Huf Huelsbeck and Fuerst and KG HS1 Radio Identification Device User Manual Technical Description and Users Manual
Huf Huelsbeck & Fuerst GmbH & Co. KG Radio Identification Device Technical Description and Users Manual
Users Manual
Huf Hülsbeck & Fürst User’s Manual of the DAG Key Gen. 6 User’s Manual of the DAG Key Gen. 6 Model: HS1 PDSCA1 - T. Herzog Seite 1 von 6 28.08.2014 Huf Hülsbeck & Fürst Technical Description and User’s Manual of the DAG Key Gen. 6 Contents 1 General operation of the key ..................................................................................................................... 3 2 Operating frequencies of HF transferral .................................................................................................... 3 2.1 3-channel ............................................................................................................................................ 3 2.2 Operation of channel-frequencies and power-modes ......................................................................... 4 3 Block diagram ............................................................................................................................................ 4 4 Technical data ........................................................................................................................................... 5 4.1 Electrical characteristics ..................................................................................................................... 5 4.2 General HF specification..................................................................................................................... 5 4.3 Disposal .............................................................................................................................................. 5 5 Declaration of Conformity, product Label .................................................................................................. 6 5.1 Radio equipment authorization to FCC in USA .................................................................................. 6 5.2 Radio equipment authorization to RSS-210 in Canada ...................................................................... 6 5.3 Location of product label ..................................................................................................................... 6 PDSCA1 - T. Herzog Seite 2 von 6 28.08.2014 Huf Hülsbeck & Fürst Technical Description and User’s Manual of the DAG Key Gen. 6 1 General operation of the key The DAG Key Gen. 6 consists of a HF transceiver. It is used to transmit the information for locking or unlocking the vehicle by an uni-directional (Remote Keyless Entry RKE) or bi-directional (Keyless Go/Start operation after a LF Wake Up KG) HF transmission. At KG the Vehicle Key reacts on a LF Wake Up-Signal from the vehicle (initiated after push of the Start/Stop-button of the vehicle or a sensor, which recognizes the wish to lock or unlock the vehicle or to open the trunk) from the vehicle and after that a bi-directional HF communication for autorization is initiated. When the authorization is successful the vehicle performs the desired action. For RKE there are two separate buttons each one for locking and unlocking the vehicle. The keys for all vehicles with a boot lid are additionally equipped with a third button to open or close the trunk. The key is provided with an additional button to (de-)activate the “PANIC” function for the vehicles intended for the US market. 2 Buttons 3 Buttons 2 Buttons + Panic 3 Buttons + Panic In general the following functions are provided: - Lock the car (KG and RKE) - Unlock the car (KG and RKE) - Open/Close the trunk of the car (KG and RKE, only 3 button variants) - (De-)Activate Panic Function (only RKE and USA variant) - Engine Start of the vehicle (KG) For emergency start, when the battery power is too low, the DAG Key Gen. 6 has a bi-directional very short range (< 10cm) LF-Transponder interface . 2 Operating frequencies of HF transferral 2.1 3-channel Up to 3 channels are possible. The following table shows the carrier frequency of the individual channels for each frequency band. Frequencies Frequency Variant Channel 1 (CH1) Channel 2 (CH2) Channel 3 (CH3) 433.92MHz 433.47MHz 434.37MHz 433.92MHz 315MHz 314.00MHz 314.90MHz 314.45MHz PDSCA1 - T. Herzog Seite 3 von 6 28.08.2014 Huf Hülsbeck & Fürst Technical Description and User’s Manual of the DAG Key Gen. 6 2.2 Operation of channel-frequencies and power-modes Normally each key operates in 3-channel mode at the respective frequencies listed above. Since some countries allow operation with higher HF-transmitter power, the key fob can be configured between two RF power modes. When individual frequencies of the 3 HF-channels are not allowed to use this channel(s) will be switched off. This especially information depends on the countries and is available by the country code of the electronic ignition switch. The key changes its operation at the first time it is be authentically used. The change of used channel frequencies and power mode is durable locked and can not be changed after this. 3 Block diagram SAW Filter HF Transceiver XTAL 24,74 MHz 433.47/433.92/434.37 MHz 314.00/314.45/314.90 MHz PCB Loop Antenna HF Antenna Matching Temporarily 4.12 MHz (fXTAL/6) Programmer Interface LF-ASIC 3D-LF-Coil 3D-Transponder 21,845 kHz µController LED RSSI-Measurement 3V Battery CR2032 Powermanagement 2-4 Micro Switches PDSCA1 - T. Herzog Seite 4 von 6 28.08.2014 Huf Hülsbeck & Fürst Technical Description and User’s Manual of the DAG Key Gen. 6 4 Technical data 4.1 Electrical characteristics Power supply: Type of Battery: Voltage range: Temperature range: Battery (CR2032, coin cell) Lithium 2,1V … 3,2V RKE/KG: -20°C … +65°C Emergency start: -40°C … +85°C 4.2 General HF specification 3-channel operation: fop1 = 433.47 MHz / 433.92 MHz / 434.37 MHz fop2 = 314.00 MHz / 314.45 MHz / 314.90 MHz Transmission power EIRP: 433.92 MHz variant: 315 MHz variant: < -14.4 dBm < -19.6 dBm Type of modulation: FSK, deviation ±10 kHz Type of HF antenna: PCB Loop antenna 4.3 Disposal An old battery must be lodged at a collection point or the service. PDSCA1 - T. Herzog Seite 5 von 6 28.08.2014 Huf Hülsbeck & Fürst Technical Description and User’s Manual of the DAG Key Gen. 6 5 Declaration of Conformity, product Label 5.1 Radio equipment authorization to FCC in USA FCC ID: YGOHS1 The transmitter will be supplied as an original equipment device to the car manufacturer. According to 47 CFR 15.19 (labeling requirements) the car manufacturer will print the following text in the appropriate User’s Manual of the car: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Usually this is followed by the following FCC caution: Any changes or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. 5.2 Radio equipment authorization to RSS-210 in Canada IC: 4008C-HS1 The transmitter will be supplied as an original equipment device to the car manufacturer. According to RSS-210 (labeling requirements) the car manufacturer will print the following text in the appropriate User’s Manual of the car: This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, mêmesi le brouillage est susceptible d'en compromettre le fonctionnement. Usually this is followed by the following RSS caution: Any changes or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. 5.3 Location of product label The product label with FCC ID and IC certification number can be found under the battery cover. PDSCA1 - T. Herzog Seite 6 von 6 28.08.2014
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.6 Linearized : Yes XMP Toolkit : Adobe XMP Core 4.0-c316 44.253921, Sun Oct 01 2006 17:14:39 Producer : GPL Ghostscript 9.06 Keywords : Modify Date : 2014:12:10 13:45:48+01:00 Create Date : 2014:10:06 10:05:45+02:00 Creator Tool : PDFCreator Version 1.6.1 Metadata Date : 2014:12:10 13:45:48+01:00 Document ID : uuid:219d6a83-4f8b-11e4-0000-37f7c46b2832 Instance ID : uuid:8bf04902-4217-480a-a158-fc8a960d16c7 Format : application/pdf Title : Technical Description and Users Manual Creator : therzog Description : () Page Count : 6 Subject : Author : therzogEXIF Metadata provided by EXIF.tools