KYE SYSTEMS GMZKB TOUCH MOUSE 6000 (GM-120017/T) User Manual
KYE Systems Corp TOUCH MOUSE 6000 (GM-120017/T) Users Manual
Users Manual
English
1
Touch Mouse 6000 User Manual
Hardware Installation
1. Install one AA or two AA batteries in the mouse as instructed.
2. Connect the receiver to a USB port of a PC.
3. Make sure that you have switched on the power switch underneath the mouse.
Power on the mouse Plug in the receiver
Using the Mouse
1. Click: The Touch Mouse provides full 2-button operation. Press the left or right area of the mouse surface. (For Windows 8/7)
Left-click
Press the left side of
the touch surface.
Right-click
Press the right side
of the touch surface
Vertical Wheel
Scroll (Up)
Vertical Wheel
Scroll (Down)
2. Press the top 1/2 of the touch strip to go to the Windows Start screen (Metro Start in Windows 8).
3. Battery low indication: If the LED is flashing, then the battery level is low, you need to replace battery immediately.
4. For Window 8 Gestures
Gestures Description Gestures Description
Edge Swipe (Left)
Swipe from the far
left edge of the
surface to the right.
Edge Swipe (Right)
Swipe from the far
right edge of the
surface to the left.
Vertical Wheel
Scroll (Up)
Vertical Wheel
Scroll (Down)
Horizontal Wheel
Scroll (Left)
Horizontal Wheel
Scroll (Right)
Adjust View
(Zoom in)
Adjust View
(Zoom out)
Edge Swipe (Top)
Note:
You are prompted to install Touch Mouse 6000 software that enhances your Touch Mouse experience with gestures. Download the software driver from our website: www.geniusnet.com
Warning: (Troubleshooting)
1. Do not use the wireless optical/IR mouse on a desk which is made of glass or mirror.
2. The connection of the wireless device is factory preset, so when you plug the USB receiver into any USB port, the connection between the micro receiver and the mouse will be established automatically.
3. In case your PC did not install the hardware successfully, remove the micro receiver from the USB port and go Human Interface Devices under Device Manager to remove the mouse then plug in the micro
receiver to a USB port again.
4. If you feel the mouse does not move smooth as usual, it is possible the battery has lost its charge so you need to replace it. Remember to put the battery in the correct direction.
English
2
FCC Compliance and Advisory Statement
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, according to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can