Intermec Technologies 2011B-2 2011B Radio in 700C, 751G, and CN2NI/CN2 User Manual 074759
Intermec Technologies Corporation 2011B Radio in 700C, 751G, and CN2NI/CN2 074759
Contents
Users Manual 1
P/N 074759-001
Important WCFS011BEWW
802.11b Radio Information!
For Users in the United States and Canada
Place this supplement in your manual.
For the 802.11b Radio Configuration
This device complies with Part 15 of the FCC Rules and with RSS-
210 of Industry Canada. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that can cause undesired operation.
Federal Communications Commission Compliance
FCC Digital Emissions Compliance: This equipment has been
tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the radio or television receiving antenna.
• Increase the separation between the computer equipment and
receiver.
• Connect the equipment to an outlet on a circuit different from that
to which the radio or television receiver is connected.
• Consult the dealer or an experienced radio television technician for
help.
6001 36th Avenue West
Everett, Washington 98203
U.S.A.
tel 425.348.2600
fax 425.355.9551
www.intermec.com
© 2004 Intermec Technologies
Corporation. All rights reserved.
Important 802.11b Radio Information!
*074759-001*
P/N 074759-001
Operation Warning: To comply with the FCC’s RF
exposure requirements and minimize health hazards,
the user shall not touch the antenna of this device
when the device is in use.
Changes or modifications not expressly approved by
Intermec could void the user’s authority to operate
this equipment.
Industry Canada Compliance
This Class A digital apparatus meets all requirements of the Canadian
Interference-Causing Equipment Regulations. This device requires a
radio license unless it is used totally inside a building. (The user must
obtain this license.)
Cet appareil numérique de la classe A respecte toutes les exigences du
Règlement sur le matériel brouilleur du Canada. Cet appareil exige
une license radio à moins d’être entièrement installé dans un
bâtiment. (L’utilisateur doit obtenir cette license.)