Hytera Mobilfunk DIB5800 TETRA Digital base station User Manual Part Two

Hytera Mobilfunk GmbH TETRA Digital base station Users Manual Part Two

Contents

Users Manual Part Two

Download: Hytera Mobilfunk DIB5800 TETRA Digital base station User Manual Part Two
Mirror Download [FCC.gov]Hytera Mobilfunk DIB5800 TETRA Digital base station User Manual Part Two
Document ID2768341
Application ID341pYUZyrsOaFI4kaHhEIQ==
Document DescriptionUsers Manual Part Two
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize21.41kB (267635 bits)
Date Submitted2015-09-30 00:00:00
Date Available2016-03-01 00:00:00
Creation Date2015-09-25 08:23:05
Producing SoftwareMicrosoft® Office Word 2007
Document Lastmod2015-09-29 20:49:24
Document TitleUsers Manual Part Two
Document CreatorMicrosoft® Office Word 2007
Document Author: maggie

FCC Warning
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 250cm
between the radiator& your body.
These products can operations in uncontrolled RF exposure Environments.
In order to comply with the FCC RF exposure requirements, the antenna installation must
comply with following:
Users must be fully aware of the hazards of the exposure and able to exercise control over
their RF exposure to qualify for the higher exposure limits.
In order to comply with the FCC RF exposure requirements, the antenna installation must
comply with following:
The base station antenna must be installed so as to provide a minimum separation distance of
250cm between the antenna and persons within the area. This antenna should with gain less
than 8dBi, VSWR≤1.5:1, ZO=50ohms)
IC Warning
This device complies with Industry Canada RSS 119 standard (s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference,including interference that may cause undesired operation of the
device.
Le présentappareilestconforme aux CNR d'IndustrieCanadaapplicables aux appareils radio
exempts de licence.
L'exploitationestautorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareildoit accepter tout brouillageradioélectriquesubi, mêmesi le
brouillageest susceptible d'encompromettre le fonctionnement.
IC Radiation Exposure Statement:
This equipment complies with IC RF radiation exposure limits set forth for an uncontrolled
environment.
This equipment should be installed and operated with minimum distance 250cm between the
radiator & your body.
IC exposition aux radiations:
Cet équipement est conforme avec IC les limites d'exposition aux rayonnements définies pour
un contrôlé environnement.
Cet émetteur ne doit pas être co-localisés ou fonctionner en conjonction avec une autre
antenne ou émetteur.
Cetéquipementdoitêtreinstallé et utilisé avec un minimum de 250cm de distance entre le
radiateur et votre corps.
Any Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
In order to comply with the IC RF exposure requirements, the antenna installation must comply
with following:
The base station antenna must be installed so as to provide a minimum separation distance of
250cm between the antenna and persons within the area. This antenna should with gain less
than 8dBi, VSWR≤1.5:1, ZO=50ohms)

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.5
Linearized                      : No
Tagged PDF                      : Yes
XMP Toolkit                     : 3.1-701
Create Date                     : 2015:09:25 08:23:05Z
Creator Tool                    : Microsoft® Office Word 2007
Modify Date                     : 2015:09:29 20:49:24+08:00
Metadata Date                   : 2015:09:29 20:49:24+08:00
Format                          : application/pdf
Creator                         : maggie
Producer                        : Microsoft® Office Word 2007
Document ID                     : uuid:15b1ea04-fd80-4574-ae94-61d374161b87
Instance ID                     : uuid:798ccd1e-02a6-4913-a5fc-3ee04e5964e7
Page Count                      : 2
Language                        : zh-CN
Author                          : maggie
EXIF Metadata provided by EXIF.tools
FCC ID Filing: ZW4DIB5800

Navigation menu