Intel ND15 XBEE 900 HP User Manual Module installation instruction V3

Module installation instruction V3

Intel Corporation

2200 Mission College Blvd

Santa Clara, CA 95054

Installation Addendum – FCC ID: 2AB8ZND15

This module is approved for use with the antennas described in the Digi manual,

XBee-PRO 900HP/XBee-PRO XSC RF Modules User Guide, page 181, when

installed so that the end device and antennas are a minimum of 20cm from

persons. RF exposure information needs to be included in the end product’s user

manual to ensure installation in accordance with these conditions.

Use in such portable conditions is limited to devices manufactured by Intel or by

ODMs. The device shall be installed onto a ski, snowboard or similar device such

that the device is located at least 39mm from wrists, ankles, feet and

hands. Installation instructions and user information must clearly reflect this and

the instructions must indicate that this separation distance is required to ensure

compliance with RF exposure requirements.

The host equipment into which the module is installed must be labelled with the

following visible to the user:

Contains FCC ID: 2AB8ZND15