KAPSCH TRAFFICCOM CANADA 802001 G4P Transponder User Manual FPT Interior Transponder Mounting Instructions

KAPSCH TRAFFICCOM CANADA INC. G4P Transponder FPT Interior Transponder Mounting Instructions

User Manual

MARKIVIndustriesCorp ® SShheeeett 11 ooff 11 880022000011--000011..ddoocc NNoovv 1144,, 22000088 ©© MMAARRKK IIVV IINNDDUUSSTTRRIIEESS CCoorrpp EEXXCCEEPPTT AASS MMAAYY BBEE OOTTHHEERRWWIISSEE PPRROOVVIIDDEEDD BBYY CCOONNTTRRAACCTT,, TTHHEESSEE DDRRAAWWIINNGGSS AANNDD SSPPEECCIIFFIICCAATTIIOONNSS CCOONNTTAAIINN PPRROOPPRRIIEETTAARRYY IINNFFOORRMMAATTIIOONN AANNDD AARREE TTHHEE PPRROOPPEERRTTYY OOFF MMAARRKK IIVV IINNDDUUSSTTRRIIEESS CCOORRPP AANNDD AARREE IISSSSUUEEDD IINN SSTTRRIICCTT CCOONNFFIIDDEENNCCEE AANNDD SSHHAALLLL NNOOTT BBEE TTRRAANNSSMMIITTTTEEDD OORR RREEPPRROODDUUCCEEDD OORR CCOOPPIIEEDD OORR UUSSEEDD AASS TTHHEE BBAASSIISS FFOORR MMAANNUUFFAACCTTUURREE OORR SSAALLEE OOFF AAPPPPAARRAATTUUSS WWIITTHHOOUUTT PPRRIIOORR WWRRIITTTTEENN PPEERRMMIISSSSIIOONN.. Short Range Vehicle-to-Roadside Communications Equipment for Automatic Vehicle Identification G4P Transponder Mounting Instructions for car interior on windshield For proper operation, make sure the transponder is mounted as follows: 1. Identify the front face of the transponder. It displays your agency label and two upward-pointing arrows. (Fig.-1) This side faces the driver with the ar-rows pointing toward the roof of your vehicle. 2. Identify the position in your vehicle in which the transponder will be mounted. The preferred location is between the exposed edge of the windshield (roof-line) and the rear view mirror post—as long as the clearances in Fig.-2 can be maintained. If there is insufficient room, the alternate location shown in Fig.-3 must be used. 3. Having determined the mounting position in your vehicle, clean the inside surface of that section of the windshield if necessary. Now carefully remove the protective backing from the Dual LockTM mounting strips on the rear of the transponder as shown in Fig. 4 and firmly press the rear of the transponder against the glass. Maintain the pressure for about 15 seconds to achieve a good bond The transponder may be removed by lifting any one corner with sufficient pressure to separate the Dual LockTM strips. Do not remove the Dual LockTM from the windshield and reuse it; obtain new strips from your service center if necessary. This equipment must be installed to provide a separation distance of at least 20 cm from all nearby persons and must not be co-located or operating in conjunction with any other antenna or transmitter. Fig.-2 Preferred Mounting Location Fig.-1 Transponder Front Face Fig.-4 Transponder Rear Face Fig.-3 Alternate Mounting Location ARROWS POINT UP Rear view mirror Transponder

Navigation menu