Horizon Hobby PLANO1T Plano RF Module User Manual Plano User Guide f

Horizon Hobby, LLC Plano RF Module Plano User Guide f

Exhibit D Users Manual per 2 1033 b3

Page 1 of 4 Plano RF Module User Manual Horizon Hobby, LLC 4105 Fieldstone Rd Champaign, IL 61822 1. Features  2.4GHz Frequency Hopping spread spectrum (FHSS) radio transceiver module  Operates in the unlicensed worldwide ISM band (2.4 GHz to 2.483.5GHz) band  Fully integrated power regulation with a wide input unregulated operating range 3V to 10V  Fully integrated local oscillator and 24MHz 10ppm reference crystal  400mA operating current  Transmit power - <=18.5dBm in EU, <=26dBm in North America  Receive sensitivity up to -95dBm  DSSS data rates up to 1Mbps  1 mile operating range  Full packet assembling and disassembling  Auto transaction sequencer  Fully buffered digital interface with high voltage tolerant inputs 2. Pin description Pin Number Name Description 1 RF_P Positive RF input signal to LNA during RX Positive RF output signal to PA during TX 2 RF_N Negative RF input signal to LNA during RX Negative RF output signal to PA during TX 3,7,17,20,29,33 GND Module GND 4 RX_TX Optional bias pin for the RF LNA 5 X32K_Q1 32-kHz crystal oscillator pin 1 6 X32K_Q2 32-kHz crystal oscillator pin 2 8 DIO_0 GPIO, Sensor Controller, high-drive capability 9 DIO_1 GPIO, Sensor Controller, high-drive capability 10 DIO_2 GPIO, Sensor Controller, high-drive capability 11 VDDS2 1.8-V to 3.8-V GPIO supply 12 DCOUPL 1.27-V regulated digital-supply decoupling capacitor( 13 JTAG_TMSC JTAG TMSC
Page 2 of 4 14 JTAG_TCKC JTAG TCKC 15 DIO_3 GPIO, High drive capability, JTAG_TDO 16 DIO_4 GPIO, High drive capability, JTAG_TDI 18 DCDC_SW Output from internal DC-DC. Tie to ground for external regulator mode 19 VDDS_DCDC (1.7-V to 1.95-V operation) 21 RESET_N Reset, active-low. No internal pullup. 22 DIO_5 GPIO, Sensor Controller, Analog 23 DIO_6 GPIO, Sensor Controller, Analog 24 DIO_7 GPIO, Sensor Controller, Analog 25 DIO_8 GPIO, Sensor Controller, Analog 26 DIO_9 GPIO, Sensor Controller, Analog 27 VDDS 1.8-V to 3.8-V main chip supply 28 VDDR 1.7-V to 1.95-V supply, typically connect to output of internal DC-DC. 30 X24M-N 24-MHz crystal oscillator pin 1 31 X24M_P 24-MHz crystal oscillator pin 2 32 VDDR_RF 1.7-V to 1.95-V supply, typically connect to output of internal DC-DC( 3. Specifications Parameter Value Units Storage Temp -65 to 105 Degrees Celsius VDD 2.4 to 3.6 Volts Receive Sensitivity -95 dBm Transmit power (conducted) 25.5 dBm MAX Transmit power (radiated) 27 dBm MAX Idle current 5 mA Receive current 22 mA Transmit current 400 mA
Page 3 of 4 4. Module User Requirements 4.1 This module must be integrated into a device where the user cannot access the antenna connector. 4.2 Only a 1.5dBi antenna can be used with this module. The antenna must meet and not exceed the gain and pattern of the supplied folded dipole antenna. 4.3 The device must contain the following permanent labeling on the exterior of the device as follows: Contains FCC ID: BRWPLANO1T Contains IC: 6157A-PLANO1T 4.4 The user manual of the device must contain the following paragraph:
Page 4 of 4 FCC Information This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Caution: Changes or modifications not expressly approved by the party manufacturer could void the user’s authority to operate the equipment. 4.5 This module meets the requirements for a mobile device that may be used at separation distances of more than 5cm from the human body. It may be used in hand-held controllers that provide a separation distance of at least 5cm between the antenna and the body (excluding hands/wrists). IC Information This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. CE Information This product contains a radio transmitter with wireless technology which has been tested and found to be compliant with the applicable regulations governing a radio transmitter in the 2.400 GHz to 2.4835 GHz frequency range.

Navigation menu