Junlan Electronic ITSB350 Bluetooth Soundbase User Manual ITSB 340 Manual 012215 lores

Shenzhen Junlan Electronic Ltd Bluetooth Soundbase ITSB 340 Manual 012215 lores

User Manual

Download: Junlan Electronic ITSB350 Bluetooth Soundbase User Manual ITSB 340 Manual 012215 lores
Mirror Download [FCC.gov]Junlan Electronic ITSB350 Bluetooth Soundbase User Manual ITSB 340 Manual 012215 lores
Document ID2681419
Application IDlXpuZGEUBSkgG5N0dn6lWw==
Document DescriptionUser Manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize237.68kB (2970998 bits)
Date Submitted2015-07-16 00:00:00
Date Available2015-07-16 00:00:00
Creation Date2015-01-22 18:23:02
Producing SoftwareAdobe PDF library 9.90
Document Lastmod2015-01-23 19:13:48
Document TitleITSB-340-Manual-012215-lores
Document CreatorAdobe Illustrator CS5

2.1CH TV Stand Bluetooth Sound Base Speaker
MODEL:ITSB-350
1 X Remote Control
1 X Instruction Manual
1 X RCA Cable
1 X 3.5mm Aux In Cable
Press the
button on the unit or press the SOURCE button on the remote
control repeatedly until "BT"appears on display.
ITSB-350
Optical-In
14
optical in.
FRONT VIEW
The TV STAND SOUND BASE
STANDBY
10
11
Press the
button on the unit or press the SOURCE button on the remote control
repeatedly until "BT"appears on display.
TOP VIEW
the TV STAND
PAIR
SOUND BASE
TUNE-
TUNE+
12
PRE/
RECALL
13
10
FM SCAN
MO/ST
the TV STAND SOUND BASE
Folloe these precautions when using a battery in this device:
ITSB-350
ITSB-350
1. Use only the size and type of battery specified.
2. Be sure to follow the correct polarity when installing the battery as indicated in the battery
compartment. A reversed battery may cause damage to the device.
REAR VIEW
3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc ) or old
batteries with fresh ones.
4. If the batteries in the device are consumed or device is not to be used for a long period of
time, remove the batteries to prevent damage or injury from possible battery leakage.
OPTICAL
5. Do not try to recharge the battery not intended to be recharged; it can overheat and rupture.
( Follow battery manufacturer's instructions.)
6. The batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
7. Clean the battery contacts and also those of the device prior to battery installation.
OPTICAL
7.
12
11
14
13
1. SPEAKER
2. DISPLAY
3. REMOTE SENSOR
4.
POWER Button
5.
SOURCE Button
6.
PLAY/PAUSE/PAIR Button
7.
TUNE DOWN/PREVIOUS Button
8.
TUNE UP/NEXT Button
9.
VOLUME DOWN Button
10.
VOLUME UP Button
11. DC IN JACK
12. AUX IN JACKS(L/R)
13. OPTICAL IN JACK
14. ANTENNA WIRE
Button
2. VOL(volume)- Button
8. FM SCAN Button
3. SOURCE Button
9. MO/ST(Mono/Stereo) Button
8. This product contains a coin/button cell battery. If the coin/button cell battery is swallowed, it
can cause severe internal burn in just 2 hours and can lead to death. Keep new and used
batteries away from children. If the battery compartment does not close securely, stop using
and keep it away from children. If you think batteries might have been swallowed or
placed inside any part of the body, seek immediate medical attention.
11. VOL(volume)+ Button
5. EQ (equalizer) Button
6.
12.
TUNE- Button
3) Press
/TUNE- or /TUNE+ button on remote control(or press
or
button on the unit) repeatedly to search the specific
band.
Press and hold the TUNE - or
TUNE + button on remote control
(or press and hold the
or
button on the unit), the unit will search
automatically the available band back and forth then stop and play).
~ Press the EQ button on the remote control to set to JAZZ, POP, ROCK,
CLAS and NORM mode.
~ Press the
/TUNE + or
/TUNE - button to skip the tracks.
button
button on the remote control or press the
~ Press the
on the unit to pause, press again to resume.
4) To store the band automatically, press FM SCAN button on remote
control , the unit will scan all available band and store automatically.
5) After finishing scanning, press "PRE/RECALL" button on remote control
repeatedly to select and listen the desired preset channels.
10. MUTE Button
4. PAIR Button
If you want to connect another BT device while playing, press "PAIR" Button on
remote control or press and hold the
Button on the unit to cut off
current pairing, then try to connect the other BT device following above steps.
2) Press the
button on the unit or press the SOURCE button on the
Remote Control repeatedly until FM frequency appears on display.
6) If the available FM station is stereo, the unit will plays it in stereo mode
automatically. If the reception is no good, press the MO/ST button on the
Remote Control to switch it to Mono mode. Press again to turn back to
Stereo mode.
TUNE+ Button
13. PRE/RECALL Button
PLAYING AUDIO VIA OPTICAL-IN SOURCE
1. Connect the Aux out jacks from the external audio player (such like DVD player,
VCR …etc.) to the AUX IN jacks on the rear of the unit by the supplied RCA
connection cable as the figure below:
1. Connect the Optical out jack from the external audio Player (such like TV, DVD Player
BD Player …etc.) to the OPTICAL IN jack on the top of unit by the Optical Connection
Cable (not supplied) as the figure below: ( F or PCM format only )
20
60
Type of Optical Digital Audio in ........................................................................ PCM
Rear view of the unit
OPTICAL
OPTICAL
white
is a trademark on a registered trademark of Bluetooth
SIG Inc. All other trademarks and trade names are
those of their respective owners.
red
Optical Connection Cable ( not supplied )
or +
(DVD or VCR...etc)
TV; DVD player; BD player... etc.
2. Connect the unit to the power as previous procedures.
3. Press the Standby (
the unit.
) button on the unit or Remote Control to power on
4. Press the
button on the unit or press the SOURCE button on the
Remote Control repeatedly until "AUX" appears on display.
5. Power on the connected external player and start playback music as usual.
correct source appears
2. Power on the unit as previous procedures.
3. Press the
button on the unit or press the SOURCE button on the
Remote Control repeatedly until "OPTI" appears on display.
4. Power on the connected external player and start playback the Music as usual.
Turn on the digital audio output and set it to PCM (Plus Code Modulation) type
similar to the follows figure:
Picture
Audio
Sound Mode
Bass
Treble
Balance
Surround
AVL
Digital Output
Audio Language
Select
Time
Setup
Lock
Off
MENU
Exit
Standard
Off
Off
PCM
English
Move
or -
FCC Warning:
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that
may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
RF Exposure Statement
To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be
installed and operated with minimum distance between 20cm the radiator your body:
Use only the supplied antenna.

