IDT Technology AD932 BLE Dongle User Manual Model AD268
IDT Technology Limited BLE Dongle Model AD268
USERS MANUAL
USB Bluetooth Smart Dongle
Model: AD932
USER MANUAL
EN
OVERVIEW
ESTABLISH CONNECTION
CONNECT TO CONSOLE
Plug our USB Bluetooth Smart Dongle (AD932) into the console’s USB port. The Dongle
automatically runs the program and receives the Bluetooth Smart signal when it has
established connection with the console.
Make sure the plug is intended to be correctly oriented in direction of the Dongle
You may comply the USB Bluetooth Smart Dongle with corresponding software
SPECIFICATION
TYPE
DESCRIPTION
L x W x H
18 x 6.5 x 21 mm
(0.7 x 0.3 x 0.8 inches)
ABOUT OREGON SCIENTIFIC
Visit our website (www.oregonscientific.com) to learn more about Oregon Scientific
products.
For any enquiry, please contact our Customer Services at info@oregonscientific.com.
Oregon Scientific Global Distribution Limited reserves the right to interpret and construe
any contents, terms and provisions in this user manual and to amend it, at its sole
discretion, at any time without prior notice. To the extent that there is any inconsistency
between the English version and any other language versions, the English version shall
prevail.
EU-DECLARATION OF CONFORMITY
Hereby, Oregon Scientific, declares that USB Bluetooth Smart Dongle (model: AD932) is
in compliance with the essential requirements and other relevant provisions of Directive
1999/5/EC. A copy of the signed and dated Declaration of Conformity is available on
request via our Oregon Scientific Customer Service.
FCC STATEMENT
The following information is not to be used as contact for support or sales. Please call our
customer service number (listed on our website at www.oregonscientifific.com), or on the
warranty card for this product for all inquiries instead.
We
Name: Oregon Scientific, Inc.
Address: 10778 SW Manhasset Dr. UNIT B-2 Tualatin,
Or 97062 USA
Telephone No.: 1-800-853-8883
declare that the product
Product No.:AD932
Product Name: USB Bluetooth Smart Dongle
Manufacturer: IDT Technology Limited
Address: Block C, 9/F, Kaiser Estate,
Phase 1, 41 Man Yue St.,
Hung Hom, Kowloon,
Hong Kong
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) This device
must accept any interference received, including interference that may cause undesired
operation.
WARNING Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio / TV technician for help.