IPICO Australia 3271-1 High Performance UHF fixed reader User Manual Exhibit 8b

Exhibit 8b

EXHIBIT 8 - UHF RFID READER USER MANUAL 109 AMENDMENT 1

PAGE 1 OF 2

EXHIBIT 8: USER MANUAL –AMENDMENT 1

High Performance UHF fixed reader

EXHIBIT 8 - UHF RFID READER USER MANUAL 109 AMENDMENT 1

PAGE 2 OF 2

The following new paragraph will be added to the user’s manual of the

Model IP3271 at the next printing and will be applicable to:

· FCC ID Number VHY3271-1

· FCC ID Number VHY3271-2

· FCC ID Number VHY3271-3

Warning: Exposure To Radio Frequency (RF) Radiation

● The radiated output of this device is below the FCC radio frequency exposure limits. Nevertheless, the

device should be used in such a manner that the potential for human contact during normal operation is

minimized.

● The end user must avoid any extended human RF exposure directly in front of the UHF Reader, up to a

distance of 30 cm, when unit is switched on.

● When servicing the equipment and selecting a location for the antennas, it is important to note that a

minimum distance of 30 cm is required between personnel and the IPICO antennas to comply with the radio

frequency exposure limit.

● The antenna used for this transmitter must be installed to provide a separation distance of at least 30 cm

from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.

● The following safety precautions should be observed:

- Do not touch or move the antenna while the unit is transmitting or receiving.

- Do not hold any component containing the radio such that the antenna is very close or

Touching any exposed parts of the body, especially the face or eyes, while transmitting.

- Do not operate the radio or attempt to transmit data unless the antenna is connected; this

behaviour may cause damage to the radio.