Honda Lock Mfg HLIK-1T RKE Transmitter User Manual
Honda Lock Mfg. Co., Ltd. RKE Transmitter Users Manual
Users Manual
＋
−
≦
≦
≦
Remove the old battery from the
back of the inner cover, and insert
a new battery into the back of the
cover with the side facing down.
Install the parts in reverse order.
An improperly disposed battery
can hurt the environment.
Always confirm local regulations
for battery disposal.
4.
5.
Keyless Entry Function
When using radio equipment with
very small output capacity, the
equipment must accept any
interference caused by the emission
of various radio communication
equipment as well as industrial,
scientific and medical facilities.
Use of such radio equipment is
prohibited in an aeroplane and around
an airport.
Modulation Mode: FSK
Frequency Range: 313 314 MHz
Transmitting Power: 6000 V/m (3
m)
Occupied Bandwith: 300 kHz
Spurious Emission Limits: 600 V/m
(3 m)
The equipment shall not cause any
harmful interference with various
authorized radio communication. If
such interference is detected,
operation of the equipment shall be
suspended until a measure is taken to
remove such interference.
The user shall not change the
transmission frequency, amplify the
output capacity by such means as
installing a transmission amplifier,
install another aerial, or replace the
original transmission aerial without
permission of the Authority.
Instruments and Controls
Remote Transmitter
Chinese Regulations for Controlling
Short Range Radio Equipment
84
06/03/20 16:43:07 32SDRT00_089
＋
Inside the transmitter, separate
the inner cover from the keypad
by releasing the two tabs on the
cover.
Remove the old battery from the
back of the inner cover, and note
the polarity. Make sure the
polarity of the new battery is the
same ( side facing down), then
insert it into the back of the cover.
Install the parts in reverse order.
3.
4.
5.
As required by the FCC:
This device complies with Part 15 of the
FCC rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any
interference received, including
interference that may cause undesired
operation.
Changes or modifications not expressly
approved by the party responsible for
compliance could void the user’s
authority to operate the equipment.
This device complies with Industry
Canada Standard RSS-210.
Operation is subject to the following two
conditions: (1) this device may not cause
interference, and (2) this device must
accept any interference that may cause
undesired operation of the device.
Remote Transmitter
Instruments and Controls
87
TAB
BATTERY
０５／０５／２６ １７：１９：２４ ３１ＳＮＡ６００ ００９０