Kenwood USA 420700 700/800MHz P25 Tranceiver User Manual B59 2546 00 TK 3102G indd

Download:
Mirror Download [FCC.gov]
Document ID	1212756
Application ID	A6foKb3u0p493HAyalKWuQ==
Document Description	Manual safety info
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	42.01kB (525135 bits)
Date Submitted	2009-12-12 00:00:00
Date Available	2009-12-13 00:00:00
Creation Date	2017-11-12 02:26:18
Producing Software	GPL Ghostscript 9.18
Document Lastmod	2017-11-12 02:26:18
Document Title	B59-2546-00 (TK-3102G).indd
Document Creator	Adobe InDesign CS2_J (4.0.5)

Radio FRequency eneRgy SaFety inFoRmation
This Kenwood transceiver has been tested and complies with the standards listed below, in regards
to Radio Frequency (RF) energy and electromagnetic energy (EME) generated by the transceiver.
• FCC RF exposure limits for Occupational Use Only . RF Exposure limits adopted by the FCC are generally
•
•
•
based on recommendations from the National Council on Radiation Protection and Measurements, & the
American National Standards Institute.
FCC OET Bulletin 65 Edition 97-01 Supplement C
American National Standards Institute (C95.1 – 1992)
American National Standards Institute (C95.3 – 1992)
This Kenwood transceiver generates RF EME while transmitting. RF EME (Radio Frequency Electric &
Magnetic Energy) has the potential to cause slight thermal, or heating effects to any part of your body less
than the recommended distance from this radio transmitter’s antenna. RF energy exposure is determined
primarily by the distance to and the power of the transmitting device. In general, RF exposure is minimized
when the lowest possible power is used or transmission time is kept to the minimum required for consistent
communications, and the greatest distance possible from the antenna to the body is maintained. The
transceiver has been designed for and is classiied for Occupational Use Only . Occupational/ controlled
exposure limits are applicable to situations in which persons are exposed to RF energy as a consequence
of their employment, and such persons have been made aware of the potential for exposure and can
exercise control over their exposure. This means you can use the transceiver only if you are aware of
the potential hazards of operating a transceiver and are familiar in ways to minimize these hazards. This
transceiver is not intended for use by the general public in uncontrolled environments. Uncontrolled
environment exposure limits are applicable to situations in which the general public may be exposed to RF
energy, or in which the persons who are exposed as a consequence of their employment may not be fully
aware of the potential for exposure or cannot exercise control over their exposure.
The following list provides you with the information required to ensure that you are aware of RF
exposure and of how to operate this transceiver so that the FCC RF exposure limitations are not
exceeded.
•
•
•
While transmitting (holding the Ptt switch or speaking with VoX enabled), always keep the antenna
and the radio at least 2 cm (0.79 inches) from your body or face, as well as from any bystanders. A
LED on the top of the radio shows red when the transmitter is operating in both Ptt and VoX modes.
Do not transmit for more than 50% of the total transceiver use time; transmitting over 50% of the total use
time may exceed the limits in accordance to the FCC RF exposure requirements. Nominal transceiver
operation is 5% transmission time, 5% reception time, and 90% stand-by time.
Use only the speciied antenna for this transceiver; this may be either the antenna provided with the
transceiver or another antenna authorized by Kenwood.
Use only Kenwood authorized accessories (antennas, battery packs, belt clips, Speaker/ Mics or
headsets etc.): When worn on the body, always place the radio in a Kenwood recommended clip or
carrying case meant for this product. The use of other than recommended or approved body- worn
accessories may result in RF exposure levels which exceed the FCC’s occupational/ controlled
environment RF exposure limits.
To ensure that your exposure to RF EME is within the FCC limits for occupational use, you must
observe and adhere to the above points.
electromagnetic interference compatibility
Electronic devices are susceptible to electromagnetic interference (EMI) if they are not adequately
shielded or designed for electromagnetic compatibility. Because this transceiver generates RF
energy, it can cause interference to such equipment.
•
•
Turn OFF your transceiver where signs are posted to do so. Hospitals and health care facilities use
equipment that is sensitive to electromagnetic radiation.
Turn OFF your transceiver while on board an aircraft when so instructed. Use of the transceiver must
be in accordance with airline regulations and/or crew instructions.
B59-2546-00

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : No
Encryption                      : Standard V4.4 (128-bit)
User Access                     : Extract
XMP Toolkit                     : Adobe XMP Core 4.2.1-c043 52.372728, 2009/01/18-15:08:04
Instance ID                     : uuid:4b093c5f-a6c9-4a58-8b94-cd2a6871f14e
Document ID                     : adobe:docid:indd:1a322edf-64e1-11db-b677-91889fe1d42a
Rendition Class                 : proof:pdf
Manifest Link Form              : ReferenceStream, ReferenceStream
Manifest Placed X Resolution    : 72.00, 72.00
Manifest Placed Y Resolution    : 72.00, 72.00
Manifest Placed Resolution Unit : Inches, Inches
Manifest Reference Instance ID  : uuid:AA4A272864E011DB8F1EA7FB0A186C0E, uuid:AA4A272A64E011DB8F1EA7FB0A186C0E
Manifest Reference Document ID  : uuid:AA4A272764E011DB8F1EA7FB0A186C0E, uuid:AA4A272964E011DB8F1EA7FB0A186C0E
Create Date                     : 2008:04:11 10:14:56+09:00
Modify Date                     : 2009:11:17 11:06:29-07:00
Metadata Date                   : 2009:11:17 11:06:29-07:00
Creator Tool                    : Adobe InDesign CS2_J (4.0.5)
Thumbnail Format                : JPEG
Thumbnail Width                 : 256
Thumbnail Height                : 256
Thumbnail Image                 : (Binary data 10561 bytes, use -b option to extract)
Format                          : application/pdf
Title                           : B59-2546-00 (TK-3102G).indd
Producer                        : Adobe PDF Library 7.0
Trapped                         : False
GTS PDFX Version                : PDF/X-1:2001
GTS PDFX Conformance            : PDF/X-1a:2001
Page Count                      : 1
Creator                         : Adobe InDesign CS2_J (4.0.5)

EXIF Metadata provided by EXIF.tools