JSW Pacific CCD-625S CCD-625 Wireless Color Monitoring System User Manual UserManual 625R 725S Content P7 ai
JSW Pacific Corporation CCD-625 Wireless Color Monitoring System UserManual 625R 725S Content P7 ai
Part 1
Model No.: CCD-625
2.4 GHz Wireless Color 2.5" TFT Monitoring System
Contents
Important Safety Precautions ..................................1
Specifications ............................................................2
Parts Included with This System .............................3
Parts of the Wireless Monitoring System ...............3
- Parts of the Camera ...............................................3
- Parts of the Monitor ................................................3
Installation .................................................................4
- Installing the Mounting Bracket
(Camera Stand) .....................................................4
- Installing and Aligning the Camera
on the Mounting Bracket (Camera Stand) .............4
- Installing or Replacing Batteries in the Camera .....4
- Installing the Wireless Monitoring System .............5
Rotating the Antenna for Best Performance .........6
Monitor to A/V Function ............................................6
Troubleshooting Guide .............................................7
Warranty .....................................................................7
You should...
1. Check that the power cord(s) is properly connected.
2. Check that the monitor is turned ON.
3. Wrong AC/DC adapter used. Check that the adapter labeled
OUTPUT: 10V DC is connected to the camera, and adapter
labeled OUTPUT: 5V DC is connected to the monitor.
1. Check the channel switch settings on the camera(s) and
monitor. Make sure the channels match on both units.
2. Signal interference from a microwave oven. Check if a
micro-wave oven is in use or located in the path between
the camera and monitor. If so, turn it off or move it out of
the path.
3. Signal interference from other signal producing devices.
(a) Change the channel setting on both camera and monitor.
(b) Identify and eliminate the source of the interference.
(c) Relocate the camera and/or monitor closer to each other.
4. Camera and monitor are too far apart. Relocate the camera
and/or monitor
5. Antenna is positioned improperly. Adjust the antenna on the
camera and/or monitor.
Troubleshooting Guide
If the Camera
and/or Monitor...
No Power
No sound or picture.
Distorted sound or
picture
7
1 Year Limited Warranty:
JSW Pacific Corp., the maker of Navigator brand products, warrants that for a period of 1 year from
the date of purchase, this product will be free from defects in material and workmanship. JSW, at its
option, will repair or replace this product or any component of the product found to be defective during
the warranty period. Replacement will be made with a new or remanufactured product or component.
If the product is no longer available, replacement may be made with a similar product of equal or
greater value. This is your exclusive warranty.
This warranty is valid for the original purchaser from the
date of initial purchase with JSW and is not transferable.
This warranty does not cover normal wear of
parts or damage resulting from any of the following: negligent use or misuse of the product, use on
improper voltage or current, use contrary to the operating instructions, disassembly, repair or alteration
by anyone other than JSW or an authorized service center. Further, the warranty does not cover acts
of God, such as fire, flood, hurricanes and tornadoes or any batteries that are included with this unit.
JSW
shall not be liable for any incidental or consequential damages caused by the breach of any
express or implied warranty.