊÊ>ÊVÀVÕÌÊ`vviÀiÌÊvÀÊÌ>ÌÊÌÊÜVÊÌiÊ
receiver is connected.
UÊÃÕÌÊÌiÊ`i>iÀÊÀÊ>ÊiÝ«iÀiVi`ÊÀ>`É/6ÊÌiVV>ÊvÀÊi«°
/ÃÊ«À`ÕVÌÊV«iÃÊÜÌÊÊ"/ÊÕiÌÊÈxÊÀ>`>ÌÊiÝ«ÃÕÀiÊÌÃÊÃiÌÊvÀÌÊvÀÊ>Ê
uncontrolled environment.
i>clicker+ Remote IC
IC: 6495A-RLR15
Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Student
Quick Start Guide
www.iclicker.com
Answering Questions
Press the A-E button that
corresponds to your answer.
ÊUÊÊÊÃÌi>`ÞÊ}ÀiiÊU light
indicates that your answer
was received.
ÊUÊÊÊy>Ã}ÊÀi`ÊU light
indicates that your answer
was not received or your
instructor has not started
polling.
NOTE: This i>clicker remote
can be used for polling
questions that requires A-E
responses only. For questions
that require alphanumeric
responses, you must use the
i>clicker2 remote.
Registering your i>clicker+
Check with your instructor to
find out whether you should
register your remote through
your institution’s Course
Management System or the
iclicker website.
Use the 8-character ID printed
on the back of the remote to
register.
Turning on your i>clicker+
Press the Power button.
ÊUÊÊÊÃ`Ê}ÀiiÊU Power
light indicates your
remote is on.
Replacing the Batteries
Êy>Ã}ÊÀi`ÊU Low Battery
light indicates less than 10
hours of battery life remain.
1. Open the battery cover on
the back of the remote.
2. Remove both batteries.
3. Replace the batteries with
two new AAA batteries.
NOTE: Alkaline batteries
recommended.
4. Replace the battery cover.
Changing the Frequency
1. Press and hold the Power
button until the Power light
y>ÃiÃÊ}ÀiiÊU.
2. Use the A-E buttons to
enter the 2-letter frequency
code provided by your
instructor.
Green U lights indicate that
the frequency was changed
successfully.
Flashing red U A-E
lights indicate that the
frequency was not changed
successfully. Check the
frequency code provided by
your instructor and try again.