Jack Lalannes Power Juicer Operation Manual

2014-12-11

: Jack-Lalannes-Power-Juicer Jack-Lalannes-Power-Juicer-Power-Juicer-Operation-Manual-120324 jack-lalannes-power-juicer-power-juicer-operation-manual-120324 jack-lalannes-power-juicer pdf

Open the PDF directly: View PDF PDF.
Page Count: 12

DownloadJack-Lalannes-Power-Juicer Jack-Lalannes-Power-Juicer-Power-Juicer-Operation-Manual-  Jack-lalannes-power-juicer-power-juicer-operation-manual
Open PDF In BrowserView PDF
OPERATING MANUAL

JACK LALANNE POWER JUICER

CONTENTS
3 Important Safeguards
for the Power Juicer

4 Helpful Hints
for the Power Juicer

5 Parts List
for the Power Juicer

6 Assembly
for the Power Juicer

8 Disassembly
for the Power Juicer

9 Cleaning Your Power Juicer
10 Troubleshooting
for the Power Juicer

2

JACK LALANNE POWER JUICER

IMPORTANT SAFEGUARDS
READ THESE SAFEGUARDS CAREFULLY
BEFORE USING THIS PRODUCT!
When using the Jack Lalanne Power Juicer, basic safety precautions should
always be followed including the following:
• NOT FOR USE BY CHILDREN! Keep out of the reach of children to avoid injury.
The Power Juicer is not a toy.
• Consult your physician before giving fresh juice to children, especially infants.
• Be sure to turn to OFF position after each use of your Power Juicer
• Make sure the lid is attached properly and securely locked before operating
the Power Juicer.
• Do not unfasten the locking bar during operation.
• To avoid risk of injury keep hands and utensils out of the Power Juicer and away from its sharp
blade during operation.
• Use the pusher, not fingers or utensils, to propel the food into the Power Juicer.
• Should food become lodged in the opening use pusher to push it down. If food remains stuck,
turn the power off, wait until motor stops, Power Juicer shuts down completely, and is
unplugged before disassembling the juicer and removing the blocked food.
• Make sure the motor stops completely and the Power Juicer is unplugged from the electrical
outlet before cleaning, putting on or removing parts.
• To protect against risk of electrical shock or injury, never immerse power cord,
plug, or Power Juicer in water, or other liquids.
• If juicer stops due to improper operation or if there is excessive noise, turn power off, wait for
blade to stop spinning, unplug from electrical outlet, disassemble and clean
all components then reassemble Power Juicer.
• Do not use Power Juicer outdoors.
• Do not operate Power Juicer with a damaged cord or plug.
• Do not operate if Power Juicer malfunctions, is dropped or damaged in any manner.
Let a qualified appliance repair person examine and or repair appliance before using.
• To avoid electric shock or serious injury do not use any attachments that were
not recommended or sold by the manufacturer.
• Do not let power cord hang over the edge of table, counter, or let cord touch
hot surfaces such as stoves.
• To reduce the risk of injury, never place blade on base without properly assembling
the Power Juicer.
• The Power Juicer has a polarized plug (one blade is wider than the other). To reduce
the risk of electric shock, this plug will fit in a polarized outlet only one way. If the plug does
not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician.
Do not modify or force the plug in any way.
• The Power Juicer motor will not run if unit is not properly assembled. The motor has a built-in
safety feature that will not let the power turn on unless the locking bar is locked in place.

3

JACK LALANNE POWER JUICER

HELPFUL HINTS
Obtain the best results from your Jack LaLanne Power Juicer
by following these helpful hints.
• Do not put any fruit or vegetables in your machine until power is turned on.
• Allow unit to run for at least 10 seconds before juicing.
• Do not force food into the juicer. Allow food to pass through slowly and steadily
using the pusher. You do not need to apply pressure unless the juicer starts to
vibrate. Then only a slightly harder push should bring it back to balance.
• Any fruit or vegetable that will fit the chute can be put through whole. The only
time it is necessary to cut is when something is too large. Then it should be cut
into large enough pieces to fit in the chute. Do not cut pieces too small.
• Remove large pits such as peach, mango, etc. as they will damage the blade
and possibly the unit.
• Cleaning can be made easy by placing a plastic bag inside the pulp collector
container. When you are done juicing, the bag can be lifted out and disposed
of easily leaving the pulp collector easier to clean.
• Let the Power Juicer run for a few minutes before turning off to allow any excess
juice to be extracted from the pulp. Once turned off it is quite normal for the
juicer to spin for a minute or so due to the very fine precision balancing of this
appliance. Wait until Power Juicer it is done spinning before disassembling.
• Do not use bananas or avocados as they do not contain juice and will clog
machine. Add them separately in a blender.
• We do not recommend using overripe fruit as it will leave too much pulp in
the filter and clog the Power Juicer.
• Do not pour liquids into the Power Juicer at any time.

