Hytera Communications POA121 Wireless PTT User Manual 1

Hytera Communications Corporation Limited Wireless PTT 1

User manual

1PrefaceWelcome to the world of Hytera and thank you for purchasing this product. To derive optimum performance from the product, please carefully read this manual before use. This manual is applicable to the following products:Packing ListPlease unpack carefully and check that you have received the following items. If any item is missing or damaged, please contact your dealer.No. Item Qty.1 Wireless PTT 12 Charger 13 Owner’s Manual 1
2Product IntroductionProduct LayoutWireless PTTThe Up Key and Down Key can be programmed to Volu m e C o ntro l keys or Channel Selector keys. For details, consult your dealer.Note
3Charger LED IndicatorLED Indication DescriptionBlueFlashes for 4 times The product is being turned on.On The BT is pairing. Flashes twice every 3s The wireless connection is established, but no voice is being transmitted.Flashes once every 1s The wireless connection is established, and voice is being transmitted.Flashes once every 3s The wireless connection is not established.
4LED Indication DescriptionRedFlashes for 4 times The product is being turned off (BT not connected).Flashes 2 times, and then ÀDVKHVWLPHVDIWHUVVWRS The product is being turned off (BT connected).Flashes once every 3s The battery is low. Flashes once every 1s The product is being charged.On The product is transmitting.Green On The product is fully charged. 6SHFL¿FDWLRQVItem 6SHFL¿FDWLRQCommunication Distance 10 mBattery Life (5-5-90 Duty Cycle) 120 hBattery Capacity 33mAhCharging Time 1.5 hDust & Water Protection IP67Operating Temperature –20°C to +60°CStorage Temperature –40°C to +85°C
5Before UseCharging the Product ƔTurn off the product and get it fully charged if it stays idle for a long time. Charge it every three months to prolong its lifespan. ƔTurn off the product before charging; otherwise, it will be reset and turned off automatically.7KH/('LQGLFDWRUÀDVKHVRQFHHYHU\VLQGLFDWLQJWKDWWKHEDWWHU\LVORZ7RFKDUJHWKHSURGXFWGRDVIROORZVCautionNoteAfter the product is fully charged, go through the steps reversely to remove it.
6Wearing the Wireless PTT$GMXVWWKHULQJEHOWWR¿W\RXU¿QJHUDQGZHDULWBasic OperationsTurning the Product On or OffTo turn on the product, press and hold both Up Key and Down .H\VLPXOWDQHRXVO\XQWLOWKH/('LQGLFDWRUÀDVKHVblue rapidly.To turn off the product, press and hold both Up Key and Down .H\VLPXOWDQHRXVO\XQWLOWKH/('LQGLFDWRUÀDVKHVred rapidly.If the product does not establish wireless connection within five minutes, it will be turned off automatically.Note
7NotePairing the ProductThe product can work properly only when it is paired with the wireless audio adapter or the radio with BT module. After initial pairing, whenever you turn on the product, the connection will be automatically established.To enter paring mode: ƔFor Wireless Ring PTT: press and hold both Up Key and Down.H\XQWLOWKH/('LQGLFDWRUÀDVKHVEOXH ƔFor wireless audio adapter or radio with BT module: refer to corresponding User Manual for details.7KH/('LQGLFDWRUÀDVKHVEOXHLQGLFDWLQJWKDWWKHZLUHOHVVFRQQHFWLRQLVHVWDEOLVKHG ƔThe product will exit if the connection is not established three minutes after entering pairing mode. ƔThe product will always pair with the last connected wireless audio adapter or radio. Making a callTo make a call, press and hold the PTT key, and then speak into the microphone on the audio device. Release the PTTNH\ZKHQ¿QLVKHG
FCC Notice: This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ---Reorient or relocate the receiving antenna. ---Increase the separation between the equipment and receiver. ---Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. ---Consult the dealer or an experienced radio/TV technician for help. WARNING: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
IC Notice: This device complies with Canada Industry licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference; and (2) this device must accept any interference. Including interference that may cause undesired operation of the device. Cet appareil est conforme aux CNR exemptes de licence d'Industrie Canada . Son fonctionnement est soumis aux deux conditions suivantes : ( 1 ) Ce dispositif ne peut causer d'interférences ; et ( 2 ) Ce dispositif doit accepter toute interférence , y compris les interférences qui peuvent causer un mauvais fonctionnement de l'appareil. CAN ICES-3 (B) Avis d’Industrie Canada Le présent appareil est conforme aux CNR d'industrie Canada applicables aux appareils radio exem pts de licence L'exploitation est autorisée aux deux conditions suivantes: 1) I'appareil ne doit pas produire de brouillage; et 2) I'utillsateur de I'appareil doit accepterbrouillage radioélectrique subi meme si le brouillage est susceptible d'encompromettre le fonctionnement. mauvais fonctionnement de I'appareil. Cet appareil numériquie de la classe B est conforme à la norme NMB-003 du Canada. CAN NMB-3 (B) Radiation Exposure Statement: This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 0mm between the radiator & your body. Déclaration d'exposition aux radiations: Cet équipement est conforme aux limites d'exposition aux rayonnements IC établies pour un environnement non contrôlé. Cet équipement doit être installé et utilisé avec un minimum de 0mm de distance entre la source de rayonnement et votre corps.
Caution 1.Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the instructions. 3.The max operating of the EUT is 60°C. and shouldn’t be lower than -20°C. 4.The device complies with RF specifications when the device used at 0mm form your body. 5.Declaration of Conformity We, Hytera Communications Corporation Limited hereby, declare that the essential requirements compliance with the Directive 2014/53/EU. have been fully fulfilled on our product with indication below: Product Name: Wireless PTT Brand Name : Hytera Model : POA121 This product can be used across EU member states.

Navigation menu