Intermatic CA3750 Multi-Voltage High Current Contactor Module User Manual CA3750

Intermatic Inc Multi-Voltage High Current Contactor Module CA3750

Exhibit D Users Manual per 2 1033 b3

WARNING:WARNING:Read instructions completely before installation and retain for future reference.This device is not a motor disconnect.with 75°C rated copper or copper clad wire.WARNING:WARNING:OTHER CAUTIONS:For installation and/or use in accordance with appropriate electrical codes and regulations.Consult a qualified electrician for installation and operation.1. For remote operation, use with Z-Wave compatible control for wireless control from any location.2. Disconnect power when servicing or changing load.3. Use this device onlyNote: For independent channel control requires presence of InTouch™ Server (CA5500B or other).Model CA3750Multi-Voltage High CurrentContactor ModuleSpecifications:Ratings:Enclosure:Connections:RF Information:Network Information:Local control via Activator Buttonor Wireless RF Control120, 208, 240, 277VAC, 50/60Hz6600 Watts 30 A Resistive;5500VA 25 A Inductive;5540 Watts 20 A @ 277VAC Ballast;4400 Watts 20 A Tungsten;3HP @ 220VAC MotorNEMA 3R Indoor-OutdoorPolycarbonate Case.1-Neutral/Line 2, 2-Line 1,3&4Contact 1,5&6Contact 2Minimum Range:50ft indoor; 100ft outdoorFrequency: 908.42 MHzMesh Network - Each line powerednode acts as a repeater to routedistant signals.Data Rate: 9600 bits/secondSize: 232 Z-Wave™ NodesOperating Temperature Range:14°F (-10°C) to 140°F (60°C)Power Consumption: 6.0W MaxINSTALLATION:1. WARNING: TO AVOID FIRE, SHOCK, OR DEATH, TURN OFF POWER AT CIRCUIT BREAKER ANDTEST THAT POWER IS OFF BEFORE WIRING.Operation:2. Follow all local electrical and safety codes, National Electric Code (NEC), as well as Occupational Safetyand Health Act (OSHA).3. If the power disconnect point is out of sight, lock it in the “OFF” position and tag it to prevent unexpectedapplication of power.4. Move fused jumper to proper source voltage selection 120, 208, 240, or 277 VAC.5. Set contact selector switch for desired output. (1x DPST or 2x SPST)6. Do not exceed the maximum current carrying capacity of this contactor module.7. Always replace the plastic insulator covering the terminal before turning power “ON”.8. Press activator button repeatedly to cycle contact operation; 2xSPST Mode: OFF:OFF,ON:OFF; DPST Mode: OFF:OFF, ON:ON7. For programming instructions refer to the (158CA12789).InTouch Installer & Users GuideThe CA3750 Multi-Voltage High Current Contactor Module is a Z-wave™ enabled device which isfully compatible with any Z-wave enabled network. Z-wave enabled devices display the Z-wavelogo and guarantee connectivity and interoperability between devices. Each node in a Z-wavenetwork is designed to act as a repeater forming a mesh network eliminating radio “dead spots”and providing the highest level of reliability.- Multiple location ON/OFF control of contactor when used with wireless controls.- Multi-Voltage power supply 120, 208, 240, or 277 VAC- Field configurable outputs 2 independently controllable SPST contacts or simultaneous DPSTcontact operation.- Up-front activator switch always operates load, does not require central control system.Features123456LINELINE/NEUTRALProgramButtonInput / OutputTerminalsStatusLEDSupplyTerminalsThis product is compatible with other Z-Wave enabled products™Providing a Brighter Solution™158CA12473WIRELESS CONTROLSTM
Standard InstallationFCC STATEMENT OF COMPLIANCEWARNING! Changes or modifications not expressly approved by Intermatic Inc. could void the user’s authority to operate the equipment.This device complies with part 15 of the FCC rules. Operation of this device is subject to the following two conditions:(1) This device may not cause harmful interference, and(2) This device must accept any interference, including interference that may cause undesired operation.NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits aredesigned to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radiofrequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there isno guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, whichcan be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:-- Reorient or relocate the receiving antenna or device.-- Increase the separation between the equipment and receiver.-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.-- Consult the dealer or an experienced radio/TV technician for help.123456Line 1Line 2 /NeutralLOADLOAD123456Line 1Line 2 /NeutralUse jumpers onlyif device voltage andoutput voltage arethe same.LOAD LOAD123456Line 1Line 2 /NeutralUse jumpers onlyif device voltage andoutput voltage arethe same.LOAD123456Line 1Line 2 /NeutralLOADThis product is compatible with other Z-Wave enabled products™LIMITED TEN YEAR WARRANTYIf within ten (10) years from date of purchase, this product fails due to a defect in material or workmanship, Intermatic Incorporated will repair or replace, at itssole option. This warranty applies only to the original purchaser and is not transferable. This warranty excludes and this is disclaimed liability for labor forremoval of this product or reinstallation. The warranty does not apply to: (a) damage caused by accident, abuse, mishandling, dropping, acts of God, or anynegligent use; (b) units which have been subject to unauthorized repair, opened, taken apart, or otherwise modified; (c) units not used in accordance withdirections; (d) damages exceeding the cost of the product. Some states do not allow a limitation of damages, so the foregoing limitation may not apply to you.This warranty gives you specific legal rights and you may have other rights that vary from state to state.This warranty service is available by either (a) returning the product to the dealer from whom the unit was purchased, or (b) mailing postage prepaid to thenearest authorized service center listed. Please be sure to wrap the product securely when mailing to avoid shipping damage. This warranty is made by:Intermatic Incorporated, After Sales Service, 7777 Winn Road, Spring Grove, IL 60081-9698, 815-675-7000 www.intermatic.comINTERMATIC INCORPORATED WILL NOT BELIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES. THIS WARRANTY IS IN LIEU OF ALL OTHER EXPRESS OR IMPLIED WARRANTIES.ALL IMPLIED WARRANTIES, INCLUDING THE WARRANTY OF MERCHANTABILITY AND THE WARRANTY OF FITNESS FOR A PARTICULARPURPOSE, ARE HEREBY MODIFIED TO EXIST ONLY AS CONTAINED IN THIS LIMITED WARRANTY, AND SHALL BE OF THE SAME DURATION ASTHE WARRANTY PERIOD STATED ABOVE.Providing a Brighter Solution™WIRELESS CONTROLSTM

Navigation menu