Jack Lalannes Power Juicer Classic Operating Manual PJ NEWest Instructions
2015-05-12
: Jack-Lalannes-Power-Juicer Jack-Lalannes-Power-Juicer-Power-Juicer-Classic-Operating-Manual-715988 jack-lalannes-power-juicer-power-juicer-classic-operating-manual-715988 jack-lalannes-power-juicer pdf
Open the PDF directly: View PDF 
.
Page Count: 7
| Download | |
| Open PDF In Browser | View PDF |
OPERATING MANUAL TABLE OF CONTENTS IMPORTANT SAFEGUARDS READ THESE SAFEGUARDS CAREFULLY BEFORE USING THIS PRODUCT! 3 4 5 6 8 9 10 2 Important Safety Information When using electrical appliances, basic safety precautions should always be followed including the following: • NOT FOR USE BY CHILDREN! Keep out of the reach of children to avoid injury. This appliance is not a toy. • Consult your physician before giving fresh juice to children, especially infants. • Be sure to turn to OFF position after each use of your juicer Helpful Hints • Make sure the lid is attached properly and securely locked before operating the Power Juicer. • Do not unfasten the locking bar during operation. • To avoid risk of injury keep hands and utensils out of the juicer and away from its sharp blade during operation. Parts List • Use the pusher, not fingers or utensils, to propel the food into the juicer. • Should food become lodged in the opening use pusher to push it down. If food remains stuck, turn the power off, wait until motor stops, unit shuts down completely, and is unplugged before disassembling the juicer and removing the blocked food. • Make sure the motor stops completely and the unit is unplugged from the electrical outlet before cleaning, putting on or removing parts. Assembly • To protect against risk of electrical shock or injury, never immerse power cord, plug, or main unit in water, or other liquids. • If juicer stops due to improper operation or if there is excessive noise, turn power off, wait for blade to stop spinning, unplug from electrical outlet, disassemble and clean all components then reassemble machine. • Do not use outdoors. Disassembly • Do not operate this or any appliance with a damaged cord or plug. • Do not operate if appliance malfunctions, is dropped or damaged in any manner. Let a qualified appliance repair person examine and or repair appliance before using. • To avoid electric shock or serious injury do not use any attachments that were not recommended or sold by the manufacturer. Cleaning Your Power Juicer • Do not let power cord hang over the edge of table, counter, or let cord touch hot surfaces such as stoves. • To reduce the risk of injury, never place blade on base without properly assembling the unit. Troubleshooting • This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not modify or force the plug in any way. • The motor will not run if unit is not properly assembled. The motor has a built-in safety feature that will not let the power turn on unless the locking bar is locked in place. SAVE THESE INSTRUCTIONS 3 PARTS LIST ADDITIONAL SAFEGUARDS The Power Juicer has a thermal cut-off safety feature. If the unit accidentally overheats, it will stop working temporarily until the Power Juicer cools down. Afterwards, the unit will continue to work again normally. In the event the Power Juicer is jammed the motor may shut down. If this occurs the juicer should be shut off and unplugged. The unit should be thoroughly cleaned to remove the obstruction. The thermal cut-off safety feature is designed to shut off the motor when it over heats. Please use extreme caution when handling the Power Juicer blade as the blades are very sharp. MAIN UNIT (Fully Assembled) Always turn power off to the Power Juicer immediately and remove power cord from electrical outlet before disassembling to clean due to any food obstruction. Pusher CAUTION Pulp Collector Use caution when handling blade as blades are very sharp. If juicer jams turn power off immediately and remove power cord from electrical outlet before disassembling to clean. The Power Juicer has a thermal cut-off safety feature. If the unit accidentally overheats, it will stop working temporarily until the Power Juicer cools down. Clear any obstruction. Afterwards, the unit will continue to work again normally. Chute HELPFUL HINTS Filter Pulp Guard Obtain the best results from your Jack LaLanne Power Juicer by following these helpful hints. • Do not put any fruit or vegetables in your machine until power is turned on. • Allow unit to run