Huawei Technologies MHA-L29 Smart Phone User Manual
Huawei Technologies Co.,Ltd Smart Phone
User Manual
MHA-L09 MHA-L29 Quick Start Guide For more information Go to http://consumer.huawei.com/en/ to download the user guide for your device (including safety information) and read the FAQ, privacy policy, and other information. Go to Settings > About phone > Legal information to read the legal information. Your phone at a glance Before you start, let's take a look at your new phone. ⢠To turn on your phone, press and hold the power button until your phone vibrates and the screen turns on. ⢠To turn off your phone, press and hold the power button, and then touch To forcibly restart your phone, press and hold the power button until your phone vibrates. If your phone does not respond when you press the power button, this indicates that the battery is empty. Charge your battery for at least 10 minutes using a genuine Huawei charger, and then turn on your phone. Earpiece Headset jack Infrared sensor Status indicator Laser sensor Microphone 2# Dual-lens camera Dual-tone flash fingerprint sensor Front camera Volume button Power button USB-C port Microphone 1# Getting started Follow the instructions in the following figures to set up your phone. Do not insert or remove a SIM card while your phone is on. Please exercise caution when using the SIM ejector pin to avoid hurting your fingers or damaging your phone. Store your pin in a safe place out of the reach of children to prevent them from swallowing it or injuring themselves by accident. BO P 4* Insert the SIM card into the correct card slot to ensure Caution that it can be recognized by the phone. NJ BO P 4* BO P 4* 0S BO P 4* 3.'2 3.'2 NJ DSP 4% DSP 4% Dual card dual standby single pass Your phone supports only dual card dual standby single pass, which means you cannot use both SIM cards for calls or data services simultaneously. ⢠When you are on a call using SIM card 1, SIM card 2 cannot be used to make or answer calls. If someone calls SIM card 2, the caller will hear a voice message similar to "The subscriber you dialed is out of the service area" or "The subscriber you dialed cannot be connected for the moment, please try again later." The actual message will vary by service provider. ⢠When you are using SIM card 1's data service, SIM card 2's data service will be disabled. Your phone's single pass feature helps reduce power consumption and increase your phone's standby time. It is not related to your service provider's network conditions. It may be a good idea to contact your service provider and subscribe to missed call reminder and related assistance services to avoid the conflicts mentioned above. Safety Information Please read all of the safety information carefully before using your device to ensure its safe and proper operation and to learn how to dispose of your device properly. Operation and safety ⢠To prevent possible hearing damage, do not listen at high volume levels for long periods. ⢠Using an unapproved or incompatible power adapter, charger, or battery may damage your device, shorten its lifespan, or cause a fire, explosion, or other hazards. ⢠Ideal operating temperatures are XX °C to XX °C. Ideal storage temperatures are XX °C to XX °C. ⢠Pacemaker manufacturers recommend that a minimum distance of 15 cm be maintained between a device and a pacemaker to prevent potential interference with the pacemaker. If using a pacemaker, hold the device on the side opposite the pacemaker and do not carry the device in your front pocket. ⢠Keep the device and the battery away from excessive heat and direct sunlight. Do not place them on or in heating devices, such as microwave ovens, stoves, or radiators. ⢠Observe local laws and regulations while using the device. To reduce the risk of accidents, do not use your wireless device while driving. ⢠While flying in an aircraft or immediately before boarding, only use your device according to instructions provided. Use of a wireless device in an aircraft may disrupt wireless networks, present a hazard to aircraft operation, or be illegal. ⢠To prevent damage to your device's parts or internal circuits, do not use it in dusty, smoky, damp, or dirty environments or near magnetic fields. ⢠When charging the device, make sure the power adapter is plugged into a socket near the devices and is easily accessible. ⢠Unplug the charger from electrical outlets and the device when not in use. ⢠Do not use, store or transport the device where flammables or explosives are stored (in a gas station, oil depot, or chemical plant, for example). Using your device in these environments increases the risk of explosion or fire. ⢠Dispose of this device, the battery, and accessories according to local regulations. They should not be disposed of in normal household waste. Improper battery use may lead to fire, explosion, or other hazards. FCC Regulatory Compliance Body