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
XMP Toolkit                     : 3.1-701
Format                          : application/pdf
Title                           : ITSB-340-Manual-012215-lores
Metadata Date                   : 2015:01:23 19:13:48+08:00
Modify Date                     : 2015:01:23 19:13:48+08:00
Create Date                     : 2015:01:22 18:23:02-05:00
Creator Tool                    : Adobe Illustrator CS5
Thumbnail Width                 : 256
Thumbnail Height                : 228
Thumbnail Format                : JPEG
Thumbnail Image                 : (Binary data 22179 bytes, use -b option to extract)
Instance ID                     : uuid:8e8e6686-adab-4bcf-8018-0520350f1fc7
Document ID                     : xmp.did:DCEA67C1FD2068118C149AE49BDB157C
Original Document ID            : uuid:5D20892493BFDB11914A8590D31508C8
Rendition Class                 : proof:pdf
Derived From Instance ID        : xmp.iid:4E71B3EE782068118C149AE49BDB157C
Derived From Document ID        : xmp.did:4E71B3EE782068118C149AE49BDB157C
Derived From Original Document ID: uuid:5D20892493BFDB11914A8590D31508C8
Derived From Rendition Class    : proof:pdf
History Action                  : saved, saved, saved, saved, saved, saved, saved, saved, saved, saved, saved
History Instance ID             : xmp.iid:F77F1174072068118083C536F9452716, xmp.iid:FC7F1174072068118083F4382BBFCEDB, xmp.iid:1F44791A3A2068118083D031C480548D, xmp.iid:2044791A3A2068118083D031C480548D, xmp.iid:ED7F1174072068118083F5EEB51234A7, xmp.iid:F27F1174072068118083F6CC32AFBE31, xmp.iid:F57F11740720681188C6FEE160E4D428, xmp.iid:F44A43011B20681188C6FEE160E4D428, xmp.iid:4B71B3EE782068118C149AE49BDB157C, xmp.iid:4E71B3EE782068118C149AE49BDB157C, xmp.iid:DCEA67C1FD2068118C149AE49BDB157C
History When                    : 2013:03:25 15:13:01-04:00, 2013:03:27 13:23:23-04:00, 2013:04:01 16:59:25-04:00, 2013:04:01 17:03:26-04:00, 2013:04:17 13:42:21-04:00, 2013:07:30 14:04:11-04:00, 2013:08:01 16:49:37-04:00, 2013:08:01 16:53:21-04:00, 2015:01:22 14:02:13-05:00, 2015:01:22 18:22:33-05:00, 2015:01:22 18:22:55-05:00
History Software Agent          : Adobe Illustrator CS5, Adobe Illustrator CS5, Adobe Illustrator CS5, Adobe Illustrator CS5, Adobe Illustrator CS5, Adobe Illustrator CS5, Adobe Illustrator CS5, Adobe Illustrator CS5, Adobe Illustrator CS5, Adobe Illustrator CS5, Adobe Illustrator CS5
History Changed                 : /, /, /, /, /, /, /, /, /, /, /
Manifest Link Form              : EmbedByReference
Manifest Reference File Path    : /Users/design3/Desktop/ITSB-340-BW-manual-CMYK.jpg
Startup Profile                 : Print
Has Visible Overprint           : False
Has Visible Transparency        : False
N Pages                         : 1
Max Page Size W                 : 30.500000
Max Page Size H                 : 26.031670
Max Page Size Unit              : Inches
Plate Names                     : Cyan, Magenta, Yellow, Black, PANTONE 300 C, PANTONE 185 C
Swatch Groups Group Name        : Default Swatch Group
Swatch Groups Group Type        : 0
Swatch Groups Colorants Swatch Name: PANTONE 300 C
Swatch Groups Colorants Type    : SPOT
Swatch Groups Colorants Tint    : 100.000000
Swatch Groups Colorants Mode    : CMYK
Swatch Groups Colorants Cyan    : 100.000000
Swatch Groups Colorants Magenta : 42.000000
Swatch Groups Colorants Yellow  : 0.000000
Swatch Groups Colorants Black   : 0.000000
Producer                        : Adobe PDF library 9.90
Page Count                      : 1
Creator                         : Adobe Illustrator CS5
EXIF Metadata provided by EXIF.tools
FCC ID Filing: OKUITSB350

Navigation menu