SAVE THESE INSTRUCTIONS

4

Chute

Pulp Guard

Locking Bar

Lip

5

JACK LALANNE POWER JUICER

ASSEMBLY
Assemble as shown
STEP 1:
Place base on a dry flat surface with
locking bar in down position as shown.
In front of the machine (spout side).

1

Base

Locking
Bar

Front of
Machine
(Spout side)

STEP 2:
Place receptacle on the base,
with juicer spout facing direction
of locking bar. Settle receptacle
into alignment.

2
Lip
Juice Spout
Receptacle

Base

STEP 3:
Place filter inside receptacle,
matching the opening on
its bottom to the screw peg
connected to the base.

3
Filter

Receptacle

6

JACK LALANNE POWER JUICER

ASSEMBLY (CONT.)
STEP 4:
Place blade inside filter, centered
over screw peg. Using orange
crescent tool, place its pegs
into the holes in the blade
and turn clockwise
Crescent
until tightened.
Tool
IMPORTANT: Do not
over tighten as the
Blade
screw peg will break.
Holes
Remove crescent tool
and set aside.
CAUTION: Do not
leave tool inside juicer.
STEP 5:
Place lid with built-in pulp guard attached
on top of receptacle, making certain it is
snugly aligned with the pulp guard facing
in the opposite direction of the juice spout.
Lock lid into place by lifting locking bar
up until it clicks into grooves located
on both sides of the lid. Make sure
locking bar is in the full upright,
locked position.
IMPORTANT: The unit will not start
until this bar is properly locked in place.

STEP 6:
Insert pusher into chute.
Always use pusher to feed fruits
and vegetables into unit. Push gently,
never force. The blade will do the work.

4

Blade
Filter

5
Receptacle

6

Lid with built-in
Pulp guard

Pulp
Collector

Pusher

Chute
Lid with built-in
Pulp Guard

7

JACK LALANNE POWER JUICER

DISASSEMBLY
IMPORTANT: Before disassembling the unit make sure you turn the power OFF
and unplug the machine from the electrical outlet.

STEP 1:
Remove pusher from the chute.

1

Pusher

STEP 2:
Lower the locking bar (silver) into
position as shown.

2
Locking Bar

Pulp Guard

STEP 4:
Use the crescent tool (orange) to
remove the blade. Place the two pegs
at either end of the crescent tool into
the two holes on the blade, press
down and turn counter-clockwise
to unlock the blade. Remove
blade carefully.

STEP 3:
Remove lid with pulp guard,
and pulp collector.

3

Lid with Built-in
Pulp Guard

4
Crescent Tool

Pulp
Collector

8

Blade

JACK LALANNE POWER JUICER

DISASSEMBLY (CONT.)
STEP 5:
Remove filter.

STEP 6:
Remove receptacle from base.

6

5
Filter

Receptacle
Base

JACK LALANNE POWER JUICER

CLEANING YOUR
POWER JUICER
• Turn off the power switch and wait until the motor completely stops.
• With dry hands, unplug the power cord from electrical outlet.
• Disassemble the Power Juicer. (See disassembly instructions.)
• Clean all other parts in warm, soapy water. A mild detergent is recommended.
Rinse well and dry thoroughly. All components are dishwasher safe
with the exception of the base. Do not use in European Import or a
Commercial dishwasher.
• Wipe base with a soft damp cloth or sponge. Do not submerge base in water.
Do not spray with water or any other liquid. Base is not dishwasher safe.
• To clean the filter and blade, hold them under warm running water. Use a
soft-bristled dish washing brush gently to completely clean pulp from filter.
Rinse the filter from the outside under running water.
• Dry components thoroughly then assemble the machine and turn the power
on to spin out any excess water.
• Make sure the Power juicer and parts are completely dry then store in a cool,
dry place.
9

JACK LALANNE POWER JUICER

TROUBLESHOOTING
Problem
The motor does not
run after being
switched on.

