Jada Toys JT49RX91000 9” Chub City RC and 4.5” Chub City RC. User Manual 83047 IS US01 Back

Jada Toys Company Limited 9” Chub City RC and 4.5” Chub City RC. 83047 IS US01 Back

Contents

User Manual 2

Download: Jada Toys JT49RX91000 9” Chub City RC and 4.5” Chub City RC. User Manual 83047 IS US01 Back
Mirror Download [FCC.gov]Jada Toys JT49RX91000 9” Chub City RC and 4.5” Chub City RC. User Manual 83047 IS US01 Back
Document ID731657
Application ID96bjLek1dVcV4yKmgltZNw==
Document DescriptionUser Manual 2
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize90.94kB (1136810 bits)
Date Submitted2006-11-23 00:00:00
Date Available2006-11-24 00:00:00
Creation Date2006-11-16 18:08:55
Producing SoftwareAdobe PDF library 7.77
Document Lastmod2006-11-16 18:08:55
Document Title83047-IS-US01 Back
Document CreatorAdobe Illustrator CS2

83047-IS-US02
Steering Dial
INSTALLING BATTERIES IN THE R/C
Keep these instructions for future reference: they contain
important information.
IMPORTANT: Please read all “Consumer
Information” before operating your vehicle.
CAUTION:
ELECTRICALLY OPERATED PRODUCT
Not recommended for children under 8 years of age. As
with all electric products, precautions should be observed
during handling and use to prevent electric shock.
ADULT SUPERVISION REQUIRED.
Surfaces may become hot and cause burns if electronics
get wet. Do not operate vehicle through water or snow.
Consumer Information:
Note to Adults: to ensure that the child’s play is both
safe and fun, please review all operating instructions and
safety rules with your child.
CONTENTS
Vehicle
Transmitter Controller
Antenna for Transmitter Controller
6 (six) “AA” Alkaline batteries (Not included)
1. Push the ON/OFF to “OFF” position on vehicle.
2. Using a Phillips screwdriver (not included), to
remove the battery compartment door underneath
the vehicle. (See diagram 1)
3. Take out the battery cartridge from the battery
compartment.
4. Insert the 6 “AA” batteries, with polarity (+/-) as
shown inside battery cartridge.
5. Insert the battery cartridge with correct polarity (+/-)
into the battery compartment.
6. Replace the battery compartment door and use
Phillips screwdriver to lock the compartment door.
•
•
•
•
•
•
NEVER drive your vehicle on streets! They’re for real
cars!
DO NOT pick up vehicle while in motion.
Avoid collisions with wall or hard surfaces.
Keep fingers, hair and loose clothing away from tires
and the wheel hubs while the vehicle is switched ON.
Adult supervision is recommended when this vehicle is
being operated.
To avoid accidental operation, remove all batteries when
not in use.
Be sure to rest your vehicle for at least 5 minutes
after every 15 minutes of operation.
BEFORE BATTERY INSTALLATION
Your new R/C is designed to work with standard 6 (six)
“AA” alkaline batteries, sold separately.
Controller is designed to work with a 9-volt alkaline battery,
sold separately.
6 x AA Batteries
(Not Included)
steering alignment lever
To replace batteries
remove screw on battery
cover as shown in
illustration and replace
batteries
REAR
INSTALLING CONTROLLER –
9 VOLT BATTERY
1 (one) 9V Alkaline battery (not included)
1. Open the battery cover as shown (See Diagram 2 )
2. Install one 9V battery with polarity (+/-) as shown
inside battery compartment.
3. Replace battery cover.
•
•
•
•
•
•
•
•
Insure that battery polarity is correct.
Use only batteries of the type recommended
(or equivalent).
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc), or
rechargeable (nickel-cadmium) batteries.
Remove used-up batteries immediately. Remove
batteries if vehicle will not be used for a long period of
time to prevent possible leakage.
Do not recharge non-rechargeable batteries.
Do not short-circuit terminals.
Dispose of batteries safely. Do not dispose of batteries
(or products containing non-replaceable batteries) in
fire, as batteries may explode or leak.
QUICK TIPS
•
•
•
•
•
When your vehicle starts to lose power, it may lose
functions or performance. It’s time for fresh batteries
(or a recharge). Your vehicle’s running time may vary
depending on your driving style.
Radio interference can make your vehicle run badly.
Interference can be caused by other R/C vehicles
running on the same frequency; electrical wires, large
buildings; or CB radios. Try to stay away from these!
Point your transmitter controller antenna up – not down
toward your vehicle. If your vehicle gets too far away, it
won’t work properly.
Don’t drive your vehicle in sand or through water or
snow.
Don’t store your vehicle near heat or in direct sunlight.
Always turn switches OFF and remove all batteries
for storage.
Operations Tips:
Screw On
Battery Safety Information
Safety Tips
•
FRONT
TO ADJUST STEERING ALIGNMENT
Adjust the steering alignment lever on
the underside of the vehicle when the
vehicle doesn’t run straight forward.
Power on
LED Light Up
Insert 9 volt
battery into
transmitter
Locate the transmitter antenna mount
on the top of the transmitter. Insert the
antenna into the mount opening and
rotate in a clockwise direction until snug.
Left / Right
Forward
Transmitter: ON / OFF switch located on
the front of the transmitter.
When you ready to run, please make sure
push the ON / OFF switches to “ON”
position on both. Go to get fun.
Reverse
BOTTOM OF
TRANSMITTER CONTROLLER
Car: ON / OFF switch located on the
bottom of the car.
On / Off
TRANSMITTER CONTROLLER
Cleaning instruction:
To clean, wipe excess dirt from toy. Remove batteries first.
Wipe toy clean with wet cloth using plain water. Wipe dry.
DO NOT IMMERSE IN WATER and DO NOT CLEAN
VEHICLE WITH ANY CHEMICALS. Let the toy completely
dry up before putting batteries back into clean, dry battery
compartment.
©2006 Jada Toys, Inc.
City of Industry, CA 91748 USA
CHUB CITY® is a registered trademarks of
Jada Toys, Inc.
All Rights Reserved.

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
XMP Toolkit                     : 3.1.1-111
Format                          : application/pdf
Title                           : 83047-IS-US01 Back
Creator Tool                    : Adobe Illustrator CS2
Create Date                     : 2006:11:16 18:08:55+08:00
Modify Date                     : 2006:11:16 18:08:55+08:00
Metadata Date                   : 2006:11:16 18:08:55+08:00
Thumbnail Width                 : 256
Thumbnail Height                : 184
Thumbnail Format                : JPEG
Thumbnail Image                 : (Binary data 16577 bytes, use -b option to extract)
Document ID                     : uuid:00B8EC9376FC11DBA8E6F61CA8FF19FA
Instance ID                     : uuid:77cba3ae-755a-11db-86b8-000d935e252a
Derived From Instance ID        : uuid:b9daee21-5507-11db-a280-000d935e252a
Derived From Document ID        : uuid:13E1CB7F56BB11DB9B40EFBF5D82535F
Producer                        : Adobe PDF library 7.77
Page Count                      : 1
Creator Version                 : 12
Container Version               : 9
Creator                         : Adobe Illustrator(R) 12.0
For                             : Chris, Jada Toys Co Ltd
Bounding Box                    : -454 -775 486 -107
EXIF Metadata provided by EXIF.tools
FCC ID Filing: PWYJT49RX91000

Navigation menu