Hp 9000 Superdome Sx2000 Servers Installation Manual Guide, Integrity Superdome/sx2000 And

2015-01-05

• HP Installation Guide, HP Integrity Superdome/sx2000 and HP 9000 Superdome/sx2000 Servers
• About This Document
  • Intended Audience
  • Document Organization
  • Typographic Conventions
  • Related Information
  • Publishing History
  • HP contact information
  • Documentation feedback
• 1 Installing the System
  • Introduction
    • Communications Interference
    • Electrostatic Discharge
    • Public Telecommunications Network Connection
  • Unpacking and Inspecting the System
    • Verifying Site Preparation
      • Gathering LAN Information
      • Verifying Electrical Requirements
    • Checking the Inventory
    • Inspecting the Shipping Containers for Damage
      • Inspection Precautions
      • Claims Procedures
    • Unpacking and Inspecting Hardware Components
      • Tools Required
      • Unpacking the Cabinet
    • Unpacking the PDCA
    • Returning Equipment
  • Setting Up the System
    • Moving the System and Related Equipment to the Installation Site
    • Unpacking and Installing the Blower Housings and Blowers
    • Attaching the Side Skins and Blower Side Bezels
      • Attaching the Side Skins
      • Attaching the Blower Side Bezels
    • Attaching the Leveling Feet and Leveling the Cabinet
    • Installing the Front Door Bezels and the Front and Rear Blower Bezels
      • Installing the Front Door Bezels
      • Installing the Rear Blower Bezel
      • Installing the Front Blower Bezel
    • Wiring Check
    • Installing and Verifying the PDCA
    • Checking Voltage
    • Removing the EMI Panels
    • Connecting the Cables
    • Routing the I/O Cables
  • Adding an IOX Cabinet
  • Installing the Support Management Station
  • Installing the SMS Support Shelf
  • Connecting the SMS to the Superdome
  • SMS Software and Superdome Firmware Downloading Procedure
  • Restore the A9802E SMS PC with the HP Recovery Manager
  • Configuring the Event Information Tools
  • Turning On Housekeeping Power
  • Connecting the MP to the Customer LAN
    • Connecting the MP to the Network
    • Setting the Customer IP Address
  • Booting and Verifying the System
    • Connecting to the MP
    • Powering On the System 48 V Power Supply
    • Booting the HP Integrity Superdome/sx2000 to an EFI Shell
    • Booting an HP 9000 sx2000 Server to BCH
    • Verifying the System
  • Running JET Software
    • Running JUST
    • Power Cycling After Using JET
  • Offline Diagnostic Environment
  • Attaching the Rear Kick Plates
  • Performing a Visual Inspection and Completing the Installation
  • Conducting a Post-Installation Check
• Index