Honeywell LXERFID3 802.11 b/g radio User Manual RX2 User s Guide

Honeywell International, Inc. 802.11 b/g radio RX2 User s Guide

Contents

User Manual 2

 E-EQ-RX2OGWW-B RX2 User’s Guide  Appendix A  Regulatory Notices and Safety Information  FCC Information: This device complies with FCC Rules, part 15. Operation is subject to the following two conditions: 1.  This device may not cause harmful interference  and 2.  This device must accept any interference, including interference that may cause undesired operation. Note:  This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction guide, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. Warning:  Changes or modifications to this device not expressly approved by LXE, Inc., could void the user’s authority to operate this equipment. Industry Canada: This Class A digital apparatus meets all requirements of the Canadian Interference Causing Equipment Regulations. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Cet appareil numérique de la classe A respecte toutes les exigences du Règlement sur le matériel brouiller du Canada. Le present appareil numérique n’emet pas de bruits radioélectriques dépassant les limites applicables aux appareils numeriques de le Classe A préscrites dans le Reglement sur le brouillage radioélectrique édits par le ministere des Communications du Canada. RF Safety Notice Caution   This device is intended to transmit RF energy.  For protection against excessive RF exposure to humans and in accordance with FCC and Industry Canada rules, this transmitter should be installed such that a minimum separation distance of at least 25cm (9.8 in.) is maintained between the antenna and the general population.  This device is not to be co-located with other transmitters. Notice: The long term characteristics or the possible physiological effects of radio frequency electromagnetic fields have not been investigated by UL. Antenna Description: The antenna approved to operate with the RX2 Vehicle Mount Computer is a Right Hand, Circularly Polarized (RHCP) single-patch with 5dbi linear gain.     For ENG/CERT Review - Not for Distribution or Publication - Draft 04
24  Approvals RX2 User’s Guide  E-EQ-RX2OGWW-B Approvals Product  EMI / EMC Standards RX2  FCC Part 15 Subpart B, Class A  Industry Canada Class A Transceiver: Transceiver RF Standards Notes FCC Part 15, Subpart C FCC Part 2  Unlicensed Operation  IC-RSS 210  Requires License for Outdoor Use 6726  (LXE Model No.) [Cisco] IC-RSS 102   4830  (LXE Model No.) LXE 2.4GHz  CF with Type II PCMCIA Adapter Card FCC Part 15, Subpart C IC-RSS 210 IC-RSS 102 Unlicensed Operation  Requires License for Outdoor Use RFID Reader (Sirit) FCC Part 15, Subpart C IC-RSS 210 IC RSS 102 Unlicensed Operation  Requires License for Outdoor Use   Important:  This symbol is placed on the product to remind users to dispose of Waste Electrical and Electronic Equipment (WEEE) appropriately, per Directive 2002-96-EC. In most areas, this product can be recycled, reclaimed and re-used when properly discarded. Do not discard labeled units with trash. For information about proper disposal, contact LXE through your local sales representative, or visit www lxe com.    ! Vehicle Power Supply Connection Safety Statement ! Vehicle Power Supply Connection:  If the supply connection is made directly to the battery, a 2A slow-blow fuse should be installed in the positive lead within 5 inches (12.7 cm.) of the battery positive (+) terminal.  (US)  Legend:  English – US Updated 02/10/2004 For ENG/CERT Review - Not for Distribution or Publication - Draft 04

Navigation menu