Intelyt orporated ITAGV16 Wireless GPS tracking device using 802.15.4 User Manual iTAG QuickStartManual Rev2

iControl Incorporated Wireless GPS tracking device using 802.15.4 iTAG QuickStartManual Rev2

Users Manual

iControlIncorporatedhttp://www.iControl‐Inc.comiTAGModuleIntegratediTAGWithEnclosureiTAGReaderutilizinganInternaliTAGModuleiTAGModuleOperatingManualBackground.TheiTAGis2.4GHzbi‐directionalradiotransceiverthatisintegratedwithaGPSreceiver,motiondetectingsensor,andnon‐volatileflashmemoryfordatastorage.AUsermayconfigurethedevicetooperateasaRadioFrequencyIdentificationDevice(RFID)fortrackingshippingcontainersinaworldwidesupplychainusingtheMarineAssetTagTrackingSystem(MATTS)communicationprotocol.AniTAGmoduleutilizesalowpower,wireless,radiooperatinginthe2.4GHzbandasitsprimarymodeofcommunication.ThewirelessradiooperatesincompliancewithIEEEStandard802.15.4‐2006.TheiTAGGPSreceiverisUserconfigurabletoperiodicallydeterminetheiTAG’sgloballocationusingdatafromtheUSAFGPSconstellation.ThemodulemayoperateasstandalonedeviceormaybeusedasaradioandGPSreceiverforcommunicationdevicesthatareapartoflargesystemsorsecuritydevices.TheUserinterfaceforthemoduleisviaatwenty(20)pinconnectoronthebottomofthemodule.Figure1iTAGDevices
iControlIncorporatedhttp://www.iControl‐Inc.comiTAGRadioOperation.TheiTAGiscontrolledviaaserialportinterfaceforinitialconfigurationandcheckout.AllcommandsforcontrollingtheradioareidentifiedintheiTAGCommandList.OnceaUserascompletedtheinitialiTAGconfiguration,completecontrolandoperationoftheiTAGcanbeaccomplishedthroughtheradiolinkinterfaceusingthesamecommandsavailableintheiTAGCommandList.TheradiointheiTAGisnominallyoperatedinapowersavingmodewiththereceiverperiodicallyenabledand“listening”forcommandsordatarequests.Akeyelementtothepowersavingmodeistheprincipleof“tag‐talks‐last”.Inthismode,batterypowerisconservedbyonlyrespondingtomessagesthataresentdirectlytothespecificiTAGMACaddressormutualbroadcastaddress.ForamajorityofiTAGoperation,theiTAGisinadeeppowersavingmode(~98%ofthetime).TheiTAGwillonlytransmitwhenitreceivesaproperlyencryptedmessageduringitsreceiveractiveperiod.TheencryptedmessagedirectedtotheiTAGmayincludeinformationaboutwhichchanneltheiTAGshoulduseforfurthertransmissions.Once,thecommunicationparametersareexchanged,therewilltypicallybeaperiodaseveralsecondsofactiveradiotransmissionastheiTAGrelaysdata.Thedatatransmittedmayeitherbesecuritydatadestinedforgovernmentservers,and/orcommercialdatadestinedfortheendcustomer.Thisdatamayoriginatefrominternalflashstorageoritmaybereceivedandrelayedfromanothercompatibledevice.OtherComponents.Inadditiontothewirelessradio,severalotherelectronicdevicesareusedbytheiTAG.1. Thelow‐powerGPSreceiverispoweredperiodicallytoreceiveGPSsignals.TheGPSreceiveristypicallypoweredforlessthanoneminuteperhour;howeverthefrequencyofGPSfixesishighlyconfigurabletoaccommodateavarietyofrequirementsandmayvarybasedonotherinputs.2. Alow‐powerMEMSaccelerometerisusedtodetectmotion.Usingapatentpendingprocess,theiTAGutilizethemotiondetectionsensortoestablishifanewGPSfixisrequired.3. Analogsignalsmaybemonitoredtodetectsecurityrelatedinformation(e.g.temperature,enclosurebreach,installationsecurityetc.)4. TwoRS‐232serialUARTsareavailablefortheUsertocommunicatedatatothemodulefromsecondarysystemstotransmitdataviatheradiotransceiver.
iControlIncorporatedhttp://www.iControl‐Inc.comFunctionalBlockDiagram.TheiTAGmoduleintegratesaGPSreceiver,a2.4Ghzradio,andalowpowermicroprocessor.TheiTAGmodulealsoincludesasoftwareUserinterfacethatprovidescommandsforcontrollingtheradiofunctions,sendingdata,retrievingGPSlocation,anduploadingstoreddata.Note:PleaserefertotheiTAGCommandListforacompletelistofoperatingcommandsthatcontroltheiTAGmodule.TheiTAGmoduleisequippedwithanintegratedtraceantennaratedat3.0dBi.MostembeddedmobileapplicationswillutilizetheintegralantennaprovidedwiththeiTAGmodule.Optionally,amicrocoaxconnectormaybeutilizedtoconnectexternalantennatotheiTAGmodule.iControlcanprovideiTAGmoduleswithexternalantennaconnectorsthatarecertifiedandlicensedforexternalantennaoperations.NOTE:Usersmaynotmodifytheantennaorit’sconnectioninanywayorriskviolatingradiolaw.Figure2iTAGBlockDiagram
iControlIncorporatedhttp://www.iControl‐Inc.comAbsoluteMaximumRatings.Undernocircumstancesmusttheabsolutemaximumratingsgivinginthistablebeviolated.Stressexceedingoneormoreofthelimitingvaluesmaycausepermanentdamagetothedevice.Parameter Min Max Units Condition Supply Voltage -0.3 6.0 V All supply pins must have same voltage Voltage on any digital pin -0.3 3.6 V Input RF level 10 dBm Storage temperature range -50 150 C Operating ambient temperature -40 85 C Figure3MaximumRatings
