Intermec Technologies 2011B-2 2011B Radio in 700C, 751G, and CN2NI/CN2 User Manual 074759

Intermec Technologies Corporation 2011B Radio in 700C, 751G, and CN2NI/CN2 074759

Users Manual 1

P/N 074759-001 Important WCFS011BEWW 802.11b Radio Information! For Users in the United States and Canada Place this supplement in your manual. For the 802.11b Radio Configuration This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that can cause undesired operation. Federal Communications Commission Compliance FCC Digital Emissions Compliance: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the radio or television receiving antenna. • Increase the separation between the computer equipment and receiver. • Connect the equipment to an outlet on a circuit different from that to which the radio or television receiver is connected. • Consult the dealer or an experienced radio television technician for help.
6001 36th Avenue WestEverett, Washington 98203U.S.A.tel 425.348.2600fax 425.355.9551www.intermec.com© 2004 Intermec TechnologiesCorporation. All rights reserved. Important 802.11b Radio Information! *074759-001* P/N 074759-001 Operation Warning: To comply with the FCC’s RF exposure requirements and minimize health hazards, the user shall not touch the antenna of this device when the device is in use. Changes or modifications not expressly approved by Intermec could void the user’s authority to operate this equipment. Industry Canada Compliance This Class A digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations. This device requires a radio license unless it is used totally inside a building. (The user must obtain this license.) Cet appareil numérique de la classe A respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada. Cet appareil exige une license radio à moins d’être entièrement installé dans un bâtiment. (L’utilisateur doit obtenir cette license.)

Navigation menu