Huawei P20 Pro Quick Start Guide (CLT AL00, EMUI8.0, 01, English, India, Normal)

User Manual: Huawei

Open the PDF directly: View PDF .
Page Count: 10

CLT-AL00

Quick Start Guide

Your Device at a Glance

Before you start, let's take a look at your new device.

lTo power on your device, press and hold the power button

until the screen turns on.

lTo power off your device, press and hold the power button,

and then touch .

lTo restart your device, press and hold the power button,

and then touch .

lPress and hold the power button for 10 or more seconds to

forcibly restart your device.

NFC

NFC

1

3

4

5

6

7

8

10

9

2

11

12

13

14

15

16

Secondary microphone Laser sensor

Rear camera Flash / Color

temperature sensor

Earpiece Card slot

Primary microphone USB-C port / Headset

jack

Speaker Fingerprint scanner

Power button Volume button

Ambient light sensor /

Optical proximity

sensor

Front camera

Status indicator Infrared sensor

1

Getting Started

lDo not insert or remove the SIM card when your device

is powered on.

lEnsure that the card is correctly aligned and that the

card tray is level when you insert it into your device.

lBe careful not to scratch your device or hurt yourself

when using the eject pin.

lStore the eject pin out of the reach of children to

prevent accidental swallowing or injury.

lDo not use cut or modied SIM cards with your device

as these may not be recognized and could damage the

card tray (slot).

lIf your SIM card does not match your device, please

contact your carrier.

Follow the instructions in the following gures to set up your

device. Please use the eject pin included.

1 2

2

Dual Card Dual Standby Single

Pass

Your device supports only dual card dual standby single pass,

which means you cannot use both SIM cards for calls or data

services simultaneously.

lWhen you are on a call using SIM card 1, SIM card 2 cannot

be used to make or answer calls. If someone calls SIM card

2, the caller will hear a voice message similar to "The

subscriber you dialed is out of the service area" or "The

subscriber you dialed cannot be connected for the moment,

please try again later." The actual message will vary by

service provider.

lWhen you are using SIM card 1's data service, SIM card 2's

data service will be disabled.

Your device's single pass feature helps reduce power

consumption and increase your device's standby time. It is not

related to your service provider's network conditions.

You can go to Settings > Wireless & networks > Dual SIM

settings, and enable Enable call forwarding between SIMs

to avoid the conicts mentioned above.

3

For More Information

If you encounter any problems while using your device, you

can obtain help from the following resources:

lGo to Tips for function details and usage tips.

lVisit http://consumer.huawei.com/en to view device

information, frequently asked questions and other

information.

lVisit http://consumer.huawei.com/en/support for the most

up-to-date contact information for your country or region.

lYou can nd service hotlines, retailer addresses, service

policies and more information for your local region in

HiCare.

Go to Settings and touch System > About phone > Legal to

view legal information for your product.

Go to Settings and touch System > About phone > Legal >

Safety information to view safety information for your

product.

Go to Settings and touch System > Certication logos to

view more information on certication logos for your product.

All pictures and illustrations in this guide, including but

not limited to the device color, size, and display content,

are for your reference only. The actual device may vary.

Nothing in this guide constitutes a warranty of any kind,

express or implied.

4

Safety Information

Please read all of the safety information carefully before using

your device to ensure its safe and proper operation and to

learn how to dispose of your device properly.

Operation and safety

l To prevent possible hearing damage, do not

listen at high volume levels for long periods.

lUsing an unapproved or incompatible power adapter,

charger, or battery may damage your device, shorten its

lifespan, or cause a re, explosion, or other hazards.

lIdeal operating temperatures are 0 °C to 35 °C. Ideal

storage temperatures are -20 °C to +45 °C.

lPacemaker manufacturers recommend that a minimum

distance of 15 cm be maintained between a device and a

pacemaker to prevent potential interference with the

pacemaker. If using a pacemaker, hold the device on the

side opposite the pacemaker and do not carry the device in

your front pocket.

lKeep the device and the battery away from excessive heat

and direct sunlight. Do not place them on or in heating

devices, such as microwave ovens, stoves, or radiators.

lObserve local laws and regulations while using the device.