for at least 10 seconds before juicing. • Do not force food into the juicer. Allow food to pass through slowly and steadily using the pusher. You do not need to apply pressure unless the juicer starts to vibrate. Then only a slightly harder push should bring it back to balance. • Any fruit or vegetable that will fit the chute can be put through whole. The only time it is necessary to cut is when something is too large. Then it should be cut into large enough pieces to fit in the chute. Do not cut pieces too small. • Remove large pits such as peach, mango, etc. as they will damage the blade and possibly the unit. Before juicing cherries we recommend you remove the pits using a cherry pitter. • Cleaning can be made easy by placing a plastic bag inside the pulp collector container. When you are done juicing, the bag can be lifted out and disposed of easily leaving the pulp collector easier to clean. • Let the Power Juicer run for a few minutes before turning off to allow any excess juice to be extracted from the pulp. Once turned off it is quite normal for the juicer to spin for a minute or so due to the very fine precision balancing of this appliance. Wait until it is done spinning before disassembling. • Do not use bananas or avocados as they do not contain juice and will clog machine. Add them separately in a blender. • We do not recommend using overripe fruit as it will leave too much pulp in the filter and clog the machine. • Do not pour liquids into the machine at any time. 4 SAVE THESE INSTRUCTIONS Lid with Built-in Pulp Guard (Crescent tool pegs fit here to tighten. WARNING: DO NOT OVER TIGHTEN) Crescent Tool (for tightening and removing blade) Blade Screw Peg (Pegs fit into blade.) Locking Bar Juice Spout Lip Receptacle Base 5 ASSEMBLY ASSEMBLY (CONT.) Assemble as shown STEP 1: Place base on a dry flat surface with locking bar in down position as shown. In front of the machine (spout side). 1 STEP 4: Place blade inside filter, centered over screw peg. Using orange crescent tool, place its pegs into the holes in the blade and turn clockwise Crescent until tightened. Tool IMPORTANT: Do not over tighten as the Blade screw peg will break. Holes Remove crescent tool and set aside. CAUTION: Do not leave tool inside juicer. Base Locking Bar Front of Machine 4 Blade Filter (Spout side) STEP 5: STEP 2: Place receptacle on the base, with juicer spout facing direction of locking bar. Settle receptacle into alignment. 2 Lip Juice Spout Receptacle Place lid with built-in pulp guard attached on top of receptacle, making certain it is snugly aligned with the pulp guard facing in the opposite direction of the juice spout. Lock lid into place by lifting locking bar up until it clicks into grooves located on both sides of the lid. Make sure locking bar is in the full upright, locked position. IMPORTANT: The unit will not start until this bar is properly locked in place. 5 Receptacle Lid with built-in Pulp guard Pulp Collector Base STEP 3: Place filter inside receptacle, matching the opening on its bottom to the screw peg connected to the base. STEP 6: 3 Insert pusher into chute. Always use pusher to feed fruits and vegetables into unit. Push gently, never force. The blade will do the work. 6 Pusher Filter Chute Receptacle 6 Lid with built-in Pulp Guard 7 DISASSEMBLY DISASSEMBLY (CONT.) IMPORTANT: Before disassembling the unit make sure you turn the power OFF and unplug the machine from the electrical outlet. STEP 1: Remove pusher from the chute. 1 Pusher STEP 2: Lower the locking bar (silver) into position as shown. STEP 5: Remove filter. 6 5 2 STEP 6: Remove receptacle from base. Filter Receptacle Base Locking Bar Pulp Guard STEP 4: Use the crescent tool (orange) to remove the blade. Place the two pegs at either end of the crescent tool into the two holes on the blade, press down and turn counter-clockwise to unlock the blade. Remove blade carefully. STEP 3: Remove lid with pulp guard, and pulp collector. 