Impex Fitness Wm 367 Owners Manual PARTS LIST
Impex-Fitness-Wm-367-Owner-S-Manual impex-fitness-wm-367-owner-s-manual
2015-06-15
: Impex-Fitness Impex-Fitness-Wm-367-Owners-Manual-746867 impex-fitness-wm-367-owners-manual-746867 impex-fitness pdf
Open the PDF directly: View PDF
Page Count: 13
- BEFORE YOU BEGIN...................................................................................…. 1
- IMPORTANT SAFETY NOTICES..................................................................…. 2
- HARDWARE IDENTIFIER.....…....................................................................…. 4
- ASSEMBLY INSTRUCTIONS........................................................................…. 5
- EXPLODED DIAGRAM………………………………………………………………. 10
- PARTS LIST...............................................................................................……. 11
- WARRANTY.................................................................................................…. 12
- ORDERING PARTS.......................................................................................… 12
- ASSEMBLY INSTRUCTION
- A.) Attach the Leg Developer (#7) to the Front Leg (#5). Secure it with one M8 x 3 1/8” Allen Bolt (#32), two Ø 5/8” Washers (#36), and one M8 Aircraft Nut (#41).
- B.) Insert two Foam Tubes (#11) halfway through the holes on the Leg Developer. Push four Foam Rolls (#24) onto the Tubes from both sides.
- C.) Place a Spring Clip (#19) onto the weight post on the Leg Developer.
- A.) Attach the Backrest Supports (#10) onto both ends of the pivot on the Main Seat Support (#3). Place the other end rest against the Backrest Adjustment Bar (#28).
- B.) Place the Backrest Board (#27) onto the Backrest Supports. Secure it with four M6 x 1 ½” Hex Bolts (#34) and Ø ½” Washers (#37).
- C.) Place the Seat Pad (#26) onto the Main Seat Support. Secure it with four M6 x 1 ½” Hex Bolts (#34) and Ø ½” Washers (#37).
- A.) Attach the Arm Curl Pad (#25) to the Arm Curl Stand (#6). Secure it with two M8 x 5/8” Allen Bolts (#31) and Ø 5/8” Washers (#36).
- B.) Insert the Arm Curl Stand into the top opening on the Front Leg. Secure it with a Lock Knob (#13).
- 1 Right Upright Beam 1
- 14 2 3/8” Rubber Bumper 2