JET OPTOELECTRONICS ATK2010AXX ACTIVE RES MONITOR-10.1 STD-BLACK User Manual MANUAL

JET OPTOELECTRONICS CO.,LTD. ACTIVE RES MONITOR-10.1 STD-BLACK MANUAL

MANUAL

ATK2010Rear Seat Entertainment SystemOwners Manual
ATK2010 Owners ManualEnglishEnglish22015 Atom Enterprises, Inc. All rights reserved. This manual, or any portion thereof, may not be reproduced without the express written consent of Atom Enterprises, Inc.For any questions, please call customer service (855) 574-2866www.atomenterprisesinc.com
ATK2010 Owners ManualTable of ContentsEnglish3General information 4Safety instructions 4General Characteristics 4Cleaning and care 4Supported media 5Country codes 5Front panel control buttons 6Inputs/outputs 7Remote control 8-9Wireless IR headphones 10How to identify Monitor A/B 10OperationPlaying a disc 11Playing media via wireless display (miracast/DLNA) 11Playing media via AUX input 11Playing media via USB 11Playing media via HDMI/MHL input 11FM Transmitter function 11Sharing media between monitors 12Setup Main menus 13Troubleshooting 14Compliance information 14-16Specifications 16
English4General InformationPlease read this instruction manual carefully. Poor road conditions can cause problems with some media playback. In cold environments, the screen may sometimes display distortion. This is normal. Safety InformationFor safety reasons, it is recommended that media is only changed when vehicle is stationary. Children should not be permitted to unfasten their seatbelt to function the system/change media. System can be functioned using the remote control with seatbelts fastened. The use of headphones at high volume can cause permanent damage to hearing. To avoid hearing damage, set the volume to low before using them. It is unlawful, in most jurisdictions, and unsafe to drive a motor vehicle which is equipped with a video display that is visible, directly or indirectly, by the driver while moving. This system should never be installed where visible by the driver. General Characteristics•10.1” LED LCD display•1024 x 600 Resolution•Slot load DVD player•USB 2.0/2 amp charge•Miracast/DLNA (wireless connection to smartphone, etc)•Front capacitive touch controls•Support IR headphones/remote control•Analog A/V input-1/8” Jack•Stereo headphone output-1/8” Jack•FM Transmitter (88.5-107.5 MHZ)CautionDo not operate the system without the vehicle running, as it may cause the battery to drain. Please make sure the system is turned off when the vehicle is not running. Cleaning and CareClean your rear seat entertainment system with a soft, dry cloth. For stubborn deposits, a mild cleaning agent may be used. Wipe off and finish with a dry cloth. Please note that strong cleaning agents, such as alcohol, thinners, benzene, insecticides, may cause damage to the system and should never be used.
English5Supported MediaSupported disc mediaBefore inserting media, ensure that it is compatible with the system. Please note that the following data media is NOT compatible with the system:•Optical data media (CD-1, CD-ROM, DVD-ROM)•Mini discDisc types that are compatibleSupported USB media filesMP3,WMA,OGG,MPE,MPG,MPEG,AVI,DIV,VID,VOB,JPG,JPEG, AAC, M1V, M2V, OGM. Supported HDMI/MHL input•HDMI media from any HDMI output Device•HDMI media from MHL compatible device (ie: MHL compatible smartphone, MHL compatible tablet, etc) NOTE: only certain devices are MHL compatible and may require special cables/adapters (please check with the device manufacturer)Symbol Disc TypeVideo DVDAudio CD (ie: CD-R with MP3, MPEG, WMA, or JPG files)Video CDRegion Countries in this region1 Canada, USA, US territories2 Japan, Europe, South Africa, Middle East (including Egypt)3 South East Asia, East Asia (including Hong Kong)4 Australia, New Zealand, Pacific Islands, Central America, Mexico, South America, Carribean5 Former Soviet Union, (alsoNorth Korea, Mongolia), Indian subcontinent, Africa6 ChinaCountry code restrictionsIf the country code on a DVD disc does not match the system country code, the DVD cannot be played.