3 Lid with Built-in Pulp Guard 4 CLEANING YOUR POWER JUICER • • • • • Blade • Crescent Tool Pulp Collector • • • 8 Turn off the power switch and wait until the motor completely stops. With dry hands, unplug the power cord from electrical outlet. Disassemble the machine. (See disassembly instructions.) Wipe base with a soft damp cloth or sponge. Do not submerge base in water. Do not spray with water or any other liquid. Base is not dishwasher safe. We recommend washing the pusher by hand in warm soapy water. Due to temperature differences in dishwashers if you choose to wash the pusher in the dishwasher, place it on top rack only. Clean all other parts in warm, soapy water. A mild detergent is recommended. Rinse well and dry thoroughly. All components are dishwasher safe with the exception of the base. Do not use in European Import or a commercial dishwasher. To clean the filter and blade, hold them under warm running water. Use a softbristled dish washing brush gently to completely clean pulp from filter. Rinse the filter from the outside under running water. Dry components thoroughly then assemble the machine and turn the power on to spin out any excess water. Make sure unit and parts are completely dry then store in a cool, dry place. 9 TROUBLESHOOTING Problem The motor does not run after being switched on. Possible Reasons and Solution • Check to see if unit is plugged in. • Locking bar is not locked in place properly. • Check if all parts are assembled properly. • Check if there is any residue left between blade and receptacle. Exciting Offers from Power Juicer Accessory Kit & Cookbook Jack LaLanne’s Recipes for Healthy Living Cookbook Power Juicer Platform Measuring Cup Overflow Platform Filter Brush • Check to see if food is stuck to the bottom of the pusher. The motor is running with loud noise and shaking. • Check that all parts are assembled properly and in the correct position. • Juicing overripe fruit may result in too much pulp and will clog the filter. Turn machine off and clean the filter. The motor is running. The spout is in the downward position, but no juice is coming out. • Turn the power off and unplug the machine. Wait for blade to stop spinning. Use a toothpick to loosen any obstruction in the non-drip spout. The motor overheats causing the power to automatically shut off. • The motor needs to warm up for 10 seconds before use. • The fruits and vegetables may be soft or overripe. • There may be too much pulp in the filter. Turn machine off and clean the filter. • Motor stops running due to the built-in feature, the overheat safety control. Juice splashes from the rim of the receptacle. Replacement Parts Kit #1 Replacement Parts Kit #2 Filter Crescent Tool Pulp Guard Pulp Collector Pusher Blade To order or for more information on juicing visit: www.powerjuicer.com • This is normal. or call 1-800-526-2518 — 8:00am–9:00pm EST Monday–Friday 9:00am–5:00pm EST Saturday & Sunday Please allow 4-6 weeks for shipping. YES! Please Send Me the following Items: Print Name ________________________________________________ n One Accessory Kit & Cookbook for only $19.99 plus $6.99 s&h. Total $26.98. Address____________________________________________________ n “Recipes for Healthy Living” Cookbook - FREE plus $7.99 s&h. Total $7.99. ______________________________________________Apt._________ n Replacement Parts Kit #1 for only $29.99 plus FREE s&h. Total $29.99. City______________________________________________________ n Replacement Parts Kit #2 for only $34.99 plus FREE s&h. Total $34.99. State___________________ Zip_______________________________ n VISA n MasterCard n Discover Exp. Date____ Credit Card #______________________________________ Phone# (____________) _____________________________________ n Check n Money Order (NJ residents add 7% sales tax. PA & CT residents add 6% sales tax. NY & NV add applicable sales tax.) U.S. CURRENCY ONLY PRICES SUBJECT TO CHANGE E-mail ____________________________________________________ Please make checks payable to: POWER JUICER 10 Mail Payment Today To: POWER JUICER 26 Barnes Industrial Rd. North, P.O. Box 3125, Dept. PJ999, Wallingford, CT 06494 © 2008 Tristar Products, Inc. All rights reserved. Distributed by: Tristar Products, Inc. Wallingford, CT 06494 PJ Classic V4 0508
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.7 Linearized : Yes XMP Toolkit : Adobe XMP Core 4.0-c316 44.253921, Sun Oct 01 2006 17:08:23 Create Date : 2008:06:04 13:04:35Z Creator Tool : QuarkXPress(tm) 6.5 Modify Date : 2008:06:05 14:46:24-04:00 Metadata Date : 2008:06:05 14:46:24-04:00 Producer : QuarkXPress(tm) 6.5 X Press Private : %%DocumentProcessColors: Black.%%EndComments Format : application/pdf Title : PJ NEWest Instructions (final) Document ID : uuid:3e88c465-9238-472b-85b4-490ff3e7bd0d Instance ID : uuid:4af8bc95-7d13-46b8-a080-a5bd35e6c529 Page Count : 7 Creator : QuarkXPress(tm) 6.5EXIF Metadata provided by EXIF.tools