Intermec Technologies CWAN-RIM902 RADIO MODEM MODULE User Manual compliance insert

Intermec Technologies Corporation RADIO MODEM MODULE compliance insert

compliance insert

Norand Mobile Systems Division, EMC Test Lab FCC ID: EHACWAN-RIM902
DOC. NO.: 577-500-914 REPORT NO: 990824-1
RIM Radio Module FCC SAR Page 1 of 2
APPENDIX E, Declaration of Conformity Insert
Technologies Corporation
Norand Mobile Systems Division
EMC Test Laboratory
MEASUREMENT/TECHNICAL REPORT
Intermec Technologies Corporation
Cellular Radio Module
OEM From RIM 902
REPORT NO: 990824-1
DATE: August 24 , 1999
APPENDIX E
DECLARATION OF CONFORMITY INSERT, USER INFORMATION
Norand Mobile Systems Division, EMC Test Lab FCC ID: EHACWAN-RIM902
DOC. NO.: 577-500-914 REPORT NO: 990824-1
RIM Radio Module FCC SAR Page 2 of 2
APPENDIX E, Declaration of Conformity Insert
Compliance Statement Insert
Device Name: Hand-held Computer Model Number: 6600
The responsible party for the compliance of this device is: Intermec Technologies Corporation
550 Second Street SE
Cedar Rapids, Iowa 52401 USA
(319) 369-3100
CAUTION: See users guide instructions for handling, charging, and replacing batteries. Failure to follow those instructions can
result in personal injury, fire, or battery explosion.
This product conforms to the following approvals. The user(s) of this product are cautioned to use accessories and peripherals
approved by Intermec Technologies Corporation. The use of accessories other than those recommended or changes to this
product that are not approved by Intermec Technologies Corporation may void the compliance of this product and may result in
the loss of the users authority to operate the equipment.
WARNING: Per the FCC RF exposure requirements, the user shall not touch the antenna while the transceiver is in use.
FCC Digital Emissions Compliance
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
Reorient or relocate the radio of television receiving antenna.
Increase the separation between the computer equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the radio or television receiver is connected.
Consult the dealer or an experienced radio television technician for help.
Canadian Digital Apparatus Compliance
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.
Telephone Installation Warning Notices
The following notices apply to equipment that may be connected to telephone lines or systems. For your personal safety, and to protect this equipment
from potential electrical or physical damage, do NOT connect equipment to telephone lines or data communication equipment unless the following
warnings have been read, understood, and complied with.
Never install telephone wiring during a lightning storm.
Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.
Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface.
Use caution when installing or modifying telephone lines.
Avoid using telephone (other than cordless type) during an electrical storm. There may be a remote risk of electric shock from lightning.
Do not use the telephone to report a gas leak in the vicinity of the leak.
Installation do téléphone : avertissements
Les avertissements qui suivent s'appliquent à tout équipement qui peut être branché aux lignes ou systemes téléphoniques. Pour votre sécurité
personnelle et pour protéger l'équipement de tout dommage électrique ou physique potentiel, NE PAS brancher un ordinateur tablette électronique ou ses
périphériques aux lignes téléphoniques ou équipements avant que les avertissements suivants aient été lus, compris et observés:
Ne jamais installer de câblage téléphonique pendant un orage électrique.
Ne jamais installer de prise téléphonique dans un endroit humide à moins que la prise ait été spécifiquement conçue pour être utilisée dans les
endroits humides.
Ne jamais toucher les fils de téléphone ou de l'équipement terminal non isolés à moins que la ligne téphonique n'ait été débranchée de
l'interface réseau.

Navigation menu