Ki Ryung Electronics KS-K6002 FM Modulator For Sirius Satellite Receiver User Manual Streamer Car Install Guide

Ki Ryung Electronics Co., Ltd. FM Modulator For Sirius Satellite Receiver Streamer Car Install Guide

User Manual

2003 JVCCar Docking Kit Installation Guide KS-K6001 or KS-K6002C
2KS-K6001 & KS-K6002 Installation GuideBox Contents3Safety Precautions WarningTake the following precautions to prevent trafficaccidents and avoid personal injury:• Installation must be performed according to thisinstallation manual. JVC PnP is not responsiblefor issues arising from installations not performedaccording to the procedures in this manual.• Do not install the unit where it may obstruct yourview through the windshield or of your vehicle’sindicator displays.• Do not install the unit where it may hinder thefunction of safety devices such as an airbag.Doing so may prevent the airbag from functioningproperly in the event of an accident.• The installation and use suggestions containedin this manual are subject to any restrictions orlimitations that may be imposed by applicablelaw—the purchaser should check applicable lawfor any restrictions or limitations before installingand/or operating this unit.• Failure to follow these safety instructions andwarnings may result in a serious accident. CautionTake the following precautions to keep the unit inproper working order:• Be sure the unit is connected to a 12V DC powersupply with a negative ground connection.• Do not install the unit where it will be exposed tohigh levels of humidity, moisture, or dust.• When replacing a fuse, use only a new one withthe proper rating. Using a fuse with the wrongrating may cause the unit to malfunction.• To prevent a short circuit when replacing a fuse,first unplug the cigarette lighter adapter from thecigarette lighter.• When drilling holes to mount the unit, make surenot to damage wiring or other systems on theother side.For the latest information about this and other JVC products, visit the JVC Web site at:www.jvc.com. If anything is missing or damaged, or if your KS-K6001 or KS-K6002 fails tooperate, notify your shipper immediately. JVC recommends that you keep the original packaging incase you need to ship your KS-K6001 or KS-K6002 in the future.KS-K6001 & KS-K6002 Installation Guide1 x Cassette Adaptor (only in KS-K6001) (only in KS-K6001)1 x Suction Cup MountAfter you unpack your KS-K6001 or KS-K6002, make sure everything here is included:1 x Car Dock 1 x Cigarette Power Adaptor 1 x Audio Cable1 x Antenna
Car Docking Kit Installation Guide for KS-K6001 or KS-K6002 Kit (sold seperately)Note: Do not put JVC in the docking station until you have completed the installation.KS-K6001 Contents:• Installation Guide.• Car docking cradle.Ciarette lighter power supply.• Suction Cup Mount.• Magnetic roof-mount SIRIUSantenna.• Cassette adapter• RCA cable1. Determine where you want tomount JVC PnP.• Do not install JVC PnP whereit may obstruct your view throughthe windshield or your view ofyour vehicle’s indicator displays.• Do not install JVC PnP whereit will hinder your access to thevehicle’s controls.• Do not install JVC PnP whereit may hinder the function ofsafety devices such as anairbag. Doing so may preventthe air-bag from functioningproperly in the event of anaccident.• Find a location that providesgood visibility of and access toJVC PnP’s front panel.• The JVC stronglyrecommends that you mountJVC PnP in a location where thebase can be attached with theprovided screws or on thewindshield with the providedsuction-cup mount.2. You can bend the leaves onthe base to conform to curvedmounting surfaces.3. Peel the covering away fromthe adhesive on the bottom ofthe base and adhere it to themounting surface. Use theprovided screws to securelyattach the base to the surface.• If using screws, be sure thatyou do not damage wiring orother systems on the other sideof the mounting surface.4. Using the provided screws,assemble the docking stationInstallation in a Vehicle (continued)cradle to the base or to thesuction cup mount.5. Plug the cigarette lighteradapter into the back of the cradle.Don’t plug the adapter into thecigarette lighter until theinstallation is completed.6A. Plug the cassette adapter intothe back of the cradle (KS-K6002kit only). For the KS-K6001 kit,tune your radio to one of four FMstations on the side of the vehicledock6B. If your car stereo has an auxinput, plug the supplied audiocable into the back of the cradleinstead of the cassette adapter.Plug the audio cable’s white (Lch,) and red (R ch.) connectorsinto your car stereo.45KS-K6002 Contents:• Installation Guide.• Car docking cradle w/ FM.• Suction Cup Mount.• Magnetic roof-mount SIRIUS antenna.• Cigarette lighter power supply.Note: The SIR-STRVK1 Kit doesn’t come with the shown cassette adapter because it has a wireless FM Transmitter.KS-K6001 & KS-K6002 Installation Guide KS-K6001 & KS-K6002 Installation Guide
