LANKE XUNTONG TECHNOLOGY PTR9018 Bluetooth low energy 4.0 modules User Manual

LANKE XUNTONG TECHNOLOGY CO.,LTD Bluetooth low energy 4.0 modules Users Manual

Contents

User Manual

Download: LANKE XUNTONG TECHNOLOGY PTR9018 Bluetooth low energy 4.0 modules User Manual
Mirror Download [FCC.gov]LANKE XUNTONG TECHNOLOGY PTR9018 Bluetooth low energy 4.0 modules User Manual
Document ID3216301
Application IDh2U0XFysjkWBC+2f52foOw==
Document DescriptionUser Manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize24.49kB (306122 bits)
Date Submitted2016-12-02 00:00:00
Date Available2016-12-05 00:00:00
Creation Date2016-11-29 17:14:12
Producing SoftwareAdobe PDF Library 11.0
Document Lastmod2016-11-29 17:14:13
Document TitleUsers Manual
Document CreatorAcrobat PDFMaker 11 Word 版
Document Author: MCU

PTR9018
Bluetooth Low Energy System on Module
Embedded Cortex™ M0 32 bit processor
The PTR9018 ultra-low power Bluetooth Low Energy/2.4GHz Proprietary Multi-protocol
modules based on the nRF51822 from Nordic Semiconductor. The module with an ARM®
Cortex™ M0 32 bit processor, embedded 2.4GHz transceiver, and integrated antenna,
provide a complete solution with no additional RF design, allowing faster time to market,
while simplifying designs, reducing BOM costs, also reduce the burden of Regulatory
approvals to enter the world market. Making you more quickly into the bluetooth smart
application and remove the worries.
Features

System on Module(SOM) base on Nordic nRF51822

Bluetooth Low Energy/2.4GHz Proprietary Multi-protocol support

Complete Bluetooth Low Energy stack/profiles solution (Bluetooth 4.x and Higher)

ARM® Cortex™-M0 32 bit processor, 256 kB flash memory, 16 kB RAM

2.4 GHz transceiver, Max TX Power +4 dBm, -93 dBm sensitivity@BLE

31 General Purpose I/O, Configurable mapping Pins, Simple layout of external application

Internal RC Oscillator 32.768 kHz(± 250 ppm).

Flexible real-time counter and Two 16 bit and one 24 bit timers with counter mode

AES Coprocessor, Random Number Generator ,Watchdog Timer ,Temperature sensor

Rich set of Peripheral: ADC, SPI, 2-wire , and UART. Programmable Peripheral Interconnect(PPI)

Internal RC Oscillator 32.768 kHz(± 250 ppm).

Small size about 22.7mmx17.5mm x1.6mm with Antenna.
COPYRIGHT ©2016 ALL RIGHTS RESERVED
XunTong Tech TEL: +86 755 26675941
E-mail: nrf@freqchina.com
Typical Applications:
















