Kidde Fire Systems Marine Instruments Fm 200 Users Manual K 90 5180

2015-02-09

: Kidde-Fire-Systems Kidde-Fire-Systems-Kidde-Fire-Systems-Marine-Instruments-Fm-200-Users-Manual-568171 kidde-fire-systems-kidde-fire-systems-marine-instruments-fm-200-users-manual-568171 kidde-fire-systems pdf

Open the PDF directly: View PDF PDF.
Page Count: 1

A UTC Fire & Security Company
This literature is provided for informational purposes only. KIDDE-FENWAL, INC. assumes
no responsibility for the product’s suitability for a particular application. The product must be
properly applied to work correctly.
If you need more information on this product, or if you have a particular problem or question,
contact KIDDE-FENWAL, INC., Ashland, MA 01721. Telephone: (508) 881-2000.
Kidde Fire Systems
A UTC Fire & Security Company
400 Main Street
Ashland, MA 01721
Ph: 508.881.2000
Fax: 508.881.8920
www.kiddefiresystems.com
K-90-5180 Rev AC © 2010 Kidde-Fenwal Inc. Printed in USA
Effective: September 2010
K-90-5180
FM-200® Component Description
Pressure Operated Switch
FEATURES
•For Use with UL Listed, ULC Listed and
FM Approved Systems
• See Kidde® Manual 90-FM200M-021 for
USCG Approval
P/N: 81-486536-000
OPERATED
SET
4.00"
WIRING
SCREW
TERMINALS
4.00"
SET
OPERATED
PRESSURE OPERATED SWITCH
3P.D.T.
UL
TO RESET
PUSH STEM TO SET POSITION
15 AMP 125 VAC
10 AMP 250 VAC
3/4 HP 1-2-3 PH 125-480 VAC
8 COVER SCREWS
STEM SHOWN IN SET POSITION-
PULL UP ON STEM TO MANUALLY
OPERATE SWITCH
0.375"
1/2” SUPPLY PIPE WITH UNION
FRONT VIEW
FRONT VIEW
COVER REMOVED
SWITCH 3PDT
COVER
GASKET
BOX 3 EACH SIDE
1/2” CONDUIT
KNOCKOUTS
½” NPT FEMALE,
CONNECT TO SYSTEM
PIPING
SIDE SECTION
TO RESET
PUSH STEM TO SET POSITION
FM
15 AMP.— 125 V.AC 10 AMP.—250 V.AC
3/4HP—250 VAC
PT. NO. 486536
KIDDE-FENWAL, INC.
400 MAIN STREET
ASHLAND, MA 01721
WIRING DIAGRAM
SET
OPERATED
PRESSURE INLET
C
NC
NO
C
NC
NO
C
NC
NO
FM-200 is a registered trademark of the Great Lakes Chemical Corporation.
NOTES:
• The switch may be mounted in any position; how-
ever, the preferred installation is upright, as shown.
• Any load connection to the switch must not exceed
the switch rating, and shall utilize a suitable protec-
tion device (i.e., circuit breaker, fuse).
• Contact Ratings (3 PDT):
– 15 Amp @125 Vac
– 10 Amp @ 250 Vac
– 3/4 HP @ 250 Vac
– 1, 2 or 3 Phase

Navigation menu