Hyundai Electronics Co HWT-210 PCS CDMA WLL Phone User Manual Manual

Hyundai Electronics Industries Co Ltd PCS CDMA WLL Phone Manual

Manual

i FCC RF EXPOSURE INFORMATIONIn August 1996 the Federal Communications Commission (FCC) of the United Stateswith its action in Report and Order FCC 96-326 adopted an updated safety standardfor human exposure to radio frequency (RF) electromagnetic energy emitted by FCCregulated transmitters. Those guidelines are consistent with the safety standardpreviously set by both U.S. and international standards bodies. The design of thisphone complies with the FCC guidelines and these international standards.This device was tested for RF exposure compliance with the back of the phone kept3cm (1.2 inches) from the body. To comply with FCC RF exposure requirements, aminimum separation distance of 3cm (1.2 inches) must be maintained between theuser/bystander and the back of the phone, including the antenna.For more information about RF exposure, please visit the FCC website at www.fcc.govWARNING! Read this information before using your WLL
_-., __. ..^.l._- .I _.I--- Contents --1. Before Using...........................................................................21.1 .Checking the Package.....................................................21.2. Name and Function of Each Part...................................31.3. Cautions.........................................................................32. Installation..............................................................................52.1. General Installation........................................................52.2. Installation of Wall Bracket...........................................82.4. Setup for Data Service..................................................11 ..2.4.1 Connection between PC and the WLL terminal...113. How to Use............................................................................113.1. To Make a Call............................................................113.1.1. General................................................................11,3.1.2. Redial Function..................................................123.1.3. End of Digit Function..........................................123.2. To Answer a Call.........................................................123.2.1.. When the subscriber is in on-hook status...........123.2.2. When the subscriber is in off-hook status .12...........3.3. To Adjust Volume. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .... 123.4. To Adjust Signal Sending Stand-by Time after Dialing .133.5.To Adjust Hook Flash Time (Click Time) . . . . . . . . . . . . . . . . . . . .133.6. To Use Data Service. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 133.6.1 Data Service Receiving mode Setup Function . . . . 133.7 To use G3 Fax Service(Optional). . . . . . . . . . . . . . . . . . . . . . . . . .13<Appendix>1. HWT-2 10 Features2. Technical Specification
3) Put Al and A2 parts of the terminal on the screw head and press them down to hold.4) It will be seen as followings after the installation.Screw requiredto fix the bracketto the wall.)Bt The backup battery is built-in within the WLL terminal so that it can operate without externalpower for some time. If the SMPS is removed, the backup battery starts to operate. It can be usedabout 15 hours in stand-by mode and two hours during the call.-9-
_.” .._..- -...-”_. . .I...- .,.-I<Appendix>1. FeaturesGeneralLocal ToneHook Flash OperationUser Control2. Tech&al Specifrca’tionAir InterfaceBattery Back-up- IConnectors for VariousService SupportPhysicalEnvironinentalPower Supply4ccessories- Connection with normal telephone- Line interface capability : 2 wire- 3 LED (Power, Battery, Service)- Wall Mountable- Dial tone- Busy tone- Warning Tone- Last Number Rediai- End of Digit- Received Volume Control : Sstep- Dial Time Control : 4s - 8s- Hook Flash Time(Click Time) Control- Common air interface standard: J-STD-008- Frequency: TX: 1850 - 1910MHxRX: 1930 - 199oMHx- TX Output Power: 316mW(25dBm)- RX Sensitivity: - 104dBm- Vocoder: 8K/13K QCELP8K EVRC- Channel Bandwidth: CDMA 1.25Mhx- Spurious: TX Freq. Band: -61dBm below: RX Freq. Band: -81dBm below- MOD/DEMOD: OQPSK/QPSK- Frequency Accuracy: Fo+/-150Hz- Type: Ni-Cd- Capacity: 8.4@1.7A- Talk Time: 2 Hours- Standby.Time: 20 Hoursi ,. ‘. * ’ . k- RJ-11: standard wire-line telephone: Analog G3 Fax (Optional)- Serial port : Maintenance Purpose: Data Service Purpose ( Internet, .PCFax)- Dimension (DxWxH) : 226xl66x65mm- Weight (including Backup battery): 995g- Operating temperature: -1OOC -‘+50°C- Input Power :llOV-24OV(fzO)AC, 50/6OHx- Output Power: DC lZV@2A- Power Supply- 16 -

Navigation menu