JVC KENWOOD 701349 A/V Remote Control TX User Manual IOM701349A

JVC KENWOOD Corporation A/V Remote Control TX IOM701349A

Exhibit A Users Manual

Kenwood/RC-R1110 EXHIBIT A
FCC ID: IOM701349
EXHIBIT A
[FCC Ref. 2.1033(b)(3)]
"Installation and Operating Instructions Furnished to the User"
B60-4502-00 00 CH (K, M, T, X) 9912
VR-4900/VR-4700
KRF-V9993D
OC
5252
Specifications
Chapter Four : Warnings and Specifications
Frequency Response (IHF’78)
CD1...........................................5 Hz ~ 80 kHz, +0.5 dB, -3 dB
Signal to Noise Ratio (IHF ‘66)
Phono (MM) ................................................................... 77 dB
CD1................................................................................... 90 dB
Input Sensitivity / Impedance
Phono (MM) .................................................... 2.5 mV / 47 k
CD1.................................................................. 200 mV / 47 k
Output Level / Impedance
Tape Rec ........................................................... 200 mV / 220
Pre Out (Front, Center, Surround, Subwoofer)....... 1 V / 1 k
Tone Control
Bass ............................................................. + 7 dB (at 100 Hz)
Treble .......................................................... + 7 dB (at 10 kHz)
Loudness Control
Volume at -40 dB level......... +7 dB (100 Hz), +4 dB (10 kHz)
Digital Audio Section
Sampling Frequency ............................ 32 kHz, 44.1 kHz, 48 kHz
Input Level / Impedance / Wavelength
Optical ......................... -15 dBm ~ -21 dBm, 660 nm +30 nm
Coaxial.............................................................. 0.5 Vp-p / 75
Chapter Four: Warnings and Specifications
Read this page carefully to ensure safe operation.
VR-4900 (for U.S.A. and Canada only) /
KRF-V9993D (for U.K. only) Specifications
Audio Section
Rated Output Power during stereo operation
100 watts per channel minimum RMS, both channels driven,
at 6 from 20 Hz to 20 kHz with no more than 0.03% total
harmonic distortion (FTC).
Effective Output Power during surround operation
Front
1 kHz, 0.06 % T.H.D. at 6 , one channel driven
..........................................................................130 W + 130 W
Center
1 kHz, 0.06 % T.H.D. at 6 , one channel driven ........ 130 W
Surround
1 kHz, 0.06 % T.H.D. at 6 , one channel driven
..........................................................................130 W + 130 W
Total Harmonic Distortion............... 0.004 % (1 kHz, 50 W, 6 )
Warnings
FCC WARNING
This equipment may generate or use radio frequency
energy. Changes or modifications to this equipment
may cause harmful interference unless the modifica-
tions are expressly approved in the instruction manual.
The user could lose the authority to operate this equip-
ment if an unauthorized change or modification is
made.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device, pur-
suant to Part 15 of the FCC Rules. These limits are de-
signed to provide reasonable protection against harmful
interference in a residential installation. This equipment
may cause harmful interference to radio communica-
tions if it is not installed and used in accordance with
the instructions. However, there is no guarantee that in-
terference will not occur in a particular installation. If
this equipment does cause harmful interference to ra-
dio or television reception, which can be determined by
turning the equipment off and on, the user is encour-
aged to try to correct the interference by one or more of
the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
the receiver.
Connect the equipment into an outlet on a cir-
cuit different from the one that the receiver is
connected to.
Consult the dealer or an experienced radio/TV tech-
nician for help.
FCC Compliance Notice
Audio-video Receiver, VR-4900 and VR-4700
These devices comply with Part 15 of FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause un-
desired operation.
KENWOOD U.S.A. CORPORATION
2201 East Dominguez St., Long Beach, CA 90801-5745
Telephone: 310-639-9000
IC(Industry Canada) Notice
Operation is subject to the following two conditions:
(1) This device may not cause interference, and (2)
this device must accept any interference, including
interference that may cause undesired operation of the
device.
Note to CATV System Installer:
This reminder is provided to call the CATV system
installer’s attention to Article 820-40 of the NEC that
provides guidelines for proper grounding and, in par-
ticular, specifies that the cable ground shall be con-
nected to the grounding system of the building, as
close to the point of cable entry as practical.
NOTE: Do not use contact cleaning agents because
they could cause a malfunction. Be especially careful
not to use contact cleaning agents containing oil, since
they may deform the plastic components.

Navigation menu