KAB Enterprise TR-010 Remote Control Transmitter User Manual RC 010 WDS

Kab Enterprise Co., Ltd. Remote Control Transmitter RC 010 WDS

User Manual

Each receptacle is limited to 333W A14G0846 533299 2008 NOTE:This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordancewith the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception. Which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna.--Increase the separation between the equipment and receiver.--Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.--Consult the dealer or an experienced radio/TV technician for help.INSTALLATION:1. Mount or hang the RECEIVER on the wall near a wall grounded electrical 120V 60Hz outlet which the power supply cord of the RECEIVER will plug in to. 2. Plug the cord of the device you wish to control remotely at the bottom of the RECEIVER.3. The heat dissipation hole of the bottom must be stuck on the wall closely. 4. The device must be mounted in an attitude that the heat dissipation openings at the bottom enclosure shall be stuck on the wall closely and in a vertical position with the receptacle facing downward and with the receptacles at least 2 feet (610 mm) above the ground level not for water immersion.Operation: • Function A - Fading: 3 outlets turn light fading rotational by each outlet (turn off by function E)• Function B - Chasing: 3 outlets turn light ON/OFF rotational by every 2 outlets (turn off by function E)• Function C - Flashing: 3 outlets turn light ON/OFF by sec for flashing Event (turn off by function E)• Function D - Dancing: Cyclic repeat function A to C (turn off by function E)• Function E - Switch: Turn 3 outlets power ON/OFF as regular remoteChasing Dancing Fading On/Off Flashing IMPORTANT INFORMATION REQUIRED BY THE FCCFCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter.

Navigation menu