iControlIncorporatedhttp://www.iControl‐Inc.comGeneralCharacteristics.
iControlIncorporatedhttp://www.iControl‐Inc.comiTAGRadioSpecification(Transmit).
iControlIncorporatedhttp://www.iControl‐Inc.comiTAGRadioSpecification(Receive).
iControlIncorporatedhttp://www.iControl‐Inc.comOEMInstallationInstruction:AnOEMintegratorutilizesthe2x10x2mmpinheaderconnectoronthebottomoftheiCHIME.Toapplypower,utilizeserialdata,andconnecttoanaloginterfaces,theOEMmustprovidea2x10x2mmpinsocketontheirintegratingelectronics.InterfaceSpecification.TheinterfacediagramnotedbelowisforthematingconnectorontheUser’selectronics.AllinterfacestotheradioarebufferedtopreventUserinterfaceelectronicsfrominterferingwiththeoperationoftheradio.PIN Name Type Description 1 GND PWR Ground 2 Analog 7 I Analog Channel 7 (0-3.3 V input) 3 Analog 4 I Analog Channel 4 (0-3.3 V input) 4 Analog 6 I Analog Channel 6 (0-3.3 V input) 5 Analog 5 I Analog Channel 5 (0-3.3 V input) 6 VIN PWR 3.3-6.0 V input 7 TXDB Output Serial Port B transmit output (0-3.3V) 8 RXDB Input Serial Port B receive input (0-3.3V) 9 TXDA Output Serial Port A transmit output (0-3.3V) 10 RXDA Input Serial Port A receive input (0-3.3V) 11 P1_1 I/O General Purpose I/O (0-3.3 V input) 12 P1_0 I/O General Purpose I/O (0-3.3 V input) 13 P2_0 I/O General Purpose I/O (0-3.3 V input) 14 PBReset Input Reset Pin, Active low, if not used keep float 15 P2_2 I/O General Purpose I/O (0-3.3 V input) 16 P2_1 I/O General Purpose I/O (0-3.3 V input) 17 Analog 3 I Analog Channel 3 (0-3.3 V input) 18 Analog 0 I Analog Channel 0 (0-3.3 V input) 19 Analog 2 I Analog Channel 2 (0-3.3 V input) 20 Analog 1 I Analog Channel 2 (0-3.3 V input) (TopView)UsersMatingConnectorforiTAGModule
iControlIncorporatedhttp://www.iControl‐Inc.comModuleMechanicalSpecification.TheiTAGmoduleismanufacturedona0.062”thickFR4PCBsubstrate.Therearefour0.10”diametermountingholeswhichmaybeusedtosecurethemoduleinanenclosureortoahostmotherboard.Allradiocomponentsareintegratedunderamechanicallysecure,tamperproofRFshield.TheGPSantennafortheiTAGmoduleisaceramicpatchantennathatislocatedonthetopofthemodule.FornormalGPSoperations,themoduleshouldbeorientedsothattheGPSpatchantennaispointedskyward.iTAGModuleMechanicalDimensions(ininches)
iControlIncorporatedhttp://www.iControl‐Inc.comModuleUniqueAddressIdentification.EachiTAGmoduleisassignedaunique8byteMACaddressbyiControlIncorporated.TheMACaddressisusedforradionetworkaddressidentification.TheMACaddresscannotbemodifiedbytheUserandislocatedinprotectedflashmemory.Figure5depictsthecommunicationprotocolbetweeniControliTAGandtheiGATEreader.Thecommunicationprotocolutilizesaunique8byteMACaddressdefinedbytheIEEE802.15.4standard.InFigure5,TheiTAGaddressis(0x0035A923000000002).TheiGATEaddressis(0x0035A9230A010203)Figure10
iControlIncorporatedhttp://www.iControl‐Inc.com FCCCompliance:This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. Troubleshooting:If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: 1. Reorient or relocate the receiving antenna. 2. Increase the separation between the equipment and receiver. 3. Connect the equipment to an outlet on a circuit different from that to which the receiver is connected. 4. Consult the dealer or an experienced radio/TV technician. Conditions: Operation is subject to the following two conditions: 1. This device may not cause harmful interference 2. This device must accept any interference received, including interference that may cause undesired operation. Markings:TosatisfyFCCexteriorlabelingrequirementsthefollowingtextmustbeplacedontheexterioroftheproduct.ContainsModuleFCCID:FCCID:W2E‐ITAGV16
iControlIncorporatedhttp://www.iControl‐Inc.comFCCWarnings:Modifications: Modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment under FCC Rules. RadioFrequencyExposure:Notes: 1)Formobileorfixedlocationtransmitterstheminimumseparationdistanceis20cm,evenifcalculatorsindicatetheMPEdistanceisless.2)ThisequipmenthasbeenevaluatedinaccordancewiththeFCCbulletin56“Hazardsofradiofrequencyandelectromagneticfields”andbulletin65“Humanexposuretoradiofrequencyandelectromagneticfields.3)Safeoperationinanuncontrolledenvironmentwillresultifthefollowingdistancesfromthedevicearemaintainedasaminimum.

Navigation menu