KAB Enterprise TR-020S Remote Controller User Manual x420 TM 110 TR 020S SJTW 14 3 IM Rev 1

Kab Enterprise Co., Ltd. Remote Controller x420 TM 110 TR 020S SJTW 14 3 IM Rev 1

Users Manual

OUTDOOR REMOTE CONTROLLEDCOUNTDOWN TIMERInstallationReceiverTransmitter1. Mount or hang the RECEIVER on the wall near a GFCI protected outlet(125V 60Hz) which the power supply cord of the RECEIVER will pluginto.2. Plug the cord of the device you wish to control remotely at the bottom of theRECEIVER.Helpful Tips• Once programming activates at dusk in the 2hr, 4hr, 6hr, or 8hr mode, theprogram cycle will complete before the timer resets. Headlights, porch lights,street lamps and other external lighting sources will not interfere with theactive timer program.• In the dusk-to-dawn mode, temporary light sources like headlights, porchlights and other external light sources will not interfere with the photocellfunction unless the external light source is on for more than 15 minutes. Inthat case, the timer will shut off until darkness is restored.• When set to “ON”, the timer will provide continual power to attached devicesuntil the timer is switched to “OFF”, or to any of the other operating modes.Operating InstructionsReceiver & Transmitter opetation modes:ON: Power is ON to attached devicesSensor(Dusk - Dawn): power will turn on at dusk and remain on until dawn2 Hrs: Power will turn on at dusk and remain on for 2 hours4 Hrs: Power will turn on at dusk and remain on for 4 hours6 Hrs: Power will turn on at dusk and remain on for 6 hours8 Hrs: Power will turn on at dusk and remain on for 8 hoursOFF: Power is OFF to attached devices*Note for Transmitter: Control electrical outlet up to a distance of 100 feet.*Note The timer has daily repeat after setting, in case of power failure, it will stop operating when the power goes out. Once power is restored, reset thedesired operating mode as the operating instructions.1. Sensor:Sensor will turn receiver on at duskand off at dawn.2. Operating Mode:Timer will turn ON, 2, 4, 6, or 8 hoursafter dusk.3. Select button:To select the function and repeatedly.Power ON Sensor 2H 4H 6H 8H OFF ON4. Outlets:Plug the lights or devices to becontrolled by the timer into one of theoutlets.5. TransmitterPrinted in ChinaButton Layout5power sensor2 Hrs 4 Hrs6 Hrs 8 Hrs2134Battery Handling and Usage Keep batteries away from children and pets.• Follow the battery manufacturer’s safety and usage instructions.• Insert the battery observing the proper polarity (+/-) as indicated insideBattery Compartment.• Remove a spent or discharged battery from the product. Remove thebattery when not using the product for an extended period.• Never throw batteries into a fire. Do not expose batteries to fire or otherheat sources.• Dispose or recycle spent / discharged batteries in compliance with allapplicable laws. For detailed information contact your local solid wasteauthority.• Battery contains mercury. Do not put in trash. Recycle or manage ashazardous waste.WARNING:Battery Replacement1. Remove the Battery Compartment Cover from theback of the Remote Control by sliding the Cover inthe direction that its trends curve.2. Remove the spent battery and place a new DC 12VType A23 battery into the Battery Compartmentcorrectly observing the polarity indications (+/-)inside the Battery Compartment.3. Replace the Battery Compartment Cover.SAFETY INFORMATIONDO NOT ATTACH A DEVICE THAT EXCEEDS THE UNIT RATINGS:125 V ac 60 Hz, 15 A Resistive,15 A General Use,1000 W Tungsten,500 VA Electronic Ballast,1/2HP. 120 V ac 60 Hz, 8.3 A BallastFederal Communications Commission Interference StatementThis equipment has been tested and found to comply with the limits for ClassB digital device, pursuant to part 15 of the FCC Rules. These limits aredesigned to provide reasonable protection against harmful interference in aresidential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the followingmeasures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and the receiver.• Connect the equipment into an outlet on a circuit different from that to whichthe receiver is connected.• Consult the dealer or an experienced radio/TV technician for help.This device complies with Part 15 of the FCC Rules and Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation of the device.FCC Caution: Any changes or modifications not expressly approved by theparty responsible for compliance could void the user's authority to operate thisequipment.Industry Canada statement:Cet appareil est conforme à la Partie 15 des règlements de la FCC et aux normes RSS de l’Industrie du Canada. Son fonctionnement est soumis aux deux conditions suivantes : (1) cet appareil ne doit pas causer des interférences nuisibles, et (2) cet appareil doit accepter toute interférence reçue, y compris les interférences qui peuvent provoquer un fonctionnementindésirable. Le fabricant n'est pas responsable des toutes interférences radio ou télévisioncausées par des modifications non autorisées apportées à cet appareil. Detelles modifications peuvent empêcher l’utilisateur d’utiliser l'appareil.Le présent émetteur radio (identifier le dispositif par son numéro de certificationou son numéro de modèle s'il fait partie du matériel de catégorie II) a étéapprouvé par Industrie Canada pour fonctionner avec les types d'antenneénumérés ci-dessous et ayant un gain admissible maximal. Les types d'antenne non inclus dans cette liste, et dont le gain est supérieur au gain maximal indiqué, sont strictement interdits pour l'exploitation de l'émetteur.CAUTION• Suitable for use with outdoor appliances.• For use ONLY with a three conductor GFCI protected outlet.• Raintight when mounted vertically with receptacles facing downward.• Do not immerse in water.• DO NOT EXCEED RATED CAPACITY.• The device must be mounted in a vertical position with the receptacle facingdownward and with the receptacle at least 2 FT above the ground level.Size: W-21 x H-29.7/cmRECEIVER MODEL: TM-110TRANSMITTTER MODEL: TR-020SFCC ID: PAGTR-020SIC: 4494A-TR020S

Navigation menu