Intermec Technologies RFID915PCC-6 RF Identification PC Card User Manual 041116F1 User Info

Intermec Technologies Corporation RF Identification PC Card 041116F1 User Info

User Info and Compliance Statement

Intermec Technologies Corporation   EMC Test Laboratory   FCC ID: EHARFID915PCC-6 IM3 C2PC, 15.247, RSS-210, RSS-102 APPENDIX F, User Information      Technologies Corporation EMC Test Laboratory Cedar Rapids, IA MEASUREMENT/TECHNICAL REPORT  Intermec Technologies Corporation  IF6 RFID Transmitter  FCC ID: EHARFID915PCC-6 (IC: 1223A-RFIDPCC6)  REPORT NO: 041116-1  DATE: November 16, 2004  Appendix F   USER INFORMATION  Page 2  IF6 Regulatory Compliance Information Insert                DOC. NO.: 577-501-207 REPORT NO: 041116-1Page 1 of 2
578-100-0xx   Revision C    Page 1 of  1  *578-100-0xx*   *578-100-0xx* Compliance Statement Insert  Device Name:  RFID Reader  Model Number:  IF6  The responsible party for the compliance of this device is:  Intermec Technologies Corporation  6001 36th Avenue West   Everett, WA  98203  USA  (425) 348-2600  This product conforms to the following approvals.  The user(s) of this product are cautioned to use accessories and peripherals approved by Intermec Technologies Corporation.  The use of accessories other than those recommended or changes to this product that are not approved by Intermec Technologies Corporation may void the compliance of this product and may result in the loss of the users authority to operate the equipment.  This device complies with Part 15 of the FCC rules.  Operation is subject to the two following conditions:  (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.  FCC Digital Emissions Compliance  Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules.  These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.  This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.  Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. Canadian Digital Apparatus Compliance   This Class A digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.     Cet appareil numérique de la classe A respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.   WARNING:  per the FCC and Canada RF (radio frequency) exposure requirements,  (1) The IF6 antenna must be installed as recommended by Intermec Technologies to ensure compliance to RF exposure requirements.  Correct antenna mounting is fully described within the Intermec IF6 Users Guide. (2) When installing and using Intermec Technologies the IF6 RFID tag reader, a 20-cm (8-inch) passing distance must be maintained from any body part of the user or near by persons and the antenna.  The antenna must not be touched during transmitter operation.  (3) RF safety requirements mandate this device cannot be co-located with other transmitters.  WARNING: Canada procedures defined in RSS-210 "The installer of this radio equipment must ensure that the antenna is located or pointed such that it does not emit RF field in excess of Health Canada limits for the general population; consult Safety Code 6, obtainable from Health Canada’s website www.hc-sc.gc.ca/rpb"       DOC. NO.: 577-501-207 REPORT NO: 041116-1Page 2 of 2

Navigation menu