Possible Reasons and Solution
• Check to see if unit is plugged in.
• Locking bar is not locked in place properly.
• Check if all parts are assembled properly.
• Check if there is any residue left between
blade and receptacle.

The motor is running
with loud noise and
shaking.

• Check that all parts are assembled properly
and in the correct position.

The motor overheats
causing the power to
automatically shut off

• The motor needs to warm up for 10 seconds
before use.
• The fruits and vegetables may be soft
or overripe.
• There may be too much pulp in the filter.
Turn machine off and clean the filter.
• Motor stops running due to the built-in
feature, the overheat safety control.

Juice splashes from the
rim of the receptacle.

• This is normal.

10

• Juicing overripe fruit may result in too much
pulp and will clog the filter. Turn Power juicer
off and clean the filter.

Exciting Offers from

Power Juicer
Accessory Kit
& Cookbook
Jack LaLanne’s Recipes for
Healthy Living Cookbook
Measuring Cup
Overflow Platform
Filter Brush

Power Juicer Pulp
Replacement Kit

Power Juicer Blade
Replacement Kit

Pulp Guard
Pulp
Collector
Pusher

Filter
Crescent
Tool
Blade

www.powerjuicer.com

Call

1-800-526-2518
9:00 AM – 7:00 PM EST Monday – Friday
9:00 AM – 5:00 PM EST Saturday
Please allow 4-6 weeks for shipping.

YES! Please Send Me the following Items:
■ One Accessory Kit & Cookbook for only $19.99
plus $5.99 s&h. Total $25.98.
■ “Recipes for Healthy Living” Cookbook
for only $9.99 plus $1.99 s&h. Total $11.98.
■ Power Juicer Blade Replacement Kit for only $19.99
plus $4.99 s&h. Total $24.98.
■ Power Juicer Pulp Replacement Kit for only $9.99
plus $2.99 s&h. Total $12.98.
■ VISA ■ MasterCard ■ Discover Exp. Date____

Print Name ________________________________________________
Address____________________________________________________
______________________________________________Apt._________
City______________________________________________________
State___________________ Zip_______________________________

Credit Card #______________________________________ Phone# (____________) _____________________________________
■ Check ■ Money Order (NJ, PA, CT residents add 6%
sales tax. CA, NV & NY add applicable rate.)
E-mail ____________________________________________________
U.S. CURRENCY ONLY
Please make checks payable to: POWER JUICER

Mail Payment Today To: POWER JUICER
26 Barnes Industrial Rd. North, P.O. Box 3125, Dept. PJ999, Wallingford, CT 06494

We are very proud of the design and quality
of our Power Juicer. This product has been manufactured
to the highest standards. Should you have any problem our friendly
customer service staff is here to help you
if you have a question.

We are available at:

1-800-526-2518
9:00 AM – 7:00 PM EST Monday – Friday
9:00 AM – 5:00 PM EST Saturday
© 2006 Tristar Products, Inc.
All rights reserved.

Distributed By:

Tristar Products, Inc.
Wallingford, CT 06494

PJ V3 062106



Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : No
Create Date                     : 2006:06:29 12:46:04Z
Creator                         : QuarkXPress(tm) 6.5
Modify Date                     : 2014:12:07 14:52:03+08:00
X Press Private                 : %%DocumentProcessColors: Black.%%EndComments
XMP Toolkit                     : Adobe XMP Core 5.4-c005 78.147326, 2012/08/23-13:03:03
Creator Tool                    : QuarkXPress(tm) 6.5
Metadata Date                   : 2014:12:07 14:52:03+08:00
Producer                        : QuarkXPress(tm) 6.5
Format                          : application/pdf
Document ID                     : uuid:d111cf01-3377-11db-af19-00145167273e
Instance ID                     : uuid:d8dbccf1-751c-3641-b42b-b5528f223009
Page Count                      : 12
EXIF Metadata provided by EXIF.tools

Navigation menu