Intermec Technologies RFID915PCC-6 RF Identification PC Card User Manual OK

Intermec Technologies Corporation RF Identification PC Card OK

User Manual Supplement

578-100-0xx Revision C Page 1 of 1*578-100-0xx* *578-100-0xx*Compliance Statement InsertDevice Name: RFID Scanner for Hand-held Computer Model Number: IP3The responsible party for the compliance of this device is: Intermec Technologies Corporation6001 36th Avenue WestEverett, WA 98203 USA(425) 348-2600CAUTION: See users guide instructions for handling, charging, and replacing batteries. Failure to follow those instructions canresult in personal injury, fire, or battery explosion.This product conforms to the following approvals. The user(s) of this product are cautioned to use accessories and peripheralsapproved by Intermec Technologies Corporation. The use of accessories other than those recommended or changes to this productthat are not approved by Intermec Technologies Corporation may void the compliance of this product and may result in the loss ofthe users authority to operate the equipment.FCC Digital Emissions ComplianceThis equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits aredesigned to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radiofrequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However,there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or televisionreception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of thefollowing measures:• Reorient or relocate the radio of television receiving antenna.• Increase the separation between the computer equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to which the radio or television receiver is connected.• Consult the dealer or an experienced radio television technician for help. Canadian Digital Apparatus Compliance This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations. Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada. This device complies with part 15 of the FCC and Industry Canada Rules. Operation is subject to the following two conditions: (1) This device may notcause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.INTERMEC RFID Scanner IP3 UsersWARNING! RF (Radio Frequency) Exposure Regulations for United States and Canada.(1) Only the antenna supplied and installed with this unit by Intermec Technologies is to be used with this scanner. The product isconfigured to ensure compliance to RF exposure requirements.(2) The user shall not touch the scanner front (antenna) during operation. Proper use of the scanner should direct the antennatoward items to be scanned. A 20-cm (8-inch) passing distance must be maintained from any body part of the user or near bypersons and the scanner antenna.(3) RF safety requirements mandate this device can only be co-located with transmitters approved for the Intermec 700.

Navigation menu