Panel Control Buttons/Disc slotEnglish62 34 11. Power button-turns system power on/off.2. Source button-select media source for playing media (ie:DVD, AV input, MHL/HDMI, Wireless screen mirroring, USB)3. Play/Pause-starts/pauses media source selected.4. Stop-stops media that is playing.5. Eject-ejects disc5
English7Inputs/Outputs15341. HDMI input (MHL compatible)2. USB 2.0 input (2 amp charging)3. Headphone jack output (wired)4. A/V input jack (analog 3.5MM)5. Disc slot2
Remote ControlButtons/FunctionsTo control monitor A, press the A button first. To control monitor B, press the B button first. (SEE WIRELESS HEADPHONE DETAIL PAGE FOR MORE INFO)123456789101112131415161718192021221. POWER - turns power on/off2. UP - navigate selection up3. LEFT - navigate selection left4. ENTER - accepts selection5. FM - turns FM transmitter on/off(station can also be changed when button is depressed) **Function is for Monitor A only. 6. PLAY - select to play media7. REVERSE - reverses play (fast)8. PREVIOUS - selects previous track9. STOP - stops media from playing10. A- depress to control A monitor11. HOME – back to home page12. MENU – back to home page13. EJECT - ejects disc 14. RIGHT - navigate selection right15. DOWN - navigate selection down16. DVD MENU - displays DVD “ROOT MENU”17. FORWARD - plays media fast forward18. PAUSE - pauses media being played19. NEXT - selects next track20. B- depress to control B monitor21. BACK – back to previous page22. SEARCH – back to home page8English
Remote Control Battery Installation/OperationEnglish9TAB1. Remove battery cover by depressing tab (in direction of arrow) then lifting cover.2. Insert 2 AAA batteries (make sure batteries are installed with correct polarity (+/-)3. Reinstall battery cover! NOTE: There is risk of fire if batteries are not handled correctly. Do NOT recharge batteries. Do NOT intermix different battery types, or batteries not charged the same amount. Please dispose of batteries per local laws. Please keep batteries out of reach of children.OperationTo control monitor A, press the A button first. To control monitor B, press the B button first (SEE HEADPHONE DETAIL PAGE FOR MORE INFO)Remote control has an infrared beam, which must be aimed towards the lower area of the display monitor being controlled. Monitor will not receive remote signal if beam is blocked.
Wireless Headphones10Headphones are dual channel (A and B channel) infrared wireless. Channel must be selected to match the display monitor being viewed (see below) Headphones must be in line of sight of display monitor to receive audio signalHeadphones require (2) AAA batteries.NOTE: Please make sure volume control is set to low for the safety of the next user (excessive volume can cause permanent damage)Please note: headphones will power off automatically if no audio is played for more than 3 minutes. This is so the batteries aren’t drained. In the event this happens, just turn the switch off then on. Volume controlPower on/off switchChannel A/B selection switchBattery cover (depress and slide down to remove)Monitor “A/B” identification locationFollow menu sequence below:Audio>IR transmitter (Monitor “A” or “B” will be shown)NOTE: BE CAREFUL, AS MONITOR CAN BE CHANGED IN THIS MENU IF MONITOR IS SELECTED
11Operating InstructionsTurning power onTurn vehicle ignition “ON/ACC”.Press power button on RSE front panel or remote control.Playing a DiscInsert a disc (label side facing towards you)Make sure DVD –Disc is the selected source. Press play to start media.Playing media from USBInsert USB device into USB slot on right side of unit. Make sure USB is the selected source. Use navigation buttons on remote to control media files.Playing media from AUX inputPlug small male end of AV cable in to 3.5mm AV input on right side of unitPlug other jack ends (RCA type) into device to be played. Make sure AUX is the selected source. Play device per device instructions. Playing media from Wireless Display-may be optional (screen mirroring from smartphone, etc)Select “Wireless Display” from source menu. Follow screen mirroring instructions on smartphone/device to play media from.Playing media from HDMI/MHL inputPlug HDMI cable connector into HDMI jack on right side of unit. Plug other end of cable into device to be played. Make sure MHL/HDMI is selected source.Play device per device instructions. NOTE: only devices with MHL or HDMI output capability can be used. Playing audio through vehicle radio system (only plays from Monitor A)Depress FM on the remote control (if FM button is depressed again, it will turn off the FM transmitted)Use the left/right navigation buttons to select desired radio station to play audio (88.5MHZ ~ 107.5MHZ ) Tune vehicle radio to station selected on unit. NOTE: Quality of audio may be affected by station selected. Certain radio stations may not be clearly audible when FM transmitter is turned on.
