InnoSenT IPQ05 Stereo K-Band Transceiver Module User Manual IPQ 05

InnoSenT GmbH Stereo K-Band Transceiver Module IPQ 05

User Manual

Version 1.0 IPQ-05 page 1 of 3 2007-01-24 User Manual Product Family: K-Band Transceivers Stereo K-Band Transceiver with two integrated patch antennas, IF-pre-amplifier and two electronic selectable antenna patterns IPQ-05 Description: - radar-based motion detector centered @ 24.125 GHz - advanced PHEMT-oscillator with low current consumption - split transmit and receive path for maximum gain - stereo (dual channel) operation for direction of motion identification - integrated IF-pre-amplifier - enable input for oscillator shut down - small outline dimensions - two electronic selectable antenna patterns Absolute Maximum Ratings: Parameter Symbol Rating Units supply voltage VCC 5.25 V operating temperature (out of spec) TOP - 40 / + 85 °C storage temperature TSTG + 90 °C Electrical Characteristics: Parameter Symbol min. typ. max. units comment transmit frequency ftransmit 24.075 24.125 24.175 GHz f@room temperature 24.105 24.145 GHz output power (EIRP) Pout 15 20 dBm temperature drift ∆f - 1 MHz/°C antenna pattern Tx (3dB) horizontal 53 ° azimuth vertical 33 ° elevation antenna pattern Tx (10dB) horizontal 130 ° azimuth vertical 60 ° elevation side lobe suppression Tx horizontal 13 dB azimuth vertical 13 dB elevation antenna pattern Rx1 (3dB) horizontal 53 ° azimuth vertical 33 ° elevation antenna pattern Rx1 (10dB) horizontal 130 ° azimuth vertical 60 ° elevation side lobe suppression Rx1 horizontal 13 dB azimuth vertical 13 dB elevation antenna pattern Rx2 (3dB) horizontal 47 ° azimuth vertical 33 ° elevation antenna pattern Rx2 (10dB) horizontal 85 ° azimuth vertical 64 ° elevation side lobe suppression Rx horizontal 13 dB azimuth vertical 13 dB elevation
Version 1.0 IPQ-05 page 2 of 3 2007-01-24 Electrical Characteristics (cont’d): Parameter Symbol min. typ. max. units comment I/Q balance amplitude 6 dB phase 60 90 120 ° IF output voltage offset 1.0 2.2 4.0 V IF-amplifier gain 19 20 21 dB bandwidth DC kHz upper frequency limited by operational amplifier switching voltage high level 2 5.5 V narrow antenna pattern low level GND 0.5 V broad antenna pattern supply voltage VCC 4.75 5.0 5.25 V supply current ICC 35 50 mA operating temperature TOP - 20 + 60 °C outline dimensions ~ 40 x 25 x 24 mm Interface: Pin # Description In/Out Comment 1 enable input active low 2 VCC input supply voltage (+5 V) 3 GND input analog ground 4 IF1 output Signal I(nphase) 5 IF2 output Signal Q(uadrature) 6 not connected mates with: Molex P/N 53014, 53015 and 53025 I/Q Channel: Signal Q is leading if an object moves towards the radar transceiver. I Q
Version 1.0 IPQ-05 page 3 of 3 2007-01-24 Certification and environment protection: InnoSenT GmbH has established and applies a quality system for: Development, production and sales of radar sensors for commercial and industrial sensors An audit was performed, Report No. 010350 Proof has been furnished that the requirements according to DIN EN ISO 9001:2000 are fulfilled. This InnoSenT product is compliant to the restriction of hazardous substances (RoHs – European Union directive 2002/95/EG). FCC approval • This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. • Warning: Changes or modifications made to this equipment not expressly approved by InnoSenT GmbH may void the FCC authorization to operate this equipment. • Manufacturers of mobile or fixed devices incorporating IPQ-05 modules are authorized to use the FCC Grants and IC Certificates of the IPQ-05 modules for their own final products according to the conditions referenced in these documents. In this case, the FCC label of the module shall be visible from the outside, or the host device shall bear a second label stating "Contains FCC ID: UXS-IPQ05" and "Contains IC: 6902A-IPQ05". Contact Information: InnoSenT GmbH Am Roedertor 30 97499 Donnersdorf Germany Phone: +49 (0) 9528-9518-0 Fax: +49 (0) 9528-9518-99 E-Mail: info@InnoSenT.de Web: www.InnoSenT.de

Navigation menu