JVCKENWOOD 701312 User Manual IOM701312A
JVC KENWOOD Corporation IOM701312A
Exhibit A Users manual
EXHIBIT A [FCC Ref. 2.1033(b)(3)] "Installation and Operating Instructions Furnished to the User" Kenwood/RC-R0911 FCC ID: IOM701312 EXHIBIT A VR-4090/VR-4080 KRF-V7773D B60-4487-00 00 CH (K, P, M, X, Y) OC 9912 Chapter Three : Warnings and Specifications Chapter Three: Warnings and Specifications Read this page carefully to ensure safe operation. Warnings FCC WARNING This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made. • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and the receiver. • Connect the equipment into an outlet on a circuit different from the one that the receiver is connected to. • Consult the dealer or an experienced radio/TV technician for help. Audio-video Receiver, VR-4090 and VR-4080, and Remote Controller, RC-R0911 These devices comply with Part 15 of FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. KENWOOD U.S.A. CORPORATION 2201 East Dominguez St., Long Beach, CA 90801-5745 Telephone: 310-639-9000 VR-4090 Specifications Audio Section Rated Output Power during stereo operation 100 watts per channel minimum RMS, both channels driven, at 6 Ω from 20Hz to 20kHz with no more than 0.05% total harmonic distortion (FTC). Effective Output Power during surround operation Front 1kHz, 0.09% T.H.D. at 6Ω, one channel driven ......................................................................... 100W + 100 W Center 1kHz, 0.09% T.H.D. at 6Ω, one channel driven .......... 100W Surround 1kHz, 0.09% T.H.D. at 6Ω, one channel driven .......................................................................... 100W + 100W Total Harmonic Distortion .................. 0.007% (1kHz, 50 W, 6Ω) IC(Industry Canada) Notice Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Frequency Response (IHF’78) CD ................................................. 5Hz~90kHz, +0.5dB, -3dB Note to CATV System Installer: This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical. Output Level / Impedance Tape Rec .......................................................... 200mV / 2.2kΩ Pre Out (Front, Center, Surround, Subwoofer) ....... 1V / 1kΩ NOTE: Do not use contact cleaning agents because they could cause a malfunction. Be especially careful not to use contact cleaning agents containing oil, since they may deform the plastic components. 45 Signal to Noise Ratio (IHF ‘66) Phono (MM) .................................................................. 75dB CD .................................................................................... 93dB Input Sensitivity / Impedance Phono (MM) .................................................... 2.5mV / 47kΩ CD ................................................................... 200 mV / 47kΩ Tone Control Bass ............................................................. + 7dB (at 100Hz) Treble .......................................................... + 7dB (at 10kHz) Loudness Control Volume at -40dB level ............ +7dB (100Hz), +4dB (10kHz) Digital Audio Section Sampling Frequency .............................. 32kHz, 44.1kHz, 48kHz Input Level / Impedance / Wavelength Optical ............................. -15dBm~-21dBm, 660nm +30nm Coaxial .............................................................. 0.5Vp-p / 75Ω Specifications NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment may cause harmful interference to radio communications if it is not installed and used in accordance with the instructions. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: FCC Compliance Notice
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.3 Linearized : No Creator : .橡.Microsoft Word Create Date : 2000:01:18 14:35:08 Title : .橡.IOM701312A.PDF Author : .橡.s872605 Producer : Acrobat PDFWriter 4.0 Windows Modify Date : 2000:01:18 14:37:43+09:00 Page Count : 3EXIF Metadata provided by EXIF.tools