LG Electronics USA L02A PCS GSM/ WCDMA USB Modem User Manual Manual L 02A

LG Electronics USA PCS GSM/ WCDMA USB Modem Manual L 02A

Contents

Users Manual

Part 15.21 statement " Change or Modifications that are not expressly approved by the manufacturer could void     the user's authority to operate the equipment. "   Part 15.105 statement This equipment has been tested and found to comply with the limits for a class B digital device,pursuant to Part 15 of the FCC Rules.These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and usedin accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. if this equipment does cause harmful interference or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:- Reorient or relocate the receiving antenna.- Increase the separation between the equipment and receiver.- Connect the equipment into an outlet on a circuit different from that to   which the receiver is connected- Consult the dealer or an experienced radio/TV technician for help.
10For Your SafetyFCC RF Exposure InformationWARNING! Read this information before operating the USB modem.In August 1996, the Federal Communications (FCC) of he UnitedStates, with its action in Report and Order FCC 96-326, adoptedan updated safety standard for human exposure to radiofrequency (RF) electromagnetic energy emitted by FCCregulated transmitters. Those guidelines are consistent withthe safety standard previously set by both U.S. andinternational standards bodies.The design of this phone complies with the FCC guidelines andthese international standards.CAUTIONUse only the supplied and approved antenna. Use ofunauthorized antennas or modifications could impair callquality, damage the phone, void your warranty and/or result inviolation of FCC regulations. Do not use the phone with adamaged antenna. If a damaged antenna comes into contactwith skin, a minor burn may result. Contact your local dealerfor a replacement antenna.Body-worn OperationThis device was tested for typical body-worn operations withthe USB modem kept 0.19 inches (0.5cm) between theuser’s body. To comply with FCC RFexposure requirements, a minimum separation distance of 0.19inches(0.5cm) must be maintained between the user's bodyand the USB modem.FCC Part 15 Class B ComplianceThis device and its accessories comply with part 15 of FCCrules. Operation is subject to the following two conditions: (1) This device and its accessories may not cause harmfulinterference, and (2) this device and its accessories mustaccept any interference received,      including interference thatmay cause undesired operation.
  4Your mobile phone is a radio transceiver, designed and manufactured not to exceed the SAR* limits** for exposure to radio-frequency (RF) energy, which SAR* value, when tested for compliance against the standard was ●●W/kg. While there may be differences between the SAR* levels of various phones and at various positions, they all meet*** the EU requirements for RF exposure.  * The exposure standard for mobile phones employs a unit of measurement known as the Specific Absorption Rate, or SAR.  **  The SAR limit for mobile phones used by the public is 2.0 watts/kilogram (W/kg) averaged over ten grams of tissue, recommended by The Council of the European Union. The limit incorporates a substantial margin of safety to give additional protection for the public and to account for any variations in measurements.  ***  Tests for SAR have been conducted using standard operating positions with the phone transmitting at its highest certified power level in all tested frequency bands. Although the SAR is determined at the highest certified power level, the actual SAR level of the phone while operating can be well below the maximum value. This is because the phone is designed to operate at multiple power levels so as to use only the power required to reach the network. In general, the closer you are to a base station antenna, the lower the power output.  Technical Data  Ambient Temperatures Max: +55°C Min: -10°C  Contents -How to Read/Refer to This Manual -Features of the L-02A -Safety Precautions (ALWAYS FOLLOW THESE PRECAUTIONS) -Handling and Care -Purchased Product and Accessories  -Before Using the FOMA Terminal   Names of Parts and Functions
  5  FOMA Card   Available Communications   Inserting the FOMA Terminal into a PC  -Setting Up   Setting Up   Installing Communication Configuration Files (Drivers) into Windows   Installing Communication Configuration Files (Drivers) into Macintosh   Uninstalling Communication Configuration Files (Drivers)  -Using L-02A Connection Manager   About L-02A Connection Manager   Installing L-02A Connection Manager (Drivers)   Using Packet Communication   Using SMS   Using Phonebook   Using Application Option   Uninstalling L-02A Connection Manager  -DOCOMO Connection Manager     DOCOMO Communication Settings flow using DOCOMO Connection Manager   Start up DOCOMO Connection Manager   Uninstalling DOCOMO Connection Manager   Communication Settings without using DOCOMO Connection Manager  -Overseas Use   International Roaming Service (WORLD WING)   Services Available Overseas   Sending the Message in Japan to Overseas   Before Using Overseas   Setting the Searching Method for Available Networks  -Appendix   AT Commands   AT Command List   Troubleshooting
  6  Error Messages   Warranty and After-Sales Service   Export Controls of the Product and Accessories   Main Specifications   Intellectual Property Rights   Index

Navigation menu