Installation in a Vehicle: Running the Antenna Cable2. Route the cable from the antenna to thevehicle’s interior by tucking it underneath therubber molding around rear window, as shownbelow.• For SUVs, minivans & 5-door vehicles, bring thecable into the vehicle under the rubber molding forthe tailgate, and continue under the interior trim.4. From the trunk, route the cable around thepassenger compartment and to the back of thecradle.• Do not pull the wire across sharp edges that coulddamage it.• Keep the wire away from areas where it couldbecome tangled in driver’s and passenger’s feet.5. Plug the antenna into the back of cradle where itsays “ANT”.6. Plug the cigarette lighter adapter into the cigarettelighter. JVC RECOMMENDSUNPLUGGING THE CIGARETTE LIGHTERADAPTER AFTER YOU TURN THE VEHICLE’SIGNITION OFF.6 7Installation in a Vehicle: Mounting the Antenna1. Turn JVC PnP’s power off and remove it fromthe cradle; unplug the cigarette lighter adapterfrom the cigarette lighter; unplug the antenna fromthe cradle.3. Route the cable from the lowest point of therear window into the trunk. Take advantage of anyexisting cable channels or wiring conduits.KS-K6001 &Ks-K6002 Installation Guide KS-K6001 &KS-K6002 Installation Guide1. Temporarily plug the antenna into the“1-Sat/Terr (Main)” connector on theback of the cradle until it is firmlyseated.2. Find an antenna location on a metalsurface of your vehicle at least 12" x12", and at least 6" from a window. Ifyou use the included antenna mount, install the mounton the upper portion of your side-viewmirror bracket.• Best reception is achieved with the antenna mounted on theroof or trunk for convertibles.• If the vehicle has a roof rack or skid ribs, it may be necessaryto mount the antenna off-center.3. The antenna’s powerful magnet will secure it to the metalsurface. Before routing the antenna cable, confirm that theantenna is mounted in a good location:4. Temporarily plug the cigarette lighter adapter into thecigarette lighter.5. Slide JVC PnP all the way into the cradle so that theconnector at the bottom of the unit makes proper contact in thecradle. Press and hold the POWER button to turn JVC PnP on.6. If your JVC PnP has been properly connected and theantenna is receiving the SIRIUS signal you will hear audio. Ifyou do not hear audio, the display will read “Antenna Error”.Reorient the antenna until you hear audio. (See AntennaSignal, on page 27 to use the ANTENNA SIGNAL screen to aimthe antenna.)• Make sure the vehicle is not in garage, or somewhere thesatellite signal could be blocked.
8KS-K6001 &Ks-K6002 Installation Guide KS-K6001 &KS-K6002 Installation Guide 96. Sirius Program Listening OptionsThe Shuttle and Cradle provide an audio outputsignal in three manners:1. When using K6001 or K6002 cradle, the audio signalcan be routed through an audio cable which isapplied to the auxiliary inputs of a radio orentertainment system.2. When using the K6002 cradle, the audio signal canbe transmitted to a car radio on one of fourselectable FM frequencies. The audio signal canthen be played through your car radio when thecar radio is tuned to one of these frequencies.3. Some listeners prefer to use a hard-wired FMtransmitter. In this instance, when using the K6002cradle, an optional FM Switching Box assembly(Part No. 112C3159) is available and provides ahard-wired FM output when connected to the FM OUTconnector on the left side of the cradle; the other endof the switching box plugs into the antenna jack of yourradio. By using this assembly, and selecting theappropriate FM output frequency (88.1MHz, 88.3MHz,88.5MHz or 88.7MHz) with the slide switch, the Siriussignal received at the SAT (MAIN) or TERR. cradleantenna input can be played through your car radiowhen tuned to one of these frequencies.FM FREQUENCYSELECT SLIDESWITCH:88.1 MHz88.3 MHz88.5 MHz88.7 MHz3FCC WarningWarningThis equipment may generate or use radiofrequency energy. Changes or modifications to thisequipment may cause harmful interference unlessthe modifications are expressly approved in thisUser Guide. The user could lose the authority tooperate this equipment if an unauthorizedchange or modification is made.
Interconnect Diagram FM OptionTO AUXILIARY AUDIOINPUT OF RADIO ORENTERTAINMENT SYSTEMFM FREQUENCY SELECTION SWITCH.SELECT 1 OF 4 AVAILABLE FREQUENCIESAND SET YOUR EXISTING CAR RADIO TOTHE SAME FREQUENCY.TO VEHICLE+12 VDC POWERRECEPTACLEVEHICLERADIOANTENNADC POWERADAPTERVEHICLEFM RADIONOTE:1. THE FM TRANSMITTER OPTION MUSTBE SET TO ”FM ON” IN THE SHUTTLEUSER MENU. (REFER TO THE OWNER’SMANUAL, PUBLICATION NO.128-6812.)2. WHEN THE FM TRANSMITTER IS TOBE USED, DO NOT CONNECT THEAUDIO CABLE TO THE AUDIO OUTCONNECTOR OF THE SHUTTLE.SHUTTLE CRADLEKS-K6002 ONLY**TERRESTRIAL ANTENNA CONNECTION FOR USE WITH OPTIONAL 2 CONNECTOR ANTENNA CONFIGURATIONSHUTTLEANTENNAOR**10

Navigation menu