- 2.4 GHz Bluetooth low energy systems
- Proprietary 2.4 GHz systems
- Sports and leisure equipment
- Mobile phone accessories
- Health Care and Medical
- Consumer Electronics, Game pads
- Human Interface Devices, Remote control
- Building environment control / monitoring
- RFID, Security Applications
- Bluetooth Low Energy GateWay
- iBeacons™, Eddystone™, Indoor navigation
- Low-Power Sensors
- Connected Appliances
- Lighting Products
- Fitness devices
- Wearables
Quick Specifications:
Bluetooth
Version
Bluetooth 4.x and Higher
Security
AES-128
Radio
Frequency
2.402GHz to 2.480 GHz
Modulations
GFSK at 250Kbps,1 Mbps, 2 Mbps data rates
Transmit power
-4dBm~4dBm
Receiver sensitivity
-93 dBm (BLE mode)
Antenna
On board
Current Consumption
TX @ -4dBm~4 dBm
~16 mA
RX only @ 1 Mbps
~13 mA
MCU running @16MHz code from Flash
~4.4 mA
MCU running @16MHz code from RAM
~2.4 mA
SYSTEM ON
~2.3 uA
SYSTEM OFF
~420 nA
Operating conditions
Power supply
1.9~3.6V
Operating temperature
-25~+85 °C
COPYRIGHT ©2016 ALL RIGHTS RESERVED
XunTong Tech TEL: +86 755 26675941
E-mail: nrf@freqchina.com
Pin Description(Top View):
Pin
Name
Description
Note
Pin1
P0.20
Digital I/O
Pin2
P0.19
Digital I/O
Pin3
P0.18
Digital I/O
Pin4
P0.17
Digital I/O
Pin5
SWCLK
HW debug and flash programming I/O
Pin6
SWDIO
HW debug and flash programming I/O
Pin7
P0.16
Digital I/O
Pin8
P0.15
Digital I/O
Pin9
P0.14
Digital I/O
Pin10
P0.13
Digital I/O
Pin11
P0.12
Digital I/O
Pin12
P0.11
Digital I/O
Pin13
P0.10
Digital I/O
Pin14
P0.09
Digital I/O
Pin15
P0.08
Digital I/O
Pin16
P0.07
Digital I/O
Pin17
P0.06
Digital I/O
Pin18
P0.05
Digital I/O
Pin19
P0.04
Digital I/O
Pin20
P0.03
Digital I/O
Pin21
P0.02
Digital I/O
Pin22
P0.01
Digital I/O
Pin23
P0.00
Digital I/O
Pin24
P0.30
Digital I/O
Pin25
P0.29
Digital I/O
Pin26
P0.28
Digital I/O
Pin27
P0.27
Digital I/O
COPYRIGHT ©2016 ALL RIGHTS RESERVED
XunTong Tech TEL: +86 755 26675941
E-mail: nrf@freqchina.com
Pin28
P0.26
Digital I/O
Pin29
P0.25
Digital I/O
Pin30
P0.24
Digital I/O
Pin31
P0.23
Digital I/O
Pin32
P0.22
Digital I/O
Pin33
P0.21
Digital I/O
Pin34
VCC
Power Supply
Pin35
NC
Pin36
GND
Ground
Block diagram:
General Purpose I/O:
The general purpose I/O is organized as one port enabling access and control of the 32 available
GPIO pins through one port. Each GPIO can be accessed individually with the following user
configurable features:
 Input/output direction
 Output drive strength
 Internal pull-up and pull-down resistors
 Wake-up from high or low level triggers on all pins
 Trigger interrupt on all pins
 All pins can be used by the PPI task/event system; the maximum number of pins that can be
interfaced through the PPI at the same time is limited by the number of GPIOTE channels
 All pins can be individually configured to carry serial interface or quadrature demodulator
signals
COPYRIGHT ©2016 ALL RIGHTS RESERVED
XunTong Tech TEL: +86 755 26675941
E-mail: nrf@freqchina.com
HW debug and flash programming of Module:
The Module support the two pin Serial Wire Debug (SWD) interface and offers flexible and powerful
mechanism for non-intrusive debugging of program code. Breakpoints, single stepping, and
instruction trace capture of code execution flow are part of this support.
Pin
Flash Program interface
SWDIO
Debug and flash programming I/O
SWCLK
Debug and flash programming I/O
This is the hardware debug and flash programming of module, J-Link Lite support, please refer
www.segger.com.
PCB Layout(TOP VIEW):
COPYRIGHT ©2016 ALL RIGHTS RESERVED
XunTong Tech TEL: +86 755 26675941
E-mail: nrf@freqchina.com
Recommended RF Layout & Ground Plane:
The module integrated antenna requires a suitable ground plane to radiate effectively. The area
under and extending out from the antenna portion of the module should be kept clear of copper and
other metal. The module should be placed at the edge of the PCB with the antenna edge facing out.
Reducing the ground plane will reduce the effective radiated power.
Ordering Information:
Part Number
Description
PTR9018
Bluetooth Low Energy System on Module
PTR9018-EVB
Evaluation boards for module,with key, LED, I/O extend,sock
for coin cell battery.
Absolute Maximum Ratings:
Symbol
VCC_MAX
VIO_MAX
VIO_MAX
TS
Parameter
Voltage on supply pin
Voltage on GPIO pins (VCC > 3.6V)
Voltage on GPIO pins (VCC ≤ 3.6V)
Storage Temperature Range
Min.
Max.
Unit
-0.3
-0.3
-0.3
-40
3.9
3.9
VCC + 0.3V
125
°C
Important Notice:



Reserves the right to make corrections, modifications, and/or improvements to the product and/or
its specifications at any time without notice.
Assumes no liability for the user’s product and/or applications.
Products are not authorized for use in safety-critical applications, including but not limited to
life-support applications.
ATTENTION!
Electrostatic Sensitive Device
Observe Precaution for handling.
COPYRIGHT ©2016 ALL RIGHTS RESERVED
XunTong Tech TEL: +86 755 26675941
E-mail: nrf@freqchina.com

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.5
Linearized                      : Yes
Author                          : MCU
Create Date                     : 2016:11:29 17:14:12+08:00
Modify Date                     : 2016:11:29 17:14:13+08:00
Tagged PDF                      : Yes
XMP Toolkit                     : Adobe XMP Core 5.4-c005 78.147326, 2012/08/23-13:03:03
Metadata Date                   : 2016:11:29 17:14:13+08:00
Creator Tool                    : Acrobat PDFMaker 11 Word 版
Document ID                     : uuid:c0760cf0-d0d8-437f-a7f0-13791f8b6973
Instance ID                     : uuid:51bbf004-4fa7-4253-b7f5-3a64d3882559
Subject                         : 4
Format                          : application/pdf
Title                           : 内置协议及链路层、具有六路接收通道
Creator                         : MCU
Producer                        : Adobe PDF Library 11.0
Source Modified                 : D:20161129091410
Company                         : Microsoft China
Page Layout                     : OneColumn
Page Count                      : 6
EXIF Metadata provided by EXIF.tools
FCC ID Filing: 2AA72-PTR9018

Navigation menu