To reduce the risk of accidents, do not use your wireless

device while driving.

lWhile ying in an aircraft or immediately before boarding,

only use your device according to instructions provided. Use

of a wireless device in an aircraft may disrupt wireless

networks, present a hazard to aircraft operation, or be

illegal.

lTo prevent damage to your device's parts or internal

circuits, do not use it in dusty, smoky, damp, or dirty

environments or near magnetic elds.

lWhen charging the device, make sure the power adapter is

plugged into a socket near the devices and is easily

accessible.

lUnplug the charger from electrical outlets and the device

when not in use.

lDo not use, store or transport the device where ammables

or explosives are stored (in a gas station, oil depot, or

5

chemical plant, for example). Using your device in these

environments increases the risk of explosion or re.

lDispose of this device, the battery, and accessories

according to local regulations. They should not be disposed

of in normal household waste. Improper battery use may

lead to re, explosion, or other hazards.

lYour device has been tested in a controlled environment

and certied to be splash, water, and dust resistant in

specic situations (meets requirements of classication IP67

as described by the international standard IEC 60529).

Splash, water, and dust resistance are not permanent

conditions and resistance might decrease as a result of

normal wear. Do not charge your device in wet conditions.

Visit http://consumer.huawei.com/en/support for detailed

description of this function.

Safety precautions

lUse of wireless hands-free system (headphone, headset)

with a low power Bluetooth emitter.

lMake sure the cell phone has a low SAR.

lKeep your calls short or send a text message (SMS) instead.

This advice applies especially to children, adolescents and

pregnant women.

lUse cell phone when the signal quality is good.

lPeople having active medical implants should preferably

keep the cell phone at least 15 cm away from the implant.

Disposal and Recycling Information

This symbol on the device or on its packaging

indicates that the device (including its electrical accessories)

should not be disposed of as normal household garbage.

Do not dispose this product with Regular Household, Dry and

Wet Waste. If you wish to discard this product, please contact

on the details below and follow the correct method of disposal

as guided:

E-mail: service.hw.in@huawei.com, Service hotline:

1800-209-6555 (Toll-Free) 9AM-9PM all 7 days, except public

holidays.

For further information, log on to:

Huawei E-waste Policy: http://consumer.huawei.com/in/

support/e-waste-process-policy/.

6

Ofcial Recycling Partner: Reteck Envirotech Private Limited.

Plot-4A, Sanghi Udyog, Near Navade Railway Station, Tal-

Panvel, Dist. - Raigad, Taloja MIDC-410208.

info@reteck.in

www.reteck.in / www.reteck.co

Reduction of Hazardous Substances

This device is compliant with the E-Waste (Management)

Rules, 2016 and does not contain hazardous substances

regulated by the Rules except for the applications of

exemption.

Certication Information (SAR)

This device meets guidelines for exposure to radio waves.

Your device is a low-power radio transmitter and receiver. As

recommended by international guidelines, the device is

designed not to exceed the limits for exposure to radio waves.

These guidelines were developed by the independent scientic

organization International Commission on Non-Ionizing

Radiation Protection (ICNIRP) and include safety measures

designed to ensure safety for all users, regardless of age and

health.

The Specic Absorption Rate (SAR) is the unit of measurement

for the amount of radio frequency energy absorbed by the

body when using a device. The SAR value is determined at the

highest certied power level in laboratory conditions, but the

actual SAR level of the device when being operated can be

well below the value. This is because the device is designed to

use the minimum power required to reach the network.

The SAR limit adopted by India is 1.6 watts/kilogram (W/kg)

averaged over one gram of tissue. The highest SAR value for

this device is 0.93 W/kg.

7

Legal Notice

Trademarks and Permissions

, , and are trademarks or

registered trademarks of Huawei Technologies Co., Ltd.

Android™ is a trademark of Google Inc.

LTE is a trademark of ETSI.

The Bluetooth® word mark and logos are registered

trademarks owned by Bluetooth SIG, Inc. and any use of such

marks by Huawei Technologies Co., Ltd. is under license.

Wi-Fi®, the Wi-Fi CERTIFIED logo, and the Wi-Fi logo are

trademarks of Wi-Fi Alliance.

Privacy Policy

To better understand how we protect your personal

information, please see the privacy policy at http://

consumer.huawei.com/privacy-policy.

Copyright © Huawei Technologies Co., Ltd.

2018. All rights reserved.

THIS DOCUMENT IS FOR INFORMATION PURPOSE ONLY, AND

DOES NOT CONSTITUTE ANY KIND OF WARRANTIES.

8

底边留5mm

The N-Mark is a trademark or registered

trademark of NFC Forum, Inc. in the United

States and in other countries.

31509730_01