worn operation The device complies with RF specifications when used near your ear or at a distance of 1.5 cm from your body. Ensure that the device accessories, such as a device case and device holster, are not composed of metal components. Keep the device away from your body to meet the distance requirement. Certification information (SAR) This device is also designed to meet the requirements for exposure to radio waves established by the Federal Communications Commission (USA). The SAR limit adopted by the USA is 1.6 W/kg averaged over one gram of tissue. The highest SAR value reported to the FCC for this device type complies with this limit. MHA-L09: The highest SAR value reported to the FCC for this device type when using at the ear is 1.42 W/kg, and when properly worn on the body is 0.6 W/kg, and when using the Wi-Fi hotspot function is 1.39 W/Kg. MHA-L29: The highest SAR value reported to the FCC for this device type when using at the ear is 1.42 W/kg, and when properly worn on the body is 0.6 W/kg, and when using the Wi-Fi hotspot function is 1.39 W/Kg. FCC statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Caution: Any changes or modifications to this device not expressly approved by Huawei Technologies Co., Ltd. for compliance could void the user's authority to operate the equipment. Industry Canada compliance Body worn operation The device complies with RF specifications when used near your ear or at a distance of 1.5 cm from your body. Ensure that the device accessories, such as a device case and device holster, are not composed of metal components. Keep the device away from your body to meet the distance requirement. MHA-L09: The highest SAR value reported to the IC for this device type when using at the ear is 1.41 W/kg, and when properly worn on the body is 0.6 W/kg, and when using the Wi-Fi hotspot function is 1.39 W/Kg. MHA-L29: The highest SAR value reported to the IC for this device type when using at the ear is 1.41 W/kg, and when properly worn on the body is 0.6 W/kg, and when using the Wi-Fi hotspot function is 1.39 W/Kg. IC Statement This device complies with CAN ICES-3 (B)/NMB-3(B). This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Restrictions in the 5 GHz band: Within the 5.15 to 5.25 GHz band, UNII devices will be restricted to indoor operations to reduce any potential for harmful interference to co-channel Mobile Satellite System (MSS) operations. , and are trademarks or registered trademarks of Huawei Technologies Co., Ltd. Manufactured under license from Dolby Laboratories. Dolby and the double-D symbol are registered trademarks of Dolby Laboratories. The N-Mark is a trademark or registered trademark of NFC Forum, Inc. in the United States and in other countries. LTE is a trademark of ETSI. Wi-FiÂŽ, the Wi-Fi CERTIFIED logo, and the Wi-Fi logo are trademarks of Wi-Fi Alliance. Privacy Policy To better understand how we protect your personal information, please see the privacy policy at http://consumer.huawei.com/privacy-policy. Copyright Š Huawei Technologies Co., Ltd. 2015. All rights reserved. THIS DOCUMENT IS FOR INFORMATION PURPOSE ONLY, AND DOES NOT CONSTITUTE ANY KIND OF WARRANTIES. All pictures and illustrations in this guide, including but not limited to the phone color, size, and display content, are for your reference only. The actual product may vary. Nothing in this guide constitutes a warranty of any kind, express or implied. For DTS patents, see http://patents.dts.com. Manufactured under license from DTS Licensing Limited. DTS, the Symbol, & DTS and the Symbol together are registered trademarks, and DTS Sound is a trademark of DTS, Inc. Š DTS, Inc. All Rights Reserved. The N-Mark is a trademark or registered trademark of NFC Forum, Inc. in the United States and in other countries. Note: Remember the Google account your phone last logged in to. During an untrusted factory settings restoration or microSD cardâbased update, Google's anti-theft mechanism requires you to enter the Google account your phone last logged in to on the startup navigation screen for identity authentication. Your phone can properly power on only after the identity authentication passes. Please visit http://consumer.huawei.com/en/support/hotline for recent updated hotline and email address in your country or region. Model: MHA-L09 MHA-L29
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.6 Linearized : No Author : Create Date : 2016:09:14 18:14:50+08:00 Modify Date : 2016:09:18 07:23:09+08:00 Has XFA : No XMP Toolkit : Adobe XMP Core 5.2-c001 63.139439, 2010/09/27-13:37:26 Producer : Acrobat Distiller 10.0.0 (Windows) Creator Tool : PScript5.dll Version 5.2.2 Metadata Date : 2016:09:18 07:23:09+08:00 Format : application/pdf Creator : Title : Document ID : uuid:26a9c30a-bc9e-447f-9af3-144727d9dba8 Instance ID : uuid:8ed34c7e-f030-4d60-812a-668998ce9663 Page Count : 12EXIF Metadata provided by EXIF.tools