12Sharing media from monitor A to monitor BMake sure media is playing on monitor A, then follow the menu sequence below on monitor B:Input source>MonitorMonitor B will display whatever is playing on monitor ASharing media from monitor B to monitor AMake sure media is playing on monitor B, then follow menu sequence below on monitor A:Input source>Monitor
13Main MenusBelow are all the main menus. Menus can be found by selecting the “source” button, on remote, then use the left/right navigation buttons to locate desired menu. Input source Menu (default home page)Contains list of sources for playing media (note: wireless display may be optional)Picture MenuContains list of controls for picture settingsAudio MenuContains list of controls for audio settings, including FM Transmitter (to play audio through vehicle FM radio)DVD MenuContains list of controls for disc player (note: disc must be inserted for menu to appear)
English14Trouble shootingUnit will not power on1. Be sure vehicle is turned onRemote control not working1. Check batteries for correct installation and make sure they have plenty of charge left. 2. Make sure correct monitor is selected on the remote for the monitor desired to be controlled (monitor A/B)3. Be sure remote is aimed directly towards top of monitor being controlled with no obstructions. No picture1. Ensure correct source is selected (ie: DVD, USB, etc)2. Ensure any external devices are correctly connected (ie: cable/s for AUX input , USB, etc)No sound through IR headphones1. Check batteries for correct installation and make sure they have plenty of charge left. 2. Check to make sure channel selected on headphones matches the monitor being watched (A or B. see headphone instruction page for more details)3. Be sure headphones are in line of sight of display monitor being watched with no obstructions. FCC declarationThis system complies with FCC directive, section 15. System is subject to the following 2 conditions:1. This system must not cause any harmful interference2. This system may be subject to interference which may cause unwanted operation. FCC warning1. In order to ensure ongoing FCC compliance, the system must be connected and operated with the supplied cables only. 2. Unauthorized modifications or alterations to the system may void this operating permit. FCC noticeNotice : The changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. To comply with the FCC RF exposure compliance requirements, no change to the antenna or the device is permitted. Any change to the antenna or the device could result in the device exceeding the RF exposure requirements and void user’s authority to operate the device.
English15WEEE directiveDisposal of old electrical and electronic equipment (applicable in the European Union and other European countries with separate collection systems)This symbol on the product or it’s packaging indicates that the device must not be treated as household waste. Instead, it must be handed over at the relevant collection point for the recycling of old electrical and electronic equipment. With correct disposal of the device, you are helping to avoid any negative effects on the environment and human health which might otherwise be caused by the incorrect disposal and treatment of waste. The recycling of materials helps preserve natural resources. You can obtain more information about recycling this device from your city council, your disposal company for household waste, or from the store in which you bought it. Applicable accessories: remote control, headphones. SpecificationsPanel size 10.1”Resolution 1024 x 600Backlight LEDRatio 16:9Luminance 500 NIT (typ.)Expectedbacklight life20k hours Min.Operation temperature-20~70 degrees CStorage temperature-30~80 degrees CVideo display systemNTSCInput voltage 10-16VDCI/O ports USB 2.0, HDMI, 3.5mm AV, 3.5mm earphoneIR Channels A monitor: 2.3/2.8mhzB monitor:3.2/3.8mhzSupported formatsMP3,WMA,OGG,MPE,MPG,MPEG,AVI,DIV,VID,VOB,JPG,JPEGAAC, M1V, M2V,OGM Part# ATMAN2010A

Navigation menu