KAB Enterprise TR-025 Remote Controller User Manual RC 040 TR 025B 1 3 FCC IC IM Rev20180125
KAB Enterprise Co., Ltd. Remote Controller RC 040 TR 025B 1 3 FCC IC IM Rev20180125
User Manual
TR-025 Remote Controller User Manual RC-040 + TR-025 Indoor Wireless Remote Control IMPORTANT SAFEGUARDS NOTE: These are general definitions only; all may not pertain to the actual product purchased. DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury. Usage of this signal word is limited to the most extreme situations. WARNING: Indicates potentially hazardous situation, which, if not avoided, may result in minor / moderate injury or product/ property damage. It also alerts against unsafe practices. CAUTION: Indicates a potentially hazardous situation, which, if not avoided, may result in minor/moderate injury or product/ property damage. It also alerts against unsafe practices. When using electrical products, always follow basic safety precautions including the following: WARNING-- To reduce the risk of fire, electric shock, or serious personal injury • Do not immerse the product in liquids • This product is not intended for use by children and contains small parts that may pose a choking hazard to children under the age of three. Keep the product out of the reach of children and pets. • Do not use an electrical device or appliance with this product whose electrical specifications exceed those specified in the “Electrical Specifications” section of this manual. • Indoor use only. CAUTION-- To reduce the risk of personal injury or product/ property damage: • This product is intended for non-commercial, non-industrial use in the remote control of two electrical outlets. Do not use this product for any other purpose. Maintenance 1. Plug receiver into a standard 125-volt AC electrical outlet. 2. Confirm that the electrical specifications of an item you wish to use with this product do not exceed those specified in the “Electrical Ratings” section. plug the item into an outlet of the receiver. 3. Remove the plastic battery tab from the battery compartment in the back of the remote control to activate the DC 12V Type A23 pre-installed battery. ELECTRICAL RATINGS CAUTION: Failure to properly align the battery polarity can cause personal injury and/or Voltage Frequency Wattage Amperage Horse Power 120VAC 60Hz *1000W-1625W 13A 1/3HP * Maximum combined wattage for items using a tungsten bulb plugged into the Receiver is 1000W. * Maximum combined wattage for appliances plugged into the Receiver is 1625W. RECEIVER MODEL: RC-040 TRANSMITTER MODEL: TR-025 FCC ID: PAGTR-025 IC: 4494A-TR025 Operating Instructions 1. To set up the receiver (outlet) with connecting device. 2. Removes the plastic battery tab from the battery compartment in the back of the remote control to active the DC 12V Type A23 pre-installed battery. 3. To activate the Receiver, press the ON Button of the Remote Control. The red LED of the Remote Control will illuminate momentarily and the LED of the Receiver will remain illuminated. 4. To turn the Receiver off, press the OFF Button of the Remote Control. The LED on the Receiver will shut off. Manual On/Off: Press Manual button on the body of Receiver to turn on or off. The manual button is available if the Remote Control is absence. Features: Controls one electrical outlet up to a distance of 100 feet. Battery Handling and Usage WARNING: Keep batteries away from children and pets. • Follow the battery manufacturer’s safety and usage instructions. • Insert the battery observing the proper polarity (+/-) as indicated inside the Battery Compartment. • Remote a spent or discharged battery from the product. remove the battery when not using the product for an extended period. • Never throw batteries into a fire. Do not expose batteries to fire or other heat sources. • Battery contains mercury. Do not put in trash. Recycle or manage as hazardous waste. • Dispose or recycle spent / discharged batteries in compliance with all applicable laws. For detailed information contact your local solid waste authority. property damage. Replacing the battery • Remove the Battery compartment cover from the back of the remote control by sliding the cover in the direction that its trends curve. • Remove the spent battery and place a new DC 12V Type A23 battery into the Battery Compartment correctly observing the polarity indications (+/-) inside the Battery Compartment. • Replace the Battery Compartment Cover. • Clear the battery contacts and also those of the device prior to battery installation Replacing the battery Federal Communications Commission Interference Statement This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and the receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. Industry Canada statement: This Class B digital apparatus complies with Canadian ICES-003. This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. Made in China SAVE THESE INSTRUCTIONS!
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.5 Linearized : No Author : Atico Company : Atico International Create Date : 2018:01:26 11:49:26+08:00 Modify Date : 2018:02:06 09:33:38+08:00 Source Modified : D:20070611010456 XMP Toolkit : Adobe XMP Core 5.4-c005 78.147326, 2012/08/23-13:03:03 Format : application/pdf Title : RC-040_TR-025B(1-3)(FCC+IC)_IM_Rev20180125 Creator : Atico Subject : Creator Tool : Adobe Illustrator CS6 (Macintosh) Metadata Date : 2018:02:06 09:33:38+08:00 Thumbnail Width : 172 Thumbnail Height : 256 Thumbnail Format : JPEG Thumbnail Image : (Binary data 21476 bytes, use -b option to extract) Document ID : xmp.did:BEFB7C8A17206811822AC791684C753F Instance ID : uuid:140da412-53f2-457c-909a-e0bdb6973143 Original Document ID : uuid:39FBA63D45F311DE8356E935A32B94EA Rendition Class : proof:pdf Derived From Instance ID : uuid:7555946a-8cca-a547-ae66-68d44f5078ad Derived From Document ID : xmp.did:FD7F117407206811822AE3FC153109B3 Derived From Original Document ID: uuid:39FBA63D45F311DE8356E935A32B94EA Derived From Rendition Class : proof:pdf History Action : saved, saved History Instance ID : xmp.iid:0390FFAE203B1168B0DFF2DA07C51B2D, xmp.iid:BEFB7C8A17206811822AC791684C753F History When : 2012:06:14 17:54:45+08:00, 2018:01:26 11:49:22+08:00 History Software Agent : Adobe Illustrator CS4, Adobe Illustrator CS6 (Macintosh) History Changed : /, / N Pages : 1 Has Visible Transparency : False Has Visible Overprint : False Max Page Size W : 23.017596 Max Page Size H : 32.277547 Max Page Size Unit : Centimeters Font Name : TrebuchetMS, ArialMT, Arial-Black, ArialNarrow, ArialNarrow-Bold Font Family : Trebuchet MS, Arial, Arial Black, Arial Narrow, Arial Narrow Font Face : Regular, Regular, Regular, Regular, Bold Font Type : Open Type, Open Type, Open Type, Open Type, Open Type Font Version : Version 5.00x, Version 5.06, Version 5.00.1x, Version 2.38.1x, Version 2.38.1x Font Composite : False, False, False, False, False Font File Name : Trebuchet MS.ttf, Arial.ttf, Arial Black.ttf, Arial Narrow.ttf, Arial Narrow Bold.ttf Plate Names : Cyan, Magenta, Yellow, Black Swatch Group Name : Default Swatch Group Swatch Group Type : 0 Swatch Colorant Swatch Name : New Color Swatch 6, New Color Swatch 2, AutoCAD Color Swatch Colorant Type : PROCESS, PROCESS, PROCESS Swatch Colorant Tint : 100.000000, 100.000000, 100.000000 Swatch Colorant Mode : CMYK, CMYK, CMYK Swatch Colorant Cyan : 92.971703, 92.971703, 92.971703 Swatch Colorant Magenta : 87.972801, 87.972801, 87.972801 Swatch Colorant Yellow : 89.019600, 89.019600, 89.019600 Swatch Colorant Black : 79.998497, 79.998497, 79.998497 Producer : Adobe PDF library 10.01 Headline : Page Count : 1EXIF Metadata